The bandgap in graphene‐based materials can be tuned from 0 eV to that of benzene by changing size and/or surface chemistry, making it a rising carbon‐based fluorescent material. Here, the surface chemistry of small size graphene (graphene quantum dots, GQDs) is tuned programmably through modification or reduction and green luminescent GQDs are changed to blue luminescent GQDs. Several tools are employed to characterize the composition and morphology of resultants. More importantly, using this system, the luminescence mechanism (the competition between both the defect state emission and intrinsic state emission) is explored in detail. Experiments demonstrate that the chemical structure changes during modification or reduction suppresses non‐radiative recombination of localized electron‐hole pairs and/or enhances the integrity of surface π electron network. Therefore the intrinsic state emission plays a leading role, as opposed to defect state emission in GQDs. The results of time‐resolved measurements are consistent with the suggested PL mechanism. Up‐conversion PL of GQDs is successfully applied in near‐IR excitation for bioimaging.

Hard carbon is the leading candidate anode for commercialization of Na-ion batteries. Hard carbon has a unique local atomic structure, which is composed of nanodomains of layered rumpled sheets that have short-range local order resembling graphene within each layer but complete disorder along the caxis between layers. A primary challenge holding back the development of Na-ion batteries is that a complete understanding of the structure-capacity correlations of Na-ion storage in hard carbon has remained elusive. This article presents two key discoveries: first that characteristics of hard carbon's structure can be modified systematically by heteroatom doping, and second, that these structural changes greatly affect Na-ion storage properties, which reveals the mechanisms for Na storage in hard carbon. Specifically, via P or S doping, the interlayer spacing is dilated, which extends the low-voltage plateau capacity, while increasing the defect concentrations with P or B doping leads to higher sloping sodiation capacity. Our combined experimental studies and first principles calculations reveal that it is the Na-ion-defect binding that corresponds to the sloping capacity, while the Na intercalation between graphenic layers causes the low-potential plateau capacity. The new understanding provides a new set of guiding principles to optimize hard carbon for Na-ion battery applications.

There exist tremendous needs for sustainable storage solutions for intermittent renewable energy sources, such as solar and wind energy. Thus, systems based on Earthabundant elements deserve much attention. Potassium-ion batteries represent a promising candidate thanks to the abundance of potassium resources. As for the choices of anodes, graphite exhibits encouraging potassium-ion storage properties; however, it suffers limited rate capability and poor cycling stability. Here, we systematically investigated and compared non-graphitic carbons as K-ion anodes with sodium carboxymethyl cellulose as the binder. Compared to hard This article is protected by copyright. All rights reserved.2 carbon and soft carbon, a composite hard-soft carbon with 20 wt% soft carbon distributed in the matrix phase of hard carbon micron-spheres exhibits highly amenable performance: high capacity, high rate capability, and very stable long-term cycling. In contrast, pure hard carbon suffers limited rate capability, while the capacity of pure soft carbon fades more rapidly.

In this article, graphene quantum dots (GQDs) with tunable surface chemistry (increasing oxidation degree) were prepared by an efficient two-step method. The GQDs have tunable fluorescence induced by the degree of surface oxidation, fine solubility, high stability and applicable up-conversion photoluminescence (PL). The PL mechanism was investigated based on the surface structure and PL behaviors. More importantly, the GQDs have acid-base response property and can be applied as pH sensors.

Electrochemical double-layer capacitors exhibit high power and long cycle life but have low specific energy compared with batteries, limiting applications. Redox-enhanced capacitors increase specific energy by using redox-active electrolytes that are oxidized at the positive electrode and reduced at the negative electrode during charging. Here we report characteristics of several redox electrolytes to illustrate operational/self-discharge mechanisms and the design rules for high performance. We discover a methyl viologen (MV)/bromide electrolyte that delivers a high specific energy of ∼14 Wh kg−1 based on the mass of electrodes and electrolyte, without the use of an ion-selective membrane separator. Substituting heptyl viologen for MV increases stability, with no degradation over 20,000 cycles. Self-discharge is low, due to adsorption of the redox couples in the charged state to the activated carbon, and comparable to cells with inert electrolyte. An electrochemical model reproduces experiments and predicts that 30–50 Wh kg−1 is possible with optimization.

For the first time, we demonstrate that orthorhombic V2O5 can exhibit superior electrochemical performance in sodium ion batteries when uniformly coated inside nanoporous carbon. The encapsulated V2O5 shows a specific capacity as high as 276 mAh/g, while the whole nanocomposite exhibits a capacity of 170 mAh/g. The V2O5/C composite was fabricated by a novel ambient hydrolysis deposition that features sequential water vapor adsorption in nanoporous carbon, followed by a hydrolysis reaction, exclusively inside the nanopores. The unique structure of the nanocomposite significantly enhances the capacity as well as the rate performance of orthorhombic V2O5 where the composite retains a capacity of over 90 mAh/g at a current rate of 640 mA/g. Furthermore, by calculating, we also revealed that a large portion of the sodium-ion storage, particularly at high current rates, is due to the V2O5 pseudocapacitance.

We report that crystalline 3,4,9,10-perylenetetracarboxylic dianhydride (PTCDA), an organic solid, is highly amenable to host divalent metal ions, i.e., Mg and Ca, in aqueous electrolytes, where the van der Waals structure is intrinsically superior in hosting charge-dense ions. We observe that the divalent nature of Mg causes unique squeezing deformation of the electrode structure, where it contracts and expands in different crystallographic directions when hosting the inserted Mg-ions. This phenomenon is revealed experimentally by ex situ X-ray diffraction and transmission electron microscopy, and is investigated theoretically by first-principles calculations. Interestingly, hosting one Mg ion requires the coordination from three PTCDA molecules in adjacent columns of stacked molecules, which rotates the columns, thus reducing the (011) spacing but increasing the (021) spacing. We demonstrate that a PTCDA Mg-ion electrode delivers a reversible capacity of 125 mA h g, which may include a minor contribution of hydronium storage, a good rate capability by retaining 75 mA h g at 500 mA g (or 3.7 C), and a stable cycle life. We also report Ca storage in PTCDA, where a reversible capacity of over 80 mA h g is delivered.

We demonstrate for the first time that hydronium ions can be reversibly stored in an electrode of crystalline 3,4,9,10-perylenetetracarboxylic dianhydride (PTCDA). PTCDA exhibits a capacity of 85 mAh g at 1 A g after an initial conditioning process. Ex situ X-ray diffraction revealed reversible and significant structure dilation upon reduction of PTCDA in an acidic electrolyte, which can only be ascribed to hydronium-ion intercalation. The lattice expansion upon hydronium storage was theoretically explored by first-principles density functional theory (DFT) calculations, which confirmed the hydronium storage in PTCDA.