The Cu-Ni-Si-Mg alloy was treated by aging after varying cold deformation. The effect of cold deformation, aging temperature and aging time on the microstructure and properties of the alloy were investigated. The results indicate that the alloy produce a larger number of slip bands and dislocations after cold deformation, it can accelerate the precipitation of phase during aging, improve the microhardness and electrical conductivity. The microhardness and electrical conductivity of the alloy with 80% deformation aging at 723 K for 1h are 242HV and 35.53%IACS, respectively. The volume fraction of the precipitated phase was calculated by measuring the electrical conductivity of the alloy with 80% deformation aging at 773 K, then both the equations of phase transformation and the electrical conductivity equation were obtained.
The two-dimensional O-ring seal nonlinear axisymmetric finite element model are established which is used for swinging hydraulic cylinder. Some factors influencing rubber O-ring sealing performance were taken into account, such as rotating shaft diameter, O-ring seal section diameter. The results indicate that when medium pressure is zero, the two factors influence Von Mises and maximum contact stress of sealing face greatly. Under medium pressure (P=10Mpa), the two factors have a little influence to Von Mises and maximum contact stress.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.