The protective barrier effect of OMMT and the flame-inhibition effect of TAD jointly exerted a superior flame-retardant effect, resulting in sufficient flame-retardant effect on epoxy thermosets.

Environmental context. Increasing global plastic production adds plastic debris to the environment. We show that potentially harmful additives present in plastic particles are released to water at an increased rate when material properties change by aging due to exposure to high temperature and especially to UV radiation. For risk assessment of such plastic additives, more information on their degradation products and their toxicity is needed.Abstract. Recycled plastic granules of high-density polyethylene, polyvinyl chloride and polystyrene the size of microplastics were exposed to artificial aging conditions (2000 h; photooxidative and thermo-oxidative) to simulate their fate outdoors. Their potential to leach into water during the aging process was investigated using column percolation tests. Aging-related changes on the surface of the material were characterised by IR measurements indicating oxidation reactions with the formation of new adsorption bands (C=O, C-O and OH), especially in the case of photooxidative aging. These findings were confirmed by the identification of leachable organic compounds. Leaching of total organic carbon, Cl, Ca, Cu and Zn is clearly affected by changes due to aging, and their release is increased after photooxidative aging. In general, exposure to photooxidative conditions shows a greater influence on aging and thus on leaching and seems to be the more important mechanism for the aging of microplastic in the environment. Comparison with the total content of inorganic species revealed that, for most elements, less than 3% of the total content is released after 2000 h of photooxidative aging.

We report a study of the orientational order of aligned thin films of the liquid crystalline conjugated polymer poly͑9,9-dioctylfluorene͒. Steady state polarized fluorescence measurements were used to determine the orientational order parameter ͗P 2 ͘ and ͗P 4 ͘. The influence of intermolecular and intramolecular excitation energy transfer on the degree of polarization is discussed. The role of film morphology is also examined by comparison of the results for glassy and crystalline films. ͓S0163-1829͑99͒05525-3͔

No abstract

No abstract

No abstract

Multilayer graphene (MLG) is composed of approximately 10 sheets of graphene. It is a promising nanofiller just starting to become commercially available. The dispersion of the nanofiller is essential to exploit the properties of the nanocomposites and is dependent on the preparation method. In this study, direct incorporation of 3 parts per hundred of rubber (phr) MLG into chlorine-isobutene-isoprene rubber (CIIR) on a two-roll mill did not result in substantial enhancement of the material properties. In contrast, by pre-mixing the MLG (3 phr) with CIIR using an ultrasonically assisted solution mixing procedure followed by two-roll milling, the properties (rheological, curing, and mechanical) were improved substantially compared with the MLG/CIIR nanocomposites mixed only on the mill. The Young's moduli of the nanocomposites mixed in solution increased by 38%. The CIIR/MLG nanocomposites produced via solution showed superior durability against weathering exposure.

No abstract