This article represents the results of studies of the drawing thin wire from the alloy Pd-5Ni process. The studies used the software developed by the authors using the methods of calculating the drawing process and the computer model implemented in the DEFORM 3D software package. By way of calculation, a drawing route was determined, including 14 transitions, and the efforts of deforming the metal were found when producing wire with a diameter of 0.075. For this mode of deformation processing using the DEFORM 3D software package, we simulated the drawing process and established the temperature and stress distribution over the volume of the workpiece. The simulation results confirmed that the calculated safety factor for drawing is in the range of 2.85-3.43, which ensures a stable process of deformation of the metal without breaks and, as a consequence, an increase in productivity and yield of the suitable metal. Experimental studies have confirmed the adequacy of the developed model, so it can be used to analyze the process of drawing wire from other precious metal alloys. The results of the research are recommended to improve the production technology of thin wire from the alloy Pd-5Ni for the manufacture of catalytic gripping grids.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.