The aim of this work was to compare the effects induced by two different sterilization methods (exposure to gamma radiation or ethylene oxide) and an antiseptic technique (immersion in 70% ethanol aqueous solution) on the morphology, tensile strength, percentage of strain at break, and in vitro cytotoxicity to Vero cells on chitosan membranes designed for wound healing. Four distinct membrane compositions were evaluated, with chitosan, glycerol, and chitin used as components. Gamma radiation, in spite of being one of the most commonly employed sterilizing agents, negatively affected the morphology of membranes composed solely by chitosan as well as the percentage of strain at break of the chitosan-membranes containing glycerol on their composition. Moreover, its use affected the color of the chitosan membranes. The use of 70% ethanol aqueous solution did not change the chitosan-membrane characteristics significantly, but its use has limitations concerning the process scale up. With ethylene oxide (EtO), chitosan-membrane morphology, percentage of strain at break, and in vitro cytotoxicity to Vero cells were not significantly affected. The tensile strength of the membranes containing chitin were reduced after the treatment with ethylene oxide; however, the obtained values were comprised in the range verified for normal human skin. Therefore, because the final characteristics of the membranes treated with ethylene oxide are appropriate when considering their use as wound healing devices, and because this sterilization process is easily adjusted to use on an industrial scale, EtO can be considered the most adequate sterilizing agent for chitosan membranes. However, it should be considered that this chemical is associated with toxicity, flammability, and environmental risks, as well as with possible material contamination with ethylene oxide residues.

In recent years, there has been a great interest in the development of biomaterials that could be used in the repair of bone defects. Collagen matrix (CM) has the advantage that it can be modified chemically to improve its mechanical properties. The aim of the present study was to evaluate the effect of three-dimensional membranes of native or anionic (submitted to alkaline treatment for 48 or 96 h) collagen matrix on the consolidation of osteoporosis bone fractures resulting from the gonadal hormone alterations caused by ovariectomy in rats subjected to hormone replacement therapy. The animals received the implants 4 months after ovariectomy and were sacrificed 8 weeks after implantation of the membranes into 4-mm wide bone defects created in the distal third of the femur with a surgical bur. Macroscopic analysis revealed the absence of pathological alterations in the implanted areas, suggesting that the material was biocompatible. Microscopic analysis showed a lower amount of bone ingrowth in the areas receiving the native membrane compared to the bone defects filled with the anionic membranes. In ovariectomized animals receiving anionic membranes, a delay in bone regeneration was observed mainly in animals not subjected to hormone replacement therapy. We conclude that anionic membranes treated with alkaline solution for 48 and 96 h presented better results in terms of bone ingrowth.

Collagen has been extensively described as a beneficial material in bone tissue engineering due to its biocompatibility, biodegradability, low antigenicity, and high tensile strength. However, collagen scaffolds in their pure form have some drawbacks and improvements in the physical, chemical, and biologic properties of collagen are necessary to overcome those inadequacies. Recently, the selective hydrolysis of carboxyamides of asparagine and glutamine residues of collagen has been employed to increase the number of negative sites and enhance the piezoelectric properties of collagen. Anionic collagen scaffolds were prepared by use of a hydrolysis treatment for either 24 h [bovine pericardium (BP 24)] or 48 h (BP 48). Bovine osteoblasts were cultured on them and on native matrices to understand the cellular interactions responsible for the good osteoconductivity and biocompatibility reported with in vivo tests. Based on the data obtained on cell adhesion, alkaline phosphatase (ALP) and extracellular matrix macromolecule production, and cellular proliferation through histological analysis, we may conclude that the materials tested reveal sufficient biocompatibility level for bone repair. Further, the evidence of some connection between ALP activity and the mineralization process should be emphasized. BP 48 presented the most promising results stimulating in vitro mineralization, ALP production, and possible osteoblast differentiation.

The aim of this work was to perform a systematic study about the effects induced by chitosan solution concentration and by chitin or glycerol incorporation on dense chitosan membranes with potential use as burn dressings. The membrane properties analyzed were total raw material cost, thickness, morphology, swelling ratio, tensile strength, percentage of strain at break, crystallinity, in vitro enzymatic degradation with lysozyme, and in vitro Vero cells adhesion. While the use of the most concentrated chitosan solution (2.5% w/w) increased membrane cost, it also improved the biomaterial mechanical resistance and ductility, as well as reduced membrane degradation when exposed for 2 months to lysozyme. The remaining evaluated properties were not affected by initial chitosan solution concentration. Chitin incorporation, on the other hand, reduced the membranes cost, swelling ratio, mechanical properties, and crystallinity, resulting in thicker biomaterials with irregular surface more easily degradable when exposed to lysozyme. Glycerol incorporation also reduced the membranes cost and crystallinity and increased membranes degradability after exposure to lysozyme. Strong Vero cells adhesion was not observed in any of the tested membrane formulations. The overall results indicate that the majority of the prepared membranes meet the performance requirements of temporary nonbiodegradable burn dressings (e.g. adequate values of mechanical resistance and ductility, low values of in vitro cellular adhesion on their surfaces, low extent of degradation when exposed to lysozyme solution, and high stability in aqueous solutions).

Cisplatin is an antineoplastic agent used to treat solid tumours, such as ovarian, testicular and bladder tumours. However, studies in vitro and in vivo have shown that cisplatin is mutagenic, genotoxic and tumorigenic in other tissues and organs. In this work, we examined the effect of cisplatin on Vero cells, a fibroblast-like cell line. The morphological characteristics were investigated using phase contrast microscopy, scanning electron microscopy and the actin cytoskeleton was labelled with fluorescein isothiocyanate-phalloidin. Cell proliferation was assessed based on the growth curve. Cultured Vero cells treated with cisplatin showed behavioural and morphological alterations associated with cellular transformation. The transformed cells grew in multilayers and formed cellular aggregates. The proliferation and morphological characteristics of the transformed cells were very different from those of control ones. Since transformed Vero cells showed several characteristics related to neoplastic growth, these cells could be a useful model for studying tumour cells in vitro.

The pattern of growth, adhesion and protein synthesis in Vero cells submitted to nutritional stress conditions was investigated. The control cells presented a characteristic pattern, with monolayer growth, while the stressed cells presented multilayered growth, with aggregate or spheroid formation which detached on the flask surface and continued their growth in another region. In the soft agar assay, with reduced amount of nutrients, only the stressed cells presented growth, indicating physical and nutritional independence. A 44-kDa protein was observed in stressed cells and was absent in non-stressed cells. The adhesion index and fibronectin synthesis and distribution were altered in stressed cells. After confluence, control cells presented fibronectin accumulation in lateral cell-cell contact regions, while this fibronectin accumulation pattern was not observed in stressed cells. These alterations may be responsible for the multilayered growth and decreased adhesion index observed in stressed cells which were transformed by nutritional stress conditions.

A human malignant continuous cell line, named NG97, was recently established in our laboratory. This cell line has been serially subcultured over 100 times in standard culture media presenting no sign of cell senescence. The NG97 cell line has a doubling time of about 24 h. Immunocytochemical analysis of glial markers demonstrated that cells are positive for glial fibrillary acidic protein (GFAP) and S-100 protein, and negative for vimentin. Under phase-contrast microscope, cultures of NG97 showed cells with variable morphological features, such as small rounded cells, fusiform cells (fibroblastic-like cells), and dendritic-like cells. However, at confluence just small rounded and fusiform cells can be observed. At scanning electron microscopy (SEM) small rounded cells showed heterogeneous microextentions, including blebs and filopodia. Dendritic-like cells were flat and presented extensive prolongations, making several contacts with small rounded cells, while fusiform cells presented their surfaces dominated by microvilli.We believe that the knowledge about NG97 cell line may be useful for a deeper understanding of biological and immunological characteristics of gliomas.

The biggest challenge to improve extracorporeal circulation (ECC) circuits lays on avoiding platelet adhesion to their surfaces, because this contributes to thrombus formation, resulting in the activation of blood coagulation. One approach to minimize this effect is to improve the biocompatibility of ECC circuits by modifying their surfaces. This can be achieved by coating them with heparin or phospholipids. The present study investigated the adhesion and morphology characteristics of fibroblastic and blood cells cultured on uncoated poly (vinyl) chloride PVC tubes as well as on heparin, phosphatidylcholine (DMPC), and phosphatidylethanolamine (DMPE) -coated tubing. The results showed the importance of uniform coating regardless of the substance used, because the coatings cover the grooves on PVC surfaces, which favor cell adhesion. The comparison among the three different coatings showed the best biocompatibility results for the PVC tubes coated with heparin, followed by the coating with DMPE and with DMPC. For all coated tubes, cells did not spread on the PVC surfaces and, consequently, did not adhere to their surfaces, increasing the overall biocompatibility of PVC tubes. However, possible DMPE's alkylation, caused by sterilization, resulted in increased material hydrophobicity, which explains the decrease in fibroblastic adhesion. Furthermore, sterilization of DMPC-PVC improves its hydrophilic character, also decreasing adhesion. Based on these results, coating PVC with the phospholipids DMPC and DMPE seems to be a promising technique to improve the biocompatibility of PVC tubes, and is worthy of further investigation.