No abstract

No abstract

Airborne particulate matter emitted from motor vehicle brakes is a contributor to urban air quality. Therefore, a method to rank brake pairs (pads and rotors) with respect to their particle emission factors in a reliable way is needed to develop a low-emission disc brake. A novel inertial disc brake dynamometer designed for brake particle emission studies, a modified SAE J 2707 cycle, an electrical low-pressure cascade impactor and a filter are used to test five different pad materials against cast-iron rotors. By changing only the pad materials, it is shown that the differences between the mass emission factor and the number emission factor of the the worst brake pair and those of the best brake pair decreases by more than four times and 19 times respectively. Furthermore, the results show that the material combination ranked the best in terms of the mass emission factor is ranked the worst in terms of the number emission factor. The results reveal that this combination of a test stand, a test cycle and particle instruments can discriminate between different brake pair materials in a reliable way in the case of the mass emission factors while more research has to be carried out in the case of the number emission factors.

No abstract

No abstract

Brake-related airborne particulate matter contributes to urban emissions in the transport sector. Recent research demonstrated a clear dependence of the number of ultra-fine particles on the disc brake temperature. Above the so-called transition temperature, the number of ultra-fine particles increases dramatically (several magnitudes). As for exhaust emissions, part of the emissions released during braking can be in the volatile fraction. For this reason, a disc brake test stand specifically designed for aerosol research was equipped with three different aerosol sampling instruments: (i) a standard cascade impactor, (ii) a cascade impactor operating at high temperature with a heated sampling line, and (iii) a standard cascade impactor with a thermodenuder. Tests with a brake assembly representative of European passenger vehicles were executed, and the concentration of released airborne particles was determined. The results showed a decrease by several magnitudes in the concentration (in the size range of below 200 nm) using the cascade impactor operating at 180 °C with the sampling line heated to 200 °C. A further decrease in the concentration of airborne particles with size fractions below 200 nm was measured using a standard cascade impactor with a thermodenuder heated to 300 °C.

No abstract

No abstract