Monoaromatic hydrocarbons including benzene, toluene, ethylbenzene and xylene isomers (BTEX) are a very important category of water pollutants. These volatile compounds are very hazardous because of their fast migration in soil and water bodies and their acute and chronic toxicities when inhaled or ingested, especially benzene which is a known carcinogenic molecule. In this study, a natural zeolite (i. e., clinoptilolite-rich tuffs) was modified by two cationic surfactants (i. e., hexadecyltrimethyl ammonium chloride (HDTMA-Cl), and N-cetylpyridinium bromide (CPB)). The prepared adsorbents were then characterized, and their adsorptive capabilities for BTEX examined at different experimental conditions. The results of adsorption tests at 24 h revealed that the adsorption capacity of the modified zeolites improved by increasing the surfactant loading (i. e., less than the critical micelle concentration (CMC), to higher than the CMC), which caused an increase in sorption capacity from 60 to 70% for HDTMA-modified samples, and from 47 to 99% for CPB-modified zeolite. Adsorption kinetic tests showed the optimum contact time was 48 h with an average BTEX removal of 90 and 93% for HDTMA-modified and CPB-modified zeolite, respectively. Results showed that by increasing of pH from 3 to 11, the sorption capacity of the adsorbent decreased markedly from 97 to 75%. Analyzing the influence of temperature showed that the adsorption efficiency of adsorbents for benzene reduced from 93% at 208C to 10% at 48C. However, the influence of temperature on other compounds was not remarkable. Overall, CPB-modified zeolite exhibited higher selectivity toward BTEX compounds at optimum experimental conditions. Although commercial powder activated carbon (PAC) showed a higher capacity for all BTEX compounds and faster adsorption kinetics, the adsorption capacity of the CPB-modified zeolite at optimized conditions was competitive with PAC results.

No abstract

A green synthesis approach was conducted to prepare amine-functionalized bio-graphene (AFBG) as an efficient and low cost adsorbent that can be obtained from agricultural wastes. In this study, bio-graphene was successfully used to remove Ciprofloxacin (CIP) from synthetic solutions. The efficacy of adsorbent as a function of operating variables (i.e. pH, time, AFBG dose and CIP concentration) was described by a polynomial model. A optimal99.3% experimental removal was achieved by adjusting the mixing time, AFBG dose, pH and CIP concentration to 58.16, 0.99, 7.47, and 52.9, respectively. Kinetic model revealed that CIP diffusion into the internal layers of AFBG controls the rate of the process. Furthermore, the sorption process was in monolayer with a maximum monolayer capacity of 172.6 mg/g. Adsorption also found to be favored under higher CIP concentrations. The thermodynamic parameters (ΔG˚<0, ΔH˚>0, and ΔS˚>0) demonstrated that the process is endothermic and spontaneous in nature. The regeneration study showed that the AFBG could simply regenerated without significant lost in adsorption capacity.

No abstract

No abstract

No abstract

No abstract

No abstract