A Fully-Implantable Cochlear Implant SoC With Piezoelectric Middle-Ear Sensor and Arbitrary Waveform Neural Stimulation

Abstract

A system-on-chip for an invisible, fully-implantable cochlear implant is presented. Implantable acoustic sensing is achieved by interfacing the SoC to a piezoelectric sensor that detects the sound-induced motion of the middle ear. Measurements from human cadaveric ears demonstrate that the sensor can detect sounds between 40 and 90 dB SPL over the speech bandwidth. A highly-reconfigurable digital sound processor enables system power scalability by reconfiguring the number of channels, and provides programmable features to enable a patient-specific fit. A mixed-signal arbitrary waveform neural stimulator enables energy-optimal stimulation pulses to be delivered to the auditory nerve. The energy-optimal waveform is validated with in-vivo measurements from four human subjects which show a 15% to 35% energy saving over the conventional rectangular waveform. Prototyped in a 0.18 μm high-voltage CMOS technology, the SoC in 8-channel mode consumes 572 μW of power including stimulation. The SoC integrates implantable acoustic sensing, sound processing, and neural stimulation on one chip to minimize the implant size, and proof-of-concept is demonstrated with measurements from a human cadaver ear.

Silicon-Integrated High-Density Electrocortical Interfaces

“…In order to integrate such high channel counts, programmability of waveform parameters, individual connectivity to each channel, and/or charge balancing need to be compromised to some extent. For example, groups of 4-8 electrodes in [91], [93]- [95] can share a single digital-to-analog converter for optimized, high density integration.…”

Bulk PZT Cantilever Based MEMS Acoustic Transducer for Cochlear Implant Applications

“…1.51 Vrms output was obtained under 120 dB-A acoustic input at the inlet of the canal around 1780 Hz resonance frequency with a 150 Hz bandwidth. Generated voltage is sufficient for the state of the art signal processing circuits of the CIs (6 mV at 90 dB SPL [5]). Maximum rectified DC output power was 16.25 μW with an open circuit voltage of 2.47 VDC.…”

Thin Film PZT Acoustic Sensor for Fully Implantable Cochlear Implants

“…In order to analyze the transducer's performance, device is assembled to a PCB and attached on a shaker table. Figure 6 shows the frequency response of the device under various acceleration levels corresponding to the vibration of the umbo at specific sound levels [5]. The output of the piezoelectric acoustic sensor is going to be processed by an interface circuit and converted into current pulses which are sent to corresponding electrodes to stimulate the auditory neurons.…”