Fatty acid esters of 3-monochloropropanediol (3-MCPD) and glycidol are processing contaminants found in a wide range of edible oils. While both 3 MCPD and glycidol have toxicological properties that at present has concerns for food safety, the published occurrence data are limited. Occurrence information is presented for the concentrations of 3-MCPD and glycidyl esters in 116 retail and/or industrial edible oils and fats using LC-MS/MS analysis of intact esters. The concentrations for bound 3-MCPD ranged from below the limit of quantitation (

The synthesis and characterization of a new pyridinofullerene ligand capable of forming axially symmetric complexes with ZnTPP is reported; molecular modelling studies, 1H NMR, UV-Vis spectroscopy and fluorescence quenching data support formation of a strong complex between the new ligand and ZnTPP.

The subject of this paper is a new fullerene building block design with the potential for defined geometry and good electronic communication. The synthesis and characterization of a new pyridinofullerene ligand capable of forming axially symmetric complexes with metalloporphyrins is reported. X-ray structural and molecular modeling studies, (1)H NMR, UV-vis spectroscopy, electrochemistry studies, and fluorescence quenching data support the formation of a strong complex between the new ligand and the metal center of ZnTPP. On the basis of computational studies, the highest occupied molecular orbital (HOMO) of this ligand is significantly different from a model compound with insulating carbons between the pyridine and the fullerene. The N-pyridinium fulleropyrrolidine salts of the new ligand and model compound were also prepared and their spectral and electrochemical properties are reported.

A method was developed and validated for the detection of fatty acid diesters of 2-monochloropropanediol (2-MCPD) and 3-monochloropropanediol (3-MCPD) in edible oils. These analytes are potentially carcinogenic chemical contaminants formed during edible oil processing. After separation from oil matrices using a two-step solid-phase extraction (SPE) procedure, the target compounds are quantitated using liquid chromatography-tandem mass spectrometry (LC-MS/MS) with electrospray ionization (ESI). The first chromatographic conditions have been developed that separate intact diesters of 2-MCPD and 3-MCPD, allowing for their individual quantitation. The method has been validated for 28 3-MCPD diesters of lauric, myristic, palmitic, linolenic, linoleic, oleic, and stearic acids in coconut, olive, and palm oils, as well as 3 2-MCPD diesters, using an external calibration curve. The range of average recoveries and relative standard deviations (RSDs) across the three oil matrices at three spiking concentrations are 88-118% (2-16% RSD) with maximum limits of quantitation of 30 ng/g (ppb).

No abstract

A new analytical method has been developed and validated for the detection of glycidyl esters (GEs) and 3-monochloropropanediol (3-MCPD) monoesters in edible oils. The target compounds represent two classes of potentially carcinogenic chemical contaminants formed during the processing of edible oils. Target analytes are separated from edible oil matrices using a two-step solid-phase extraction (SPE) procedure. The extracts are then analyzed using liquid chromatography-tandem mass spectrometry (LC-MS/MS) with electrospray ionization (ESI). Chromatographic conditions that separate sn-1 and sn-2 monoesters of 3-MCPD have been developed for the first time. The method has been validated for GEs, sn-1 3-MCPD monoesters of lauric, myristic, linolenic, linoleic, oleic, and stearic acids, and sn-2 3-MCPD monoesters of oleic and palmitic acids in coconut, olive, and palm oils using an external calibration curve. The range of average recoveries and relative standard deviations (RSDs) across the three oil matrices at three spiking concentrations are 84-115% (3-16% RSD) for the GEs, 95-113% (1-10% RSD) for the sn-1 3-MCPD monoesters, and 76.8-103% (5.1-11.2% RSD) for the sn-2 3-MCPD monoesters, with limits of quantitation at or below 30 ng/g for the GEs, 60 ng/g for sn-1 3-MCPD monoesters, and 180 ng/g for sn-2 3-MCPD monoesters.

Cross-linked polyester resins are being introduced into the market as alternatives to epoxy resins as coatings for metal food cans. Identification of potential migrants, from these coatings into food, is a significant analytical challenge due to the diversity of substances employed in the manufacture of the coatings. However, such identification is required to assess migration from the can coating into the food and quantify dietary exposure. Polyester can coatings were extracted with acetonitrile at 40°C for 24h and the extracts were analyzed by a variety of analytical techniques, including GC-MS, HPLC-DAD/MS, HPLC-DAD/CAD and UHPL C-HRMS. Twenty nine non-volatile oligomers were tentatively identified using retention times, UV spectra, and accurate mass measurements. Identified oligomers suggest the coating in use for food cans is a polyester coating and is mainly based on the monomers isophthalic acid, terephthalic acid and nadic acid. To give confidence in the identification, one of the tentatively identified oligomer was synthetized and analyzed by (13)C and (1)H NMR and UHPL C-HRMS. The NMR and HRMS results, confirmed the presence of this compound in the can extracts. Finally, to determine if rapid, direct detection of the oligomers was practical, the coatings were analyzed by DART-HRMS. Twenty three out of the 29 oligomers were identified in the coating by direct measurement with DART-HRMS in few minutes.

There is substantial interest in dyads in which C(60) is covalently linked to electron donors, such as porphyrins, which absorb light strongly in the visible region. We present here the details of the syntheses of such compounds, which can be broadly organized into categories depending upon the nature of the linker joining the two chromophores. The structural aspects of intramolecular electronic interaction that we have sought to explore have dictated the synthetic strategies employed to generate these classes of molecules. Flexible glycol linkers were used to allow close approach between the fullerene and porphyrin, facilitating through-space interactions. These linkers also allowed studies of the effects of metal cation complexation. Naphthalene and alkyne linkers were used to examine the possible effects a conjugated or aromatic linker might have on photophysical properties. Finally, steroids were used as linkers in dyads expected to possess a large distance between the two chromophores, in which only through-bond interactions between the fullerene and porphyrin should be possible.