No abstract

The renewable biomass material obtained from rice husk, a low-cost agricultural waste, was used as a precursor to synthesize a highly porous graphene-based carbon as electrode material for supercapacitors. Activated graphene-based carbon (AGC) was obtained by a two-step chemical procedure and exhibited a very high specific surface area (SSA) of 3292 m2 g−1. The surface morphology of the synthesized materials was studied using scanning and transmission electron microscopy (SEM, TEM). Furthermore, the AGC was modified with nickel hydroxide Ni(OH)2 through a simple chemical precipitation method. It was found that the most significant increase in capacitance could be reached with Ni(OH)2 loadings of around 9 wt.%. The measured specific capacitance of the pure AGC supercapacitor electrodes was 236 F g−1, whereas electrodes from the material modified with 9 wt.% Ni(OH)2 showed a specific capacitance of up to 300 F g−1 at a current density of 50 mA g−1. The increase in specific capacitance achieved due to chemical modification was, therefore 27%.

No abstract

Activated carbons (ACs) have been prepared from chemical treatment of walnut shells (WS) precursor at various temperatures (400‒800 °C) by using phosphoric acid (H3PO4) as activating agent. Influence of activation temperature on the porosity development and capacitive properties of resulting carbons was investigated. Thermal post-treatment of carbons previously activated at moderate temperature, e.g. 400 °C allowed further structural and porosity modification. Then, these carbons were investigated by scanning electron microscopy, Raman spectroscopy, energy-dispersive X-ray spectroscopy, electrochemical techniques and low temperature nitrogen adsorption exhibiting high BET specific surface area of approximately 2100 m2 g-1 and a total pore volume up to 1.3 cm3 g-1. Carbon material obtained through activation by H3PO4 at 400 °C and post-treated at 800 °C was used to make electrodes which were implemented to realize AC/AC capacitor using 1 mol L-1 Li2SO4. The electrochemical capacitor demonstrated high capacitance of 123 F g-1 per mass of one electrode, reduced cell resistance and stable capacitance for 5000 galvanostatic charge/discharge cycles at 1.0 A g-1.

No abstract

No abstract

No abstract

The results of the study of the formation of graphene layers in the flame in premixed flame propane or butane-oxygen mixture on a nickel substrate at atmospheric pressure and low pressure are given. The influence of the ratio C/O and supply quantity of argon on the formation of graphene layers were researched. It is shown that in the flame of propane and butane on a nickel substrate is observed under these conditions the formation of predominantly 3-10 layers of graphene.