A novel, green route for pre-exfoliation of graphite based on a biodegradable polymer and high-power ultrasound is presented. Candelilla wax (CW), derived from the leaves of the candelilla plant, has been used for the first time as a natural non aqueous medium to induce the pre-exfoliation of expanded graphite (EG) under ultrasonic irradiation in an economical way. The proposed method uses also D-limonene as a natural organic solvent for reducing viscosity and increasing the affinity between the polar groups of EG and candelilla wax, thus improving the intercalation/exfoliation of EG. The quality of dispersion of the nanofiller in the natural wax matrix has been evaluated using multiple techniques. The addition of EG to wax and use of ultrasonic treatment leads to a reduced crystallinity, probably due to restrictions of the molecular movements, improved thermal stability of wax, and to an increased shear thinning exponent, which are all indicative of a high degree of EG dispersion. The ultrasonic dynamic mechanical results suggest a reduction in the cluster size and a better filler dispersion in the wax matrix promoted by polar or chemical reactions between the CW fractions and the graphite stacks, which was observed by XPS analysis. The results were compared to those obtained with paraffin, a synthetic wax, and confirmed the dispersion improvement obtained by using natural wax as a pre-exfoliating medium.

Nanoparticles of the poly(methyl methacrylate-co-methacrylic acid) or copolymer of P(MMA-co-MAA), were prepared by semicontinuous heterophase polymerization; they show a mean diameter of 12 nm and a 1.75 MMA/MAA molar ratio determined by carbon-13 nuclear magnetic resonance. The content of MAA, greater than that of Eudragit S100, copolymer of P(MMA-co-MAA) accepted by the FDA for the preparation of tablets, ensures its biocompatibility and its metabolism without toxic effects. Loaded with up to 22 wt. % aspirin, that is, acetylsalicylic acid (ASA), these nanoparticles increase slightly their size, according to transmission electron microscopy; however, the presence of ASA on the nanoparticle surface decreases their stability, which leads to a certain aggregation of the particles in the dispersion. Fourier transform infrared spectrometry was used for demonstrating the loading of ASA in the nanoparticles.

Nanoparticles (NP) of 12.7 nm in diameter of the poly(methyl methacrylate (MMA)-co-methacrylic acid (MAA)) copolymer were prepared. 13 C-NMR results showed a MMA:MAA molar ratio of 0.64:0.36 in the copolymer, which is similar to the poly(MMA-co-MAA) commercially known as the FDA approved Eudragit S100 (0.67:0.33). The NP prepared in this study were loaded at pH 5 with varying amounts (from 0.54 to 6.91%) of doxorubicin (DOX), an antineoplastic drug. 1 H-NMR results indicated the electrostatic interactions between the ionized carboxylic groups of the MAA units in the copolymer and the proton of the glycosidic amine in DOX. Measurements by QLS and TEM indicated that the loading destabilizes the NP, and that for increase stability, they aggregate in a reversible way, forming aggregates with a diameter up to 99.5 nm at a DOX load of 6.91%. The analysis of drug release data at pH 7.4 showed that loaded NP with at least 4.38% DOX release the drug very slowly and follows the Higuchi model; the former suggests that they could remain for long periods in the bloodstream to reach and destroy cancer cells.

No abstract