Bis(LeuOH) (1a), bis-(ValOH) (2a) and bis(PhgOH) (5a) (Phg denotes (R)-phenylglycine) oxalyl amides are efficient low molecular weight organic gelators of various organic solvents and their mixtures as well as water, water/DMSO, and water/DMF mixtures. The organisational motifs in aqueous gels are dominated primarily by lipophilic interactions while those in organic solvents are formed by intermolecular hydrogen bonding. Most of the gels are thermoreversible and stable for many months. However, 2a forms unstable gels with organic solvents which upon ageing transform into variety of crystalline shapes. For some 1a/alcohol gels, a linear correlation between alcohol dielectric constants (epsilon) and gel melting temperatures (Tg) was found. The 1H NMR and FTIR spectroscopic investigations of selected gels reveal the existence of temperature dependent network assembly/dissolution equilibrium. In the 1H NMR spectra of gels only the molecules dissolved in entrapped solvent could be observed. By using an internal standard, the concentration of dissolved gelator molecules could be determined. In FTIR spectra, the bands corresponding to network assembled and dissolved gelator molecules are simultaneously present. This enabled determination of the Kgel values by using both methods. From the plots of InKgel versus 1/T, the deltaHgel values of selected gels have been determined (-deltaHgel in 10-36 kJ mol(-1) range) and found to be strongly solvent dependent. The deltaHgel values determined by 1H NMR and FTIR spectroscopy are in excellent agreement. Crystal structures of 2a and rac-5a show the presence of organisational motifs and intermolecular interactions in agreement with those in gel fibres elucidated by spectroscopic methods.

Abstract. This article summarizes methods for determining proton surface charge at mineral/water interfaces. It covers conventional experimental procedures and discusses problems with the techniques. Also it involves recommendations for obtaining reasonable and comparable results. The term "comparable results" refers to comparison between results for the same solid as obtained in different laboratories. The most important parameters for the surface titrations are discussed. We also propose a reference titration procedure that would allow direct, unbiased comparisons of experimental data. The article finally includes a check-list for researchers and reviewers which should allow limiting the amount of titration data that are not useful for future uses. (doi: 10.5562/cca2062)

Complexation of alkali-metal cations with calix[4]arene secondary-amide derivative, 5,11,17,23-tetra(tert-butyl)-25,26,27,28-tetra(N-hexylcarbamoylmethoxy)calix[4]arene (L), in benzonitrile (PhCN) and methanol (MeOH) was studied by means of microcalorimetry, UV and NMR spectroscopies, and in the solid state by X-ray crystallography. The inclusion of solvent molecules (including acetonitrile, MeCN) in the calixarene hydrophobic cavity was also investigated. The classical molecular dynamics (MD) simulations of the systems studied were carried out. By combining the results obtained using the mentioned experimental and computational techniques, an attempt was made to get an as detailed insight into the complexation reactions as possible. The thermodynamic parameters, that is, equilibrium constants, reaction Gibbs energies, enthalpies, and entropies, of the investigated processes were determined and discussed. The stability constants of the 1:1 (metal:ligand) complexes measured by different methods were in very good agreement. Solution Gibbs energies of the ligand and its complexes with Na(+) and K(+) in methanol and acetonitrile were determined. It was established that from the thermodynamic point of view, apart from cation solvation, the most important reason for the huge difference in the stability of these complexes in the two solvents lay in the fact that the transfer of complex species from MeOH to MeCN was quite favorable. That could be at least partly explained by a more exergonic inclusion of the solvent molecule in the complexed calixarene cone in MeCN as compared to MeOH, which was supported by MD simulations. Molecular and crystal structures of the lithium cation complex of L with the benzonitrile molecule bound in the hydrophobic calixarene cavity were determined by single-crystal X-ray diffraction. As far as we are aware, for the first time the alkali-metal cation was found to be coordinated by the solvent nitrile group in a calixarene adduct. According to the results of MD simulations, the probability of such orientation of the benzonitrile molecule included in the ligand cone was by far the largest in the case of LiL(+) complex. Because of the favorable PhCN-Li(+) interaction, L was proven to have the highest affinity toward the lithium ion in benzonitrile, which was not the case in the other solvents examined (in acetonitrile, sodium complex was the most stable, whereas in methanol, complexation of lithium was not even observed). That could serve as a remarkable example showing the importance of specific solvent-solute interactions in determining the equilibrium in solution.

The calix[4]arene secondary-amide derivative L was synthesized, and its complexation with alkali-metal cations in acetonitrile (MeCN) was studied by means of spectrophotometric, NMR, conductometric, and microcalorimetric titrations at 25 °C. The stability constants of the 1:1 (metal/ligand) complexes determined by different methods were in excellent agreement. For the complexation of M(+) (M = Li, Na, K) with L, both enthalpic and entropic contributions were favorable, with their values and mutual relations being quite strongly dependent on the cation. The enthalpic and overall stability was the largest in the case of the sodium complex. Molecular and crystal structures of free L, its methanol and MeCN solvates, the sodium complex, and its MeCN solvate were determined by single-crystal X-ray diffraction. The inclusion of a MeCN molecule in the calixarene hydrophobic cavity was observed both in solution and in the solid state. This specific interaction was found to be stronger in the case of metal complexes compared to the free ligand because of the better preorganization of the hydrophobic cone to accept the solvent molecule. Density functional theory calculations showed that the flattened cone conformation (C(2) point group) of L was generally more favorable than the square cone conformation (C(4) point group). In the complex with Na(+), L was in square cone conformation, whereas in its adduct with MeCN, the conformation was slightly distorted from the full symmetry. These conformations were in agreement with those observed in the solid state. The classical molecular dynamics simulations indicated that the MeCN molecule enters the L hydrophobic cavity of both the free ligand and its alkali-metal complexes. The inclusion of MeCN in the cone of free L was accompanied by the conformational change from C(2) to C(4) symmetry. As in solution studies, in the case of ML(+) complexes, an allosteric effect was observed: the ligand was already in the appropriate square cone conformation to bind the solvent molecule, allowing it to more easily and faster enter the calixarene cavity.

No abstract

No abstract

No abstract

Complexation of dihydrogen phosphate by novel thiourea and urea receptors in acetonitrile and dimethyl sulfoxide was studied in detail by an integrated approach by using several methods (isothermal titration calorimetry, ESI-MS, and (1)H NMR and UV spectroscopy). Thermodynamic investigations into H2PO4(-) dimerisation, which is a process that has been frequently recognised, but rarely quantitatively described, were carried out as well. The corresponding equilibrium was taken into account in the anion-binding studies, which enabled reliable determination of the complexation thermodynamic quantities. In both solvents the thiourea derivatives exhibited considerably higher binding affinities with respect to those containing the urea moiety. In acetonitrile, 1:1 and 2:1 (anion/receptor) complexes formed, whereas in dimethyl sulfoxide only the significantly less stable complexes of 1:1 stoichiometry were detected. The solvent effects on the thermodynamic parameters of dihydrogen phosphate dimerisation and complexation reactions are discussed.