[1] The spread of mineral particles over southwestern, western, and central Europe resulting from a strong Saharan dust outbreak in October 2001 was observed at 10 stations of the European Aerosol Research Lidar Network (EARLINET). For the first time, an optically dense desert dust plume over Europe was characterized coherently with high vertical resolution on a continental scale. The main layer was located above the boundary layer (above 1-km height above sea level (asl)) up to 3-5-km height, and traces of dust particles reached heights of 7-8 km. The particle optical depth typically ranged from 0.1 to 0.5 above 1-km height asl at the wavelength of 532 nm, and maximum values close to 0.8 were found over northern Germany. The lidar observations are in qualitative agreement with values of optical depth derived from Total Ozone Mapping Spectrometer (TOMS) data. Ten-day backward trajectories clearly indicated the Sahara as the source region of the particles and revealed that the dust layer observed, e.g., over Belsk, Poland, crossed the EARLINET site Aberystwyth, UK, and southern Scandinavia 24-48 hours before. Lidar-derived particle depolarization ratios, backscatter-and extinction-related Å ngström exponents, and extinction-to-backscatter ratios mainly ranged from 15 to 25%, À0.5 to 0.5, and 40-80 sr, respectively, within the lofted dust plumes. A few atmospheric model calculations are presented showing the dust concentration over Europe. The simulations were found to be consistent with the network observations.
In the framework of the European Aerosol Research Lidar Network to Establish an Aerosol Climatology (EARLINET), 19 aerosol lidar systems from 11 European countries were compared. Aerosol extinction or backscatter coefficient profiles were measured by at least two systems for each comparison. Aerosol extinction coefficients were derived from Raman lidar measurements in the UV (351 or 355 nm), and aerosol backscatter profiles were calculated from pure elastic backscatter measurements at 351 or 355, 532, or 1064 nm. The results were compared for height ranges with high and low aerosol content. Some systems were additionally compared with sunphotometers and starphotometers. Predefined maximum deviations were used for quality control of the results. Lidar systems with results outside those limits could not meet the quality assurance criterion. The algorithms for deriving aerosol backscatter profiles from elastic lidar measurements were tested separately, and the results are described in Part 2 of this series of papers [Appl. Opt. 43, 977-989 (2004)]. In the end, all systems were quality assured, although some had to be modified to improve their performance. Typical deviations between aerosol backscatter profiles were 10% in the planetary boundary layer and 0.1 x 10(-6) m(-1) sr(-1) in the free troposphere.
During the airborne CONTRACE field experiment carried out in November 2001 a number of polluted layers of North American (NA) origin were observed in the free troposphere over Europe. For the first time, forecasts from a Lagrangian particle dispersion model were used to predict the NA pollution events and to direct a research aircraft very precisely into these polluted layers above Europe. Two of the NA pollution events are investigated here: one in detail (case 19 November) and a second more briefly (case 22 November). An exceptional result was that the first pollution plume could be traced with the model and trace gas measurements (airborne and surface) for a period of one week, from the source region over the eastern United States to its decay over the Alps. On 14–15 November a warm conveyor belt lifted the leading edge of the pollution plume over the eastern United States to the mid troposphere where it remained during the transport over the Atlantic. On 19 November the plume was intersected with the research aircraft over Scandinavia at an altitude between 2 and 4 km. Elevated CO (170), O3 (53), NOy (1.1), acetone (5.0), and SO2 (2.6) mixing ratios (nmol/mol) were measured. A positive O3-CO correlation was observed in the plume. The observations indicate that the enhanced levels of ozone were already produced near the source region over the eastern United States and not during the transit. In the next days one branch of the plume then turned to the south and descended to ground level over the Alpine region. Elevated O3 (54 nmol mol 1) and CO (168 nmol/mol) were observed at the mountain site Zugspitze (southern Germany) during two days. At the Arosa Alpine site in Switzerland the highest daily ozone means of November 2001 were observed during this event
Abstract. For the first time, three different temperature lidar methods are combined to obtain time-resolved complete temperature profiles with high altitude resolution over an altitude range from the planetary boundary layer up to the lower thermosphere (about 1-105 km). The Leibniz-Institute of Atmospheric Physics (IAP) at Kühlungsborn, Germany (54 • N, 12 • E) operates two lidar instruments, using three different temperature measurement methods, optimized for three altitude ranges: (1) Probing the spectral Doppler broadening of the potassium D 1 resonance lines with a tunable narrow-band laser allows atmospheric temperature profiles to be determined at metal layer altitudes (80-105 km). (2) Between about 20 and 90 km, temperatures were calculated from Rayleigh backscattering by air molecules, where the upper start values for the calculation algorithm were taken from the potassium lidar results. Correction methods have been applied to account for, e.g. Rayleigh extinction or Mie scattering of aerosols below about 32 km. (3) At altitudes below about 25 km, backscattering in the Rotational Raman lines is strong enough to obtain temperatures by measuring the temperature dependent spectral shape of the Rotational Raman spectrum. This method works well down to about 1 km. The instrumental configurations of the IAP lidars were optimized for a 3-6 km overlap of the temperature profiles at the method transition altitudes. We present two night-long measurements with clear wave structures propagating from the lower stratosphere up to the lower thermosphere.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.