▪ Abstract  A liquid jet emanating from a nozzle into an ambient gas is inherently unstable. It may break up into drops of diameters comparable to the jet diameter or into droplets of diameters several orders of magnitude smaller. The sizes of the drops formed from a liquid jet without external control are in general not uniform. The sizes as well as the size distribution depend on the range of flow parameters in which the jet is produced. The jet breakup exhibits different characteristics in different regimes of the relevant flow parameters because of the different physical mechanisms involved. Some recent works based on linear stability theories aimed at the delineation of the different regimes and elucidation of the associated physical mechanisms are reviewed, with the intention of presenting current scientific knowledge on the subject. The unresolved scientific issues are pointed out.

A fuel reactivity controlled compression ignition (RCCI) concept is demonstrated as a promising method to achieve high efficiency – clean combustion. Engine experiments were performed in a heavy-duty test engine over a range of loads. Additionally, RCCI engine experiments were compared to conventional diesel engine experiments. Detailed computational fluid dynamics modelling was then used to explain the experimentally observed trends. Specifically, it was found that RCCI combustion is capable of operating over a wide range of engine loads with near zero levels of NOx and soot, acceptable pressure rise rate and ringing intensity, and very high indicated efficiency. For example, a peak gross indicated efficiency of 56 per cent was observed at 9.3 bar indicated mean effective pressure and 1300 rev/min. The comparison between RCCI and conventional diesel showed a reduction in NOx by three orders of magnitude, a reduction in soot by a factor of six, and an increase in gross indicated efficiency of 16.4 per cent (i.e. 7.9 per cent more of the fuel energy was converted to useful work). The simulation results showed that the improvement in fuel conversion efficiency was due both to reductions in heat transfer losses and improved control over the start- and end-of-combustion.

No abstract

No abstract

No abstract

No abstract

No abstract

No abstract