No abstract

No abstract

No abstract

Biodegradation studies of Mg-1Ca alloy with different microstructures in Ringer's solution reveal corrosion mechanism based on the balance between the anodic dissolution of the secondary phase and hydroxide precipitation, controlled by the secondary phase size and distribution uniformity. Alloy with ultrafine-grain structure shows at least 5-fold improvement in corrosion resistance compared to the coarse-grained alloy due to the separation of the particles of the secondary phase and its continuous intragranular nano-precipitation. This promotes an unusual low-frequency impedance behaviour described by an inductive loop with the negative time constant, which leads to the increased impedance modulus signifying the improved corrosion resistance.

The authors previously used the accumulative high-pressure torsion (ACC HPT) method for the first time on steel 316, β-Ti alloy, and bulk metallic glass vit105. On low-alloyed alloys, in particular, the zirconium alloy Zr-1%Nb, the new method was not used. This alloy has a tendency to α → ω phase transformations at using simple HPT. When using ACC HPT, the α → ω transformation can be influenced to a greater extent. This article studies the sliding effect and accumulation of shear strain in Zr-1%Nb alloy at various stages of high-pressure torsion (HPT). The degree of shear deformation at different stages of HPT was estimated. The influence of various high-pressure torsion conditions on the micro-hardness and phase composition by X-ray diffraction (XRD) of Zr-1%Nb was analyzed. It is shown that at high-pressure torsion revolutions of n = 2, anvils and the specimen significantly slip, which is a result of material strengthening. It was found that despite sliding, regular high-pressure torsion resulted in the high strengthening of Zr-1%Nb alloy (micro-hardness more than doubled), and after high-pressure torsion n = 10, up to 97% of the high-pressure ω-phase was formed in it (as in papers of other researchers). Accumulative high-pressure torsion deformation leads to the strongest transformation of the Zr-1%Nb structure and Hv and, therefore, to a higher real strain of the material due to composition by upsetting and torsion in strain cycles.