The aim of this work was to compare methods of determining the leaf area of guava (leaf discs and scanned images) and to model leaf area as a function of linear dimensions. Four areas of guava ‘Paluma’ were selected (12, 15, 20 and 24 months of age) for the experiment in the municipality of Pedro Canário, ES, Brazil. We randomly collected samples from 15 plants in each area. Ten leaves were chosen among the lower, middle and upper thirds of each plant to ensure that leaves of all sizes were collected, for a total of 600 leaves. Subsequently, we determined the leaf area by the methods of digital imaging and leaf discs. Linear regression analysis and correlation analysis were used to compare the methods. Linear, quadratic and power models of leaf area, as a function of the length or width and/or the product of length and width were adjusted. The methods of leaf discs and scanned images are discordant. The method of digitised images was a better fit to the width of the leaf, while the method of leaf discs was a better fit for length.
The uniformity and droplet size produced during the spraying as well the correct deposition of these in the target, contribute directly to the success of a pesticide application. The objective of the present study was to characterize the ejected spray in the aerial and terrestrial spraying of pumpkin crops, with the use of adjuvants in a liquid solution. The experiment was carried out in two commercial plantations, in an entirely randomized design, employing a 6 × 2 factorial scheme, with six forms of application and two liquid compositions. The droplet spectrum was assessed employing water-sensitive card imaging. Smaller drop sizes and relative amplitudes were produced by aerial applications. In turn, the largest droplet diameters and the lowest percentage of drops smaller than 100 μm were obtained when using air induction twin flat spray nozzles. The adjuvant did not interfere in the numerical and volumetric median diameters, the relative amplitude, or the volume rate of droplets smaller than 100 μm.
The objective was to evaluate the equipment efficiency in reducing drift and increasing the spray deposition. The experiment was conducted of the conilon coffee plantation, located on the experimental area of the Federal Institute of Espirito Santo, Itapina, Brazil. The experiment was a randomized complete block design with four replications. The treatments consisted: a knapsack sprayer with electrostatic assistance, an electric knapsack sprayer, a knapsack sprayer with a spray shield, and a knapsack sprayer without a spray shield. All sprayers were equipped with a single spray nozzle. Spray deposition was evaluated on wee leaves using a food colourant as a tracer. The knapsack sprayer with electrostatic assistance was the most efficient equipment, providing lower values of drift, and the greatest deposition on the weeds. It is recommended to use the electrostatic sprayer, as it showed greater efficiency in the application of the product on the target, using smaller volume
The quality and quantity production of watermelon requires the effective control of pests, diseases, and weeds, which is directly related to spraying techniques. The method of application of phytosanitary products is essential, but, most of the time, emphasis is given mainly to the applied product and little attention to the application technique. The objective of the present study was to characterize the ejected spray in the aerial and terrestrial spraying of watermelon crops, with the use of adjuvants in a liquid solution. The experiment was carried out in two commercial plantations, in an entirely randomized design, employing a 6 × 2 factorial scheme, with six forms of application and two liquid compositions. The droplet spectrum was assessed employing water-sensitive card imaging. Smaller drop sizes and relative amplitudes were produced by aerial applications. In turn, the largest droplet diameters and the lowest percentage of drops smaller than 100 μm were obtained when using air induction flat double-jet nozzles. The adjuvant did not interfere in the numerical and volumetric median diameters, the relative amplitude, or the volume rate of droplets smaller than 100 μm.
The plants of C. arabica do not naturally produce a large number of orthotropic sprouts, hindering clonal multiplication by cutting, which would be the simplest technique with a lower cost of production compared to other methods of vegetative propagation. An alternative form, used successfully in the propagation of eucalyptus, is propagation by minicutting, which consists of pruning the shoot apex of the plant, forming the ministumps, which in variable time interval emits the shoots that will be used to make minicutting. In C. arabica plants the number of shoots can be increased with the application of growth regulators and fertilizers. So, the purpose of this work was to verify the effect of growth regulators and foliar fertilizers on the emission and development of orthotropic shoots of C. arabica. The experiment was installed in a randomized complete block design, with ten treatments composed by growth regulators and fertilizers: T1 (Control); T2 (Stimulate + Sturdy + Enervig); T3 (Stimulate + Vitakelp + Biozyme); T4 (Tiba + Sturdy + Enervig); T5 (Tiba + Vitakelp + Biozyme); T6 (Brs + Sturdy + Enervig) T7 (Brs + Vitakelp + Biozyme); T8 (Stimulate); T9 (TIBA); T10 (Brs-Brassinoesteroid), each plot consisting of two plants. Biometric and physiological parameters were evaluated for the ministumps, as well as the biometric parameters of the shoots and plant survival. The results showed that there was no influence of the treatments on the biometric parameters of the ministumps. A greater number of orthotopic sprouts were obtained in treatments with the TIBA growth regulator, as well as a greater plant survival of the minicuttings, after 25 days of transplanting in a greenhouse. It was concluded that TIBA treatments influenced the production and quality of clonal minicuttings of C. arabica.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.