We have developed a series of biodegradable elastomers, poly(glycerol sebacate) (PGS), based on glycerol and sebacic acid. The polymers are potentially useful in soft tissue regeneration and engineering. To evaluate the performance of PGS in a physiological environment, we compared their degradation profiles with poly(DL-lactide-co-glycolide) (50:50, carboxyl ended, M(w) 15,000) in vivo. Among the parameters examined are changes in weight and mechanical strength with time, implant geometry, surface characteristics, and degree of swelling. Unlike poly(DL-lactide-co-glycolide), PGS primarily degrades by surface erosion, which gives a linear degradation profile of mass, preservation of geometry and intact surface, and retention of mechanical strength.

Graphene, one kind of emerging carbon nanomaterial, has attracted increasing attention recently. Due to its fascinating physical and electrochemical properties, graphene as a promising electrode material has been widely used in electrochemical sensing applications. In this review, different approaches for the fabrication of graphene and the preparation of graphene-modified electrodes for electrochemical sensors are introduced. Moreover, recent research results on different graphene-based materials as an electrochemical platform for the detection of various biomolecules and chemicals are reviewed and compared. More electrochemical studies on this novel material should show up in the near future.

Poly(glycerol sebacate) (PGS) is a thermally-crosslinked elastomer suitable for tissue regeneration due to its elasticity, degradability, and pro-regenerative inflammatory response. Pores in PGS scaffolds are typically introduced by porogen leaching, which compromises strength. Methods for producing fibrous PGS scaffolds are very limited. Electrospinning is the most widely used method for laboratory scale production of fibrous scaffolds. Electrospinning PGS by itself is challenging, necessitating a carrier polymer which can affect material properties if not removed. We report a simple electrospinning method to produce distinct PGS fibers while maintaining the desired mechanical and cytocompatibility properties of thermally crosslinked PGS. Fibrous PGS demonstrated 5 times higher tensile strength and increased suture retention compared to porous PGS foams. Additionally, similar modulus and elastic recovery were observed. A final advantage of fibrous PGS sheets is the ability to create multi-laminate constructs due to fiber bonding that occurs during thermal crosslinking. Taken together, these highly elastic fibrous PGS scaffolds will enable new approaches in tissue engineering and regenerative medicine.

No abstract

Rational design and understanding of the intrinsic mechanism are critical to develop highly active and durable electrocatalysts. In this study, a series of bi-metallic boride catalysts based on Ni and Co were prepared, and their activities were evaluated. The synthesised Co-10Ni-B catalyst exhibited excellent activity for water splitting in a 1 M KOH electrolyte. The overpotential was 330 mV at a current density of 10 mA cm-2, better than previously reported mono-metallic borides and even IrO2. The synergistic effect of Co and Ni was proved by X-ray photoelectron spectroscopy and electrochemical impedance spectroscopy. The facile formation of critical intermediates CoOOH and NiOOH during the catalytic processes and a significant increase in surface area owing to the introduction of a second metal into mono-metallic boride were attributed to the superior catalytic performance of catalysts for the oxygen evolution reaction. A Co-10Ni-B-sp catalyst with a higher surface area than the Co-10Ni-B catalyst was also synthesised to evaluate the effect of a high surface area on the catalytic activity. A lower overpotential of 310 mV at a current density of 10 mA cm-2 was achieved.