READ THESE TERMS AND CONDITIONS CAREFULLY BEFORE USING THIS WEBSITE. https://nrc-publications.canada.ca/eng/copyright Vous avez des questions? Nous pouvons vous aider. Pour communiquer directement avec un auteur, consultez la première page de la revue dans laquelle son article a été publié afin de trouver ses coordonnées. Si vous n'arrivez pas à les repérer, communiquez avec nous à

No abstract

The extrusion foaming process involves several critical steps, in which the physical foaming agent plays a significant role: plasticization, solubility, nucleation and bubble growth. Although these aspects can be studied by different techniques, a novel method based on ultrasonic sensors has proven to provide valuable information with respect to the thermoplastic foaming process. This technique can be either used off-line as a characterization tool to improve our understanding of the foaming agent characteristics, or it can be installed in-line, on the extrusion line, as a control device. Review of the different applications of this technique will be covered in this paper, with numerous examples given to the mixture of PS with CO2. The degree of plasticization of the polymer as a function of the blowing agent concentration will be addressed first, followed by the detection of the conditions prone to induce nucleation, in terms of pressure, temperature, type of nucleating agents and flow conditions. The evaluation of the kinetics of bubble growth will also be explored.

READ THESE TERMS AND CONDITIONS CAREFULLY BEFORE USING THIS WEBSITE. https://nrc-publications.canada.ca/eng/copyright Vous avez des questions? Nous pouvons vous aider. Pour communiquer directement avec un auteur, consultez la première page de la revue dans laquelle son article a été publié afin de trouver ses coordonnées. Si vous n'arrivez pas à les repérer, communiquez avec nous à

Use of mixtures of blowing agents in thermoplastic foam extrusion has been an industrial practice for a long time. However, it has gained renewed interest in the past few years due to the introduction of difficult-to-process alternative gases, targeted as potential replacement for the banned ozone-depleting blowing agents. Reasons for blending physical foaming agents (PFA) are numerous. The incentives may be economical, environmental, or technical. With respect to that latter factor, blending suitable PFAs is often regarded as providing a better control of processing conditions. For example, a specific PFA could be selected for its inflation performance and blended with other co-blowing agents chosen for their stabilizing role. Although a considerable amount of work has been done in that area, very little information has been disclosed in open literature. Carbon dioxide (CO2) has been reported as an interesting candidate for low-density polystyrene (PS) foaming, although the required concentrations are associated with high processing pressures due to the low solubility of the gas. Thus, stable processing conditions are difficult to achieve. This work studies the effect of blending CO2 with ethanol (EtOH) as a co-blowing agent for PS foaming. Extrusion foaming performance of this mixture is discussed, with respect to its solubility (i.e., degassing conditions) and rheological behavior. The function of each blowing agent during the process is analyzed with respect to the plasticization, nucleation, expansion, and stabilization phases. Attention is also paid to the interaction involving the two PFA components.