No abstract

No abstract

No abstract

Gaseous emissions from vehicles contribute substantially to air pollution and climate change. Vehicular emissions also contain secondary pollutants produced via chemical reactions that occur between the emitted gases and atmospheric air. This study aims at understanding patterns concerning emission of regulated, greenhouse, and precursor gases, which demonstrate potential for secondary aerosol (SA) formation, from vehicles incorporating different engine technologies—multi-point injection (MPI) and gasoline direct injection (GDI)—and using different fuels—gasoline, liquefied petroleum gas (LPG), and diesel. Drive cycles from the National Institute of Environmental Research (NIER) were used in this study. Results obtained from drive cycle tests demonstrate a decline in aggregate gas emissions corresponding to an increase in average vehicle speed. CO2 accounts for more than 99% of aggregate gaseous emissions. In terms of concentration, CO and NH3 form predominantly non-CO2 emissions from gasoline and LPG vehicles, whereas nitrogen oxides (NOx) and non-methane hydrocarbons (NMHC) dominate diesel-vehicle emissions. A higher percentage of SO2 is emitted from diesel vehicles compared to their gasoline- and LPG-powered counterparts. EURO-5- and EURO-6-compliant vehicles equipped with diesel particulate filters (DPFs) tend to emit higher amounts of NO2 compared to EURO-3-compliant vehicles, which are not equipped with DPFs. Vehicles incorporating GDI tend to emit less CO2 compared to those incorporating MPI, albeit at the expense of increased CO emissions. The authors believe that results reported in this paper concerning regulated and unregulated pollutant-emission monitoring can contribute towards an accurate evaluation of both primary and secondary air-pollution scenarios in Korea.

Size-segregated ultrafine particles (UFPs) in diesel exhaust were investigated to characterize carbonaceous substances, metals, and organic compounds originating from a medium-duty diesel engine dynamometer using the 13 driving mode. Organic carbon (OC) and elemental carbon (EC) peaked at 330-550 nm, but the OC/EC ratio showed two peaks in the ultrafine and accumulation modes. The distribution trend of metal elements was opposite to that of the size-segregated OC/EC ratio. The amounts of toxic Pb, As, and Cd were less than 0.03-2.5% in diesel exhaust particles (DEPs), but their cumulative fractions in the ultrafine mode exceeded 50%. Most organic compounds (76.6%) and alkanes (67.0%) were emitted in the accumulation mode (170-1000 nm). More than 70% of the identified polycyclic aromatic hydrocarbons (PAHs) were emitted in the accumulation mode (94-1000 nm), with phenanthrene being the most abundant. Two significant size ranges of toxicity equivalent quantity peaks in the ultrafine (34-66 nm) and accumulation (170-330 nm) modes were observed for the size-segregated DEPs. Contrary to the trends for PAHs and organic compounds, the identifiable nitrogen-containing polycyclic aromatic compounds were more abundant in the ultrafine mode. Overall toxicity was high as UFPs can be deposited with high efficiency throughout the human respiratory tract.

No abstract

In Korea emissions from motor vehicles are a major source of air pollution in metropolitan cities, and in Seoul a large proportion of the vehicle fleet is made up of gasoline-powered passenger cars. The carbon monoxide (CO), hydrocarbons (HC), oxides of nitrogen (NOx) and carbon dioxide (CO2) contained in the exhaust emissions from 76 gasoline-powered passenger cars equipped with three-way catalysts has been assessed by vehicle speed, vehicle mileage and model year. The results show that CO, HC, NOx and CO2 emissions remained almost unchanged at higher speeds but decreased rapidly at lower speeds. While a reduction in CO, HC and NOx emissions was noticeable in vehicles of recent manufacture and lower mileage, CO2 emissions were found to be insensitive to vehicle mileage, but strongly dependent on gross vehicle weight. Lower emissions from more recent gasoline-powered vehicles arose mainly from improvements in three-way catalytic converter technology following strengthened emission regulations. The correlation between CO2 emission and fuel consumption has been investigated with a view to establishing national CO2 emission standards for Korea.

The emission characteristics of mobile air pollution sources belonging to the non-road sector have yet to be thoroughly investigated, especially when compared to those of on-road vehicles. Hence, the present study employed an engine dynamometer to evaluate the emissions of a diesel engine complying with Tier 3 standards during various driving modes (KC1-8, NRSC, and NRTC) and a portable emissions measurement system (PEMS) to assess those of two excavators, one complying with Tier 3 and the other with Tier 4 standards, during real-world working and driving conditions. The characteristics and chemical composition of the emitted regulated pollutants (carbon monoxide (CO), non-methane hydrocarbon (NMHC), nitrogen oxide (NO x), and particulate matter (PM)) and hazardous air pollutants (HAPs), e.g., volatile organic compounds (VOCs), aldehydes, and polycyclic aromatic hydrocarbons (PAHs), were then determined. For the regulated pollutants, NRTC mode generated the highest emissions owing to the rapid changes in engine load and speed during transitions. As a result of the after-treatment systems, which utilized a diesel oxidation catalyst (DOC) and selective catalytic reduction (SCR), CO, NMHC, and NO x emissions from the Tier 4-compliant excavator were lower than those from the Tier 3compliant diesel engine and excavator. The operating conditions of the diesel engine and construction equipment as well as the after-treatment systems significantly affected the composition of the non-methane volatile organic compound (NMVOC) emissions, which were dominated by alkanes that comprised 23 detected species. Sampling the particle-phase PAHs, we found phenanthrene, fluoranthene, and naphthalene; furthermore, we estimated the concentrations of the gas-phase PAHs with models to obtain the total PAH concentrations. Formaldehyde, which contributed the largest fraction of the aldehydes, was more abundant than the other species. Thus, emissions from non-road sources, including construction equipment, must be controlled because of the considerable health risks from pollutants such as formaldehyde and benzene. Our results will aid in the establishment of a national emission inventory for HAPs.