No abstract

No abstract

No abstract

Gaseous emissions from vehicles contribute substantially to air pollution and climate change. Vehicular emissions also contain secondary pollutants produced via chemical reactions that occur between the emitted gases and atmospheric air. This study aims at understanding patterns concerning emission of regulated, greenhouse, and precursor gases, which demonstrate potential for secondary aerosol (SA) formation, from vehicles incorporating different engine technologies—multi-point injection (MPI) and gasoline direct injection (GDI)—and using different fuels—gasoline, liquefied petroleum gas (LPG), and diesel. Drive cycles from the National Institute of Environmental Research (NIER) were used in this study. Results obtained from drive cycle tests demonstrate a decline in aggregate gas emissions corresponding to an increase in average vehicle speed. CO2 accounts for more than 99% of aggregate gaseous emissions. In terms of concentration, CO and NH3 form predominantly non-CO2 emissions from gasoline and LPG vehicles, whereas nitrogen oxides (NOx) and non-methane hydrocarbons (NMHC) dominate diesel-vehicle emissions. A higher percentage of SO2 is emitted from diesel vehicles compared to their gasoline- and LPG-powered counterparts. EURO-5- and EURO-6-compliant vehicles equipped with diesel particulate filters (DPFs) tend to emit higher amounts of NO2 compared to EURO-3-compliant vehicles, which are not equipped with DPFs. Vehicles incorporating GDI tend to emit less CO2 compared to those incorporating MPI, albeit at the expense of increased CO emissions. The authors believe that results reported in this paper concerning regulated and unregulated pollutant-emission monitoring can contribute towards an accurate evaluation of both primary and secondary air-pollution scenarios in Korea.

Size-segregated ultrafine particles (UFPs) in diesel exhaust were investigated to characterize carbonaceous substances, metals, and organic compounds originating from a medium-duty diesel engine dynamometer using the 13 driving mode. Organic carbon (OC) and elemental carbon (EC) peaked at 330-550 nm, but the OC/EC ratio showed two peaks in the ultrafine and accumulation modes. The distribution trend of metal elements was opposite to that of the size-segregated OC/EC ratio. The amounts of toxic Pb, As, and Cd were less than 0.03-2.5% in diesel exhaust particles (DEPs), but their cumulative fractions in the ultrafine mode exceeded 50%. Most organic compounds (76.6%) and alkanes (67.0%) were emitted in the accumulation mode (170-1000 nm). More than 70% of the identified polycyclic aromatic hydrocarbons (PAHs) were emitted in the accumulation mode (94-1000 nm), with phenanthrene being the most abundant. Two significant size ranges of toxicity equivalent quantity peaks in the ultrafine (34-66 nm) and accumulation (170-330 nm) modes were observed for the size-segregated DEPs. Contrary to the trends for PAHs and organic compounds, the identifiable nitrogen-containing polycyclic aromatic compounds were more abundant in the ultrafine mode. Overall toxicity was high as UFPs can be deposited with high efficiency throughout the human respiratory tract.