Thermal sprayed coatings are used in various applications often dedicated to corrosion and wear protection.Poresand other coating imperfections reduce corrosion and wear resistance and/or necessitate higher coating thicknesses. To improve the quality of thermal sprayed coatings, various post-treatment processes can be used. Characterisation of the efficiency of sealing was studied by metallographic examination andcomparative investigation of the corrosion and wear behaviour of the thermal sprayed coatings used with and without sealing and also by measuring the insulation resistance of the coating system. The results differ among the sealants. It is possible to remove the sealants from the coatings by mechanical treatment. Corrosion tests of the sealants demonstrate their efficiency in closing the interconnected pores and, consequently, preventing corrosion.
The characterisation of the effectiveness of sealing was studied by metallographical investigations as well as comparing the investigations with respect to the corrosion- and wear behaviour of the used thermal sprayed coatings and last but not least by measuring of the insulation resistance of the coating system. The obtained results show that there are differences between the used sealants and it is possible through a mechanical treatment of sealed coatings to remove the sealants from the coatings. In the corrosion test the sealants show their efficiency. The sealants insulate the open porosity and prevent the corrosion attack owing to the interconnected pores.
Lock-in thermography is a nondestructive inspection method based on modulated heat transport in combination with infrared imaging. Measurement times are relatively short, about 3 or 4 minutes, and the method is amenable to inspecting a wide range of large and small parts. This paper describes the basic principle behind the method and its application to different thermal sprayed coatings (e.g., Cr-steel, Al2O3). It explains how the test samples were prepared with artificial defects simulating delaminations, inclusions, and other types of imperfections and how the method performed in each case.
The control of the coating quality becomes more and more important. Infrared methods are well introduced in industry for several types of inspections. The lock-in thermography is based on modulated heat flux and is proved for composite materials and electronic components. In combination with an IR-camera seems to meet the requirements of a modem quality control system. The off-line measurement takes about 3 up to 5 minutes depending on the geometry of the surface. The paper gives an overview on the principle, the technical details of the measurement and the correlation of the detected signals and the coating properties will be discussed. The accuracy concerning the thickness is determined for different coatings (e.g. WC-Co).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.