BackgroundSynthetic antioxidants and antimicrobials are losing ground to their natural counterparts and therefore, the food industry has motivated to seek other natural alternatives. Apple pomace, a by-product in the processing of apples, is rich in polyphenols, and plant polyphenols have been used as food additives owing to their strong antioxidant and antimicrobial properties. The goal of this study was to screen the individual polyphenols with antioxidant and antimicrobial activities from the extracts (methanol, ethanol, acetone, ethyl acetate, and chloroform) of Golden Delicious pomace.ResultsFirst, the polyphenolic compounds (total phenol content, TPC; total flavonoids, TFD; total flavanols, TFL) and antioxidant activities (AAs) with four assays (ferric reducing antioxidant power, FRAP; 1,1-diphenyl-2-picryhydrazyl radical scavenging capacity assay, DRSC; hydroxyl radical averting capacity assay, HORAC; oxygen radical absorbance capacity assay, ORAC) were analyzed. The results showed a significant positive correlation (P < 0.05) between AAs and TFD. Ethyl acetate extract (EAE) exhibited the highest TFD with a concentration of 1.85 mg RE/g powder (expressed as rutin equivalents), and the highest AAs (expressed as butylated hydroxytoluene (BHT) equivalents) with 2.07 mg BHT/g powder for FRAP, 3.05 mg BHT/g powder for DRSC, 5.42 mg BHT/g powder for HORAC, and 8.89 mg BHT/g powder for ORAC. Composition and AA assays of individual polyphenols from the EAE were then performed. Phloridzin and phloretin accounted for 46.70 and 41.94 % of TFD, respectively. Phloretin displayed the highest AA, followed by phloridzin. Finally, the antimicrobial activities of the EAE, phloridzin, and phloretin were evaluated. EAE displayed good inhibitory activities against Staphylococcus aureus with a minimum inhibition concentration (MIC) of 1.25 mg/ml and against Escherichia coli with a MIC of 2.50 mg/ml. Phloridzin and phloretin showed better inhibitory activities than the EAE, which were MICs of 0.50 and 0.10 mg/ml, respectively, against S. aureus and MICs of 1.50 and 0.75 mg/ml, respectively, against E. coli.ConclusionsEthyl acetate was the best solvent of choice to extract natural products to obtain the maximum antioxidant and antibacterial benefits. Phloridzin and phloretin have the potential to be used as natural alternatives to synthetic antioxidants and antimicrobials.

The free-piston gasoline engine linear generator (FPGLG) is a new kind of power plant consisting of free-piston gasoline engines and a linear generator. Due to the elimination of the crankshaft mechanism, the piston motion process and the combustion heat release process affect each other significantly. In this paper, the combustion characteristics during the stable generating process of a FPGLG were presented using a numerical iteration method, which coupled a zero-dimensional piston dynamic model and a three-dimensional scavenging model with the combustion process simulation. The results indicated that, compared to the conventional engine (CE), the heat release process of the FPGLG lasted longer with a lower peak heat release rate. The indicated thermal efficiency of the engine was lower because less heat was released around the piston top dead centre (TDC). Very minimal difference was observed on the ignition delay duration between the FPGLG and the CE, while the post-combustion period of the FPGLG was significantly longer than that of the CE. Meanwhile, the FPGLG was found to operate more moderately due to lower peak in-cylinder gas pressure and a lower pressure rising rate. The potential advantage of the FPGLG in lower NO x emission was also proven with the simulation results presented in this paper.

Abstract:We present a novel design of a single-cylinder free piston engine linear generator (FPELG) incorporating a linear motor as a rebound device. A systematic simulation model of this FPELG system was built containing a kinematic and dynamic model of the piston and mover, a magneto-electric model of the linear generator, a thermodynamic model of the single-cylinder engine, and a friction model between the piston ring and cylinder liner. Simulations were performed to understand the relationships between pre-set motor parameters and the running performance of the FPELG. From the simulation results, it was found that a motor rebound force with a parabolic profile had clear advantages over a force with a triangular profile, such as a higher running frequency and peak cylinder pressure, faster piston motion, etc. The rebound position and the amplitude of rebound force were also determined by simulations. The energy conversion characteristics of the generator were obtained from our FPELG test rig. The parameters of intake pressure, motor frequency, and load resistance were varied over certain ranges, and relationships among these three parameters were obtained. The electricity-generating characteristic parameters include output power and system efficiency, which can measure OPEN ACCESSEnergies 2015, 8 766 the quality of matching the controllable parameters. The output power can reach 25.9 W and the system efficiency can reach 13.7%. The results in terms of matching parameters and electricity-generating characteristics should be useful to future research in adapting these engines to various operating modes.

No abstract

Anthocyanin accumulation is crucial for the development of quality for most fruit. The mechanism underlying the regulation of anthocyanin biosynthesis by transcription factors in litchi fruit remains largely unknown. In this study, we isolated one NAC (NAM, ATAF1/2 and CUC2) TF gene, LcNAC13. Expression of LcNAC13 was upregulated as ripening proceeded, followed by the accumulation of anthocyanins. Electrophoretic mobility shift assay (EMSA) and transient expression assay showed that LcNAC13 could negatively regulate the expression of anthocyanin biosynthesis-related genes, including LcCHS1/2, LcCHI, LcF3H, LcF3’H, LcDFR, and LcMYB1. Furthermore, LcR1MYB1, as one R1-MYB type MYB, was identified to physically interact with LcNAC13 and reverse the effect of LcNAC13. Taken together, these results suggested that LcNAC13 and LcR1MYB1 may act together to antagonistically regulate anthocyanin biosynthesis during litchi fruit ripening, which helps to provide new insights into the regulatory networks of anthocyanin biosynthesis.

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International licence Newcastle University ePrints-eprint.ncl.ac.uk Guo C, Song Y, Feng H, Zuo Z, Jia B, Zhang Z, Roskilly A. Effect of fuel injection characteristics on the performance of a free-piston diesel engine linear generator: CFD simulation and experimental results.

Piezoelectric ceramics have been extensively used in actuators, where the magnitude of electrostrain is key indicator for large-stroke actuation applications. Here, we propose an innovative strategy based on defect chemistry to form a defect-engineered morphotropic phase boundary and achieve a giant strain of 1.12% in lead-free Bi 0.5 Na 0.5 TiO 3 (BNT)–based ceramics. The incorporation of the hypothetical perovskite BaAlO 2.5 with nominal oxygen defect into BNT will form strongly polarized directional defect dipoles, leading to a strong pinning effect after aging. The large asymmetrical strain is mainly attributed to two factors: The defect dipoles along crystallographic [001] direction destroy the long-range ordering of the ferroelectric and activate a reversible phase transition while promoting polarization rotation when the dipoles are aligned along the applied electric field. Our results not only demonstrate the potential application of BNT-based materials in low-frequency, large-stroke actuators but also provide a general methodology to achieve large strain.

No abstract