ResumoO objetivo do presente trabalho foi comparar o desdobro convencional e programado de toras de pínus em uma serraria de pequeno porte, tendo sido utilizados modelos de corte para diferentes classes diamétricas aplicadas em um programa de computador MaxiTora, visando a otimização no desdobro de toras. Para tal, foram selecionadas 80 toras de Pinus sp. com diâmetros que variaram de 24 a 33 cm, formando quatro classes diamétricas com 20 toras por classe. Em cada classe diamétrica, as toras foram separadas em dois lotes com 10 unidades, sendo um lote submetido ao desdobro aleatório e o outro lote submetido ao desdobro programado. Para o sistema de desdobro aleatório, os rendimentos obtidos em todas as classes diamétricas variaram de 44,96% a 52,47%, com a média geral correspondendo a 49,01%. No sistema de desdobro programado, os rendimentos obtidos variaram de 49,93% a 55,25% em todas as classes diamétricas estudadas e a média geral correspondeu a 52,14%. A classificação de toras e programação de cortes permitiram aumentar o rendimento da serraria em pelo menos três pontos percentuais. A programação de desdobro de toras resultou em aumento de rendimento em todas as classes diamétricas estudadas. Palavras-chave: Desdobro de toras; rendimento; otimização. AbstractYeld in lumber of Pinus sp. using cutting models in small sawmill. The objective of this research was to compare conventional and programmed cutting of logs pine at small sawmill. The models have been used for cutting different diametrical classes. The software MaxiTora was employed aiming to optimize logs cutting. For such, 80 logs of Pinus sp had been selected with diameters that varied from 24 cm to 33 cm, gathering four diametrical classes with 20 logs each. In each diametrical class, the logs had been separated in two lots of 10 units, then the first lot was submitted to random cutting and the second lot was submitted to programmed cutting. In relation to the random cutting system, the yield obtained in all the diametrical classes varied from 44.96% to 52.47%, and the general average corresponded to 49.01%. In relation to the programmed cutting system, the yield varied from 49.93% to 55.25% in all the diametrical classes studied, and the general average corresponded to 52.14%. Grading of logs and cutting schedule allowed to increase the sawmill efficiency in at least three percentage points. A programming sawing of logs resulted in increased yield in all diameter classes studied. Keywords: Cut of logs; yield; optimization. INTRODUÇÃOO pínus constitui uma das essências florestais mais utilizadas no Brasil na indústria de madeira processada mecanicamente. A região Sul do país concentra a maior parte dessas florestas, sendo os estados do Paraná e de Santa Catarina detentores da maior área plantada com o pínus (Associação Brasileira da Indústria de Madeira Processada Mecanicamente (ABIMCI), 2007).De acordo com Rocha (2002), o rendimento é um dos parâmetros que pode servir de base para os gestores da serraria avaliarem o seu desempenho, por revelar com r...
This study aimed to analyze the Brazilian competitiveness in the world market of the main non-timber forest products (NTFPs) exported by Brazil during the subperiods from 2006 to 2010, and from 2011 to 2016. The products were selected based on their relevance in the Brazilian NTFP export. In order to analyze competitiveness, we used the competitiveness matrix, which is given by the performance point of view. In the construction of this matrix, the vertical axis was represented by the Revealed Symmetric Comparative Advantage index while the horizontal axis was represented by the growth rate. The results showed that natural rubber was in the “missed opportunities” quadrant in the first period and in the “retreat” quadrant in the second period analyzed. On the other hand, honey, mate and cashew nut were positioned in the “optimum” sector in both periods, although cashew nut had showed a decrease both in the world growth rate and in the RSCA in the second period studied. In the final analysis, we concluded that Brazil is competitive in exports of honey and mate, it has been losing competitiveness in exports of cashew nuts, and is in decline as regards natural rubber exports.
ResumoEste trabalho objetivou verificar o impacto do custo da terra na rentabilidade da produção de madeira de Pinus. O setor florestal tem como característica fundamental gerar retornos financeiros em longo prazo, tornando muitas vezes o investimento na atividade um grande entrave a novos negócios. O preço da terra é uma variável que depende do retorno da atividade florestal, tornando necessário conhecer o efeito que o valor desse recurso terá sobre a rentabilidade. Para realizar uma estimativa da rentabilidade na atividade florestal, foram utilizados os critérios econômicos Valor Presente Líquido (VPL) e a Taxa de Interna de Retorno (TIR). Os resultados obtidos mostraram ser mais atrativa a não aquisição da terra, com VPL de US$ 5.584,00 e TIR de 18% ao ano. Já quando foi considerada a compra da terra, os resultados econômicos sofreram redução, com VPL de US$ 3.711,00 e TIR de 11% ao ano. A opção de arrendamento apresentou VPL de US$ 3.531,00 e TIR de 13% ao ano. Porém, antes de utilizar esses critérios como tomada de decisão, outros fatores devem ser avaliados, como o impacto da renda da reserva legal, melhor grau de utilização das terras e um manejo florestal adequado, visando aumentar a receita com a obtenção de novos produtos e maior produção das florestas.Palavras-chave: Rentabilidade econômica; preço da terra; manejo florestal; pínus. AbstractThe effect of land cost in the forest profitability: a case study for Santa Catarina. This research aimed to ascertain the impact of land cost land on profitability of Pinus spp. timber production. The forestry sector has as key feature to generate financial returns in the long term, often making the investment activity in a large barrier to new business. The price of land is a variable that depends on the return of forest activity, making it necessary to know the effect that the cost of this resource will have on profitability. In order to estimate return on forest activity, it uses economic criteria, like Net Present Value (NPV) and Internal Rate of Return (IRR). The results proved to be more attractive the non-acquisition of land, with NPV of US$ 5.5804,00 and IRR of 18% per year. Considering the investment in land (purchase or lease), the economic results have suffered reduction with NPV of US$ 3.711,00 and IRR of 11% per year. The lease of land presented a NPV of US$ 3.531,00 and IRR of 13% per year. But, before using such criteria as the only decision making, other factors must be evaluated as to obtain the income of the legal reserve, the better level of use of land and a proper forest management, aiming to increase revenue with the acquisition of new products and increased production of forests.Keywords: Economic profitability; land price; forest management; pinus.
ResumoEste estudo teve o objetivo de analisar a rentabilidade econômica do manejo de baixo impacto nas florestas tropicais em cenários distintos de investimento em terra e de produtividade da floresta. Os dados foram obtidos em uma fazenda situada no município de Marcelândia, estado do Mato Grosso, que explora a floresta tropical sob regime de manejo e comercializa as toras para indústrias da região. Os resultados demonstraram que a terra apresenta grande importância na rentabilidade do manejo. AbstractEconomic profitability of low impact management in Tropical forests: a case study. This paper had as objective to analyze economic viability of the management of low impact on tropical forests in different scenarios of investment in land and productivity of the forest. Data were obtained from a farm located in the municipality of Marcelândia, State of Mato Grosso, which harvests a tropical forest via RIL as a proxy to a sustainable forest management system and sells timber for wooden industries established in its region. The results showed that the land presents great importance in the profitability of management. Considering this investment, the Internal Rate of Return (IRR) ranged from 0,97% to 3,77%, well below the values of rate of Minimum to (MRI) of 12% per year. The Net Present Value (NPV) was very sensitive to the value of the land, ranging from R$ 10.993.508 to -R$ 43.139.242. The exclusion of the value of the land of the investment promoted a significant improvement in the IRR and NPV, demonstrating the impact that this feature is in the analysis of management project. When disregard the investment in land, the values of TIR ranged from 12,68% to 26,23% and the NPV ranged from R$ 210.240 to R$ 4.274.460. Keywords: Economic profitability; tropical forest; Forest management. INTRODUÇÃODurante as últimas décadas, observou-se um aumento da conscientização sobre o valor que os recursos naturais renováveis, principalmente as florestas, exercem sobre os seus habitantes. Tem-se percebido que os recursos são finitos, e se não forem criados mecanismos para o aproveitamento sustentável, a sociedade sofrerá conseqüências ambientais graves num futuro próximo.A necessidade da utilização racional dos recursos naturais fez aumentarem as pressões nacionais e internacionais sobre a floresta amazônica, sendo fundamental a utilização de mecanismos para o aproveitamento sustentável. Esse fato confere ao manejo florestal sustentado um importante instrumento para compatibilizar o desenvolvimento ambiental, social e econômico, que tem como objetivo manter a floresta em condições de abastecer a demanda das futuras gerações.
ResumoEste trabalho teve o objetivo de analisar a estrutura de custos de madeira serrada de Pinus taeda com duas metodologias de desdobro, denominadas de sistema convencional e sistema otimizado. Os diâmetros das toras variaram de 18 a 44 cm. Foram testadas 100 toras, sendo 50 toras divididas em cinco classes diamétricas para cada sistema de desdobro. Utilizando o sistema convencional de desdobro, verificou-se que os custos fixos representaram 12,03% do custo unitário de produção. Desses, os gastos com salários e encargos sociais foram os mais significativos, representando 9,22% do custo total unitário de produção, e por 76,61% dos custos fixos. O custo variável representou 87,97% do custo total unitário de produção, sendo que 84,64% foram relativos a aquisição de toras. Utilizando o sistema programado de desdobro das toras, a participação percentual do custo fixo aumentou para 14,87%, decorrente da queda ocorrida nos custos variáveis. A participação do custo variável unitário representou 85,13% do total dos custos unitários, apresentando uma redução de 3,23% em relação ao desdobro convencional. Com o desdobro programado, a redução no custo total foi de 5,12%. Palavras-chave: Pinus; classificação de toras; modelos de corte; otimização. AbstractIncome analysis costs in Pinus taeda sawn wood using two methodologies. This study aimed to examine the cost structure of Pinus taeda sawn wood using two methodologies of log sawing, called conventional and optimized systems. The logs diameter ranged from 18 to 44 cm. A total of 100 logs were tested, being 50 logs divided into five diameter classes for each sawing system tested. Using the conventional sawing method, the fixed costs accounted for 12.03% of the unit production cost. From these, wages and social charges accounted for 9.22% of the total unit production cost, and for 76.61% of the fixed costs. The variable cost represented 87.97% of the total unit production cost, and the logs acquisition accounted for 84.64% of the variable cost. Using the optimized sawing system, the percentage of fixed cost increased to 14.87%, due to the decrease in the variable costs. The participation of variable cost unit accounted for 85.13% of total the unit costs, showing a reduction of 3.23%, compared to the conventional sawing method. The reduction in the total cost using the optimized sawing method was 5.12%. Keywords: Pine; logs classification; sawn models; optimization. INTRODUÇÃOAo longo das últimas décadas, o perfil de consumo de madeiras oriundas de reflorestamento mudou substancialmente em função das restrições de exploração e da disponibilidade de espécies florestais nativas. A cadeia produtiva estendeu-se para as essências de rápido crescimento, plantadas e manejadas. A grande concentração de plantios de Pinus spp. encontra-se na região Sul do Brasil, especificamente nos estados do Paraná e Santa Catarina, onde as espécies mais plantadas são Pinus elliottii e Pinus taeda.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.