a b s t r a c tThroughout the year of 2004, 54 samples (1 L each) were collected from commercial sources in the Vale do Paraíba region (eastern portion of São Paulo State, Brazil). The concentrations of (Ca, Cr, Cu, Fe, Mg, Mn, Ni, Se, Zn, Cd and Pb) in these samples were analyzed by two atomic-absorption spectroscopy (AAS) methods. Ca, Cu, Fe, Mg and Zn were determined by flame atomic-absorption spectroscopy (FAAS) and (Cd, Cr, Mn, Ni, Pb and Se) were determined by electrothermal atomic-absorption spectroscopy (ETAAS). Tests to determine and quantify essential, nonessential and toxic elements present in bovine milk are rare in Brazil, especially so for Vale do Paraiba region. Tests were performed on standard NIST-certified milkpowder to validate the reliability of subsequently collected analytical data. Ca presented a lower recovery value (85.3%). The finding for Ca macro-nutrient was found to be below recommended international standards (1300 mg/L) for all samples possibly due to milk heterogeneity and losses in the pasteurization process. Significant results for Pb were found in all milk samples with average values at 0.230 mg/L from a minimum of 0.062 mg/L and maximum of 0.476 mg/L.

TRONCOSO, C.; PAVEZ, M.; SANTOS, A.; SALAZAR, R. & BARRIENTOS, L.Implicancias estructurales y fisiológicas de la célula bacteriana en los mecanismos de resistencia antibiótica. Int. J. Morphol., 35(4):1214Morphol., 35(4): -1223Morphol., 35(4): , 2017. RESUMEN: La alta capacidad de adaptación de las bacterias a ambientes hostiles ha permitido el desarrollo de resistencia a antibacterianos, causando problemas de impacto mundial en la salud hospitalaria y de la comunidad, limitando las opciones terapéuticas lo que afecta el control de enfermedades, elevando las tasas de morbi-mortalidad. Esta capacidad de resistencia es mediada por factores estructurales y fisiológicos de las bacterias que actúan a diferentes niveles tanto extracelular como intracelular. A niveles extracelulares se destaca la capacidad de las poblaciones bacterianas en la formación de biopelículas y la regulación de señales celulares quorum sensing, permitiendo la evasión de la acción antibiótica. A nivel de envoltura celular se destaca el funcionamiento y comportamiento de la pared celular y de la membrana celular, principalmente por medio de la regulación de la expresión de canales de entrada o porinas y/ o bombas de expulsión que impiden el acceso o inducen la salida de antibióticos; otros mecanismos integran la modificación de la actividad de drogas por medio de la hidrólisis o modificación del sitio activo del fármaco. A nivel intracelular, las bacterias pueden cambiar los procesos de óxido/reducción, modificar los sitios objetivos del antibiótico e inactivar los grupos transfer, y modificar las subunidades ribosomales afectando la acción de los antibióticos que inhiben la síntesis de proteínas. A esto se añaden las modificaciones en la expresión génica y del código genético, que regula todos los anteriores, y es capaz de generar cambios adaptativos, resistencia a fármacos y desinfectantes, entre otros. La presente revisión tiene como objetivo describir las implicancias estructurales y fisiológicas de la célula bacteriana en los mecanismos de resistencia antibiótica considerando la organización estructural y fisiológica involucrada en los principales mecanismos de resistencia a antibióticos presentes en bacterias de importancia clínica que conllevan a fallas terapéuticas con alto costo en salud humana.

The combined use of internal standardization with collision and reaction interface in an inductively coupled plasma quadrupole mass spectrometer (ICP-QMS-CRI) was evaluated. The behavior of several elements (Ba, Cd, Co, Cr, Cu, Li, Mn, Mo, Pb, Sb, V and Zn) was studied by introducing H(2) or He through the skimmer and sampler cones of the CRI device and by using In, Rh and Sc as internal standards. Certified reference material of trace elements in water (NIST 1643e) was used to evaluate the performance of the method. A vinegar sample and mixed food diet standard reference material were directly introduced into the equipment as complex matrices for Cr and V determinations. Improvements in accuracy and precision were attained combining both strategies. The introduction of H(2) through the skimmer cone was the best way to overcome polyatomic ions formation and to improve SBR and BEC values for several elements. The use of Sc as internal standard improved the performance of ICP-QMS-CRI.

This work evaluated the efficiency and systemic application of heterogeneous photocatalytic degradation for dairy wastewater under advanced oxidation process (AOP) utilizing solar radiation and immobilized ZnO as measured by total organic carbon (TOC). The AOP system consisted of a semibatch reactor and glass tank operated with an initial volume of 3 L of dairy wastewater. ZnO was immobilized on a metal plate of 800 × 250 mm and used as a catalyst bed. Evaporation rate was considered when effective degradation of the photocatalytic system was determined. The AOP utilized Taguchi's L 8 orthogonal array. The entry variables were pH, reaction time, initial organic load in the effluent, and ZnO coating thickness on the catalyst bed. When optimized, an effective TOC degradation of 14.23% was obtained under variable values of pH 8.0, a metal-plate coating of 100 micrometers (µm) ZnO, and total reaction time of 180 min.

Index-terms: trace elements, atomic absorption spectrometry, calcination, wet digestion, environmental pollution.(1) Presented in two works on the XI Geochemistry Brazilian Congress. Granted by Fapesp (processes 57382-6 e 05/53056-7

ZrO2 ceramics are one of the most important materials used in dental prostheses production, due to their excellent mechanical resistance and chemical inertness in the mouth environment. Nevertheless, the combination of low pHs and fluoride presence is able to reduce the chemical stability of these ceramics. In this work, the resistance of commercial blocks of micrometric and nanometric sized Y2O3-stabilized ZrO2 ceramics (ProtMat Materiais Avançados® and Ivoclar®) was evaluated in Fusayama artificial saliva of different pHs with (and without) the presence of fluoride ions. The study was based on the analysis of the amount of Zr4+ and Y3+ ions dissolved in the artificial saliva after different exposure times using ICP OES technique. The XRD technique was also employed to investigate the phase transformations occurring during the degradation process in artificial saliva. The micrometric sized ZrO2 ceramics presented higher resistance in the artificial saliva than nanometric sized structures.

No abstract

No abstract