In this paper, a new technology for meatball production is presented. The ingredients in the formulation used are low value parts of poultry meat (neck and back part), rice, sea cabbage (Laminaria) and carrot. Three variants of meatball were prepared with different weight ratios of Laminaria: variant 1 -15%, variant 2 -10% and variant 3 -5%. The comparative quality and Okuskhanova et al.; ARRB, 13(3): 1-9, 2017; Article no.ARRB.33337 2 organoleptic indicators of meatballs are studied. As a result, when compared with the control meatballs, the developed meatballs have soft consistency, a pleasant flavor, better sensory characteristics and balanced composition. The highest level of protein was obtained in variant 2 (19.7%) while the lowest one was determined in the control sample (10.1%). Variant 2 meatball also showed an increased level of mineral elements -3.11%, compared with variant 1 (2.6%) and variant 3 (1.6%). The moisture content of the developed meatballs varied from 67.1% to 69.3% and these values are much higher than in the control sample (61.64%). Also, the developed meatballs show a higher content of fat compared with the control sample. Different proportions of Laminaria in meatball formulations caused significant changes in content of I, Mg, K and Na. The concentrations of these elements were reduced when the Laminaria weight ratio in meatballs was lowered. Using Laminaria demonstrated a positive effect to the food quality of meatball. Original Research Article
This paper aimed to study the fatty acid composition of turkey meat. Red and white turkey meat were sampled from the local markets of Semey city, republic of Kazakhstan. The proximate composition showed a significant difference in the fat content of red and white meat. The fatty acid composition of turkey meat was as follows: saturated fatty acids 50.67% in white and 52.64% in red meat; monounsaturated fatty acids 28.07% in white and 23.79% in red meat; polyunsaturated fatty acids 21.26% in white and 23.57% in red meat. Palmitic and pentadecanoic are the major saturated fatty acids, where the oleic and linoleic acids are in a large amount in monounsaturated and polyunsaturated fatty acids, respectively.
This study was specifically designed for a small-scale meat processing enterprise “DARIYA” to set up a specific HACCP plan for the new product (patties) made from mixed horsemeat with vegetable components developed in the Department of Technology of Food Production and Biotechnology, Shakarim University of Semey. Critical control points (CCPs) were identified and applied in the HACCP plan. The different hazards were detected at each processing step, whereas each CCP in the HACCP plan was identified and accompanied with the appropriate significant hazard, critical limit, monitoring of the CCP, and corrective actions, confirming that the enterprise has fully employed the HACCP methodology and ISO 22000:2018. Our results indicate that during almost 1 year following the implementation of ISO 22000:2018, the coliform level of tested patties significantly dropped (p < 0.05) after 6 months of implementation (coliform count dropped from 4.4 MPN/g to 1.8 MPN/g). The rapid screening of the bacterial count, heavy metals, pesticide residue, and physical contamination levels also improved monitoring assertiveness, allowing them to deal with foreseeable issues linking to resources and guarantee product quality. Cesium-137 was recorded as 5.4 ± 2.9627 Bq/kg in horsemeat and 6.7 ± 2.7045 in poultry. The activity of cesium-137 did not exceed the MAC. This result discloses that prompt screening is the foremost and necessary step for small enterprises. According to this study, the “acceptance of raw materials” is the most important CCP, and their control, particularly in small-scale meat processing enterprises, can actually prevent many negative outcomes. The implementation of both standards improved food quality by declining the flaw rates for patties, and the number of flow inconsistencies needed for correction in the process also dropped significantly (p < 0.05), demonstrating that safety and quality points were improving. If the application of the HACCP plan were to continue over an extended period of time, the Food Safety Management System's (FSMS) benefits would be more substantial improvements to a greater number of items being monitored. The process of implementing HACCP principles and ISO 22000:2018 could be arduous but achievable enough to be used in small industries with significant outcomes.
Medicinal plants are one of the main sources of vitamins, minerals salts, macro-and microelements, and other biologically active substances that have a health and protective effect on the human body. The current study was aimed to appraise the heavy metals contents in the powder materials of two medicinally important plants Echinacea purpurea (L.) and Rhapónticum carthamoídes collected from the Semipalatinsk nuclear test site using atomic absorption spectrophotometer. Flavonoids, saponins, amino acid contents quantification were done both in raw materials as well as tincture prepared from both plants via GCMS-QP 2010 Ultra chromatomass spectrometer. Further, tannins concentrations and organoleptic properties of the tincture were elucidated using previously reported standard procedures. In the current study, the concentrations of heavy metals were within the permitted range i.e. lead (0.0027 mg.100g-1), cadmium (0.00012 mg.100g-1), arsenic (ND), mercury (ND). In the crude powder, flavonoids were observed to be in the highest concentration in E. purpurea (L.) (5.5 ±0.20 mg.100g-1), whereas, its concentration was 3.1 ±0.346 mg.100g-1 in R. carthamoídes powder. Tannin concentration was higher in R. carthamoídes (5.5 ±0.115 mg.100g-1) and 3.1 ±0.46 mg.100g-1 in E. purpurea. Likewise, saponins concentrations were 4.1 ±0.40 mg.100g-1 and 5.6 ±0.17 mg.100g-1 in E. purpurea and R. carthamoídes powder respectively. Concentrations of these active metabolites in the resultant tincture were flavonoids (7.6 ±0.23), tannins (7.5 ±0.28), and saponins (8.5 ±0.16) mg.100g-1. In the current study, we observed highest concentrations of these essential amino acids in the tincture including leucine/isoleucine (78.00 ±1.15 mg.100g-1), histidine (14.00 ±1.44 mg.100g-1), lysine (49.33 ±2.02 mg.100g-1), methionine (18.66 ±2.90 mg.100g-1), cystine (29.00 ±0.57 mg.100g-1), phenylalanine (24.16 ±1.87 mg.100g-1) and threonine (32.50 ±1.22 mg.100g-1) respectively. The resultant tincture has a pleasant agreeable taste coupled with acceptable herbal flavor which are important organoleptic properties for any product.
The article presents the results of the study of the nutritional value of meat cutlets from veal with the addition of cedar nut cake. The chemical and mineral composition of the cake obtained from the seeds of Siberian cedar growing on the territory of Eastern Kazakhstan has been determined. Four variants of cutlets with the addition of 0, 5, 10, and 15% of cedar cake are developed. The results of the analysis show that increasing the amount of cedar oil cake in the composition of meat semi-finished products increases the protein content (P<0.01) but at the same time the fat content in the experimental samples decreases (P<0.01) due to lower fat content in the veal meat. In terms of fatty-acid composition, the cutlets are characterized by high PUFA content (48.08%), followed by MUFA (29.46%) and SFA (22.46%). The developed cutlets are enriched with magnesium (100.4 mg/100 g) and calcium (75.3 mg/100 g), and iron content is 2.78 mg/100 g. The analysis of microstructure showed that cedar nut cake is evenly distributed among the muscle fibers in minced meat. The inclusion of cedar nut cake in the recipe for veal cutlets helps to improve the mineral, amino-acid, and fatty-acid composition and allows this product to be classified as a functional dietary product.
A technique is proposed for estimating the probability of the possible appearance of defective products (or the inconsistency of the production service) on the basis of the suitability and reproducibility indexes of the production process. The index of reproduction is recommended to be calculated on the basis of the standard deviation, which can be established by the average span of the control map and the limits of the tolerance field. At the same time, the production process must necessarily be in a state of statistical controllability. The suitability index can not be calculated on the basis of the control card characteristics, but is calculated solely on the basis of the total of the standard deviation, which is calculated on the basis of the Bessel formula and tolerance limits. The production process does not need to be statistically controllable. Conclusions on the suitability or insufficiency of the products (production services) are based on the value of the indexes of reproduction and suitability, which can take values less than or greater than one. On the basis of the obtained values of these indexes, the probability of production appearance or characteristics of the production process, that does not match the established requirements, is established.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.