No abstract

No abstract

This paper presents experimental results concerning the response of circular cylinders with and without strakes. The longitudinal and transverse fluid forces (drag and lift), amplitude response and wake structures of plain and helically straked cylinders are compared. Six different configurations of straked cylinders with pitches (p) equal to 5D, 10D and 15D and heights (h) equal to 0.1D and 0.2D are investigated. Measurements on the dynamic response oscillations of an isolated plain and straked cylinders and flow visualization employing a PIV system are shown. Fixed cylinder drag measurements are also shown. The models are mounted on an elastic base fitted with flexor blades and instrumented with strain gauges or in an air bearing base. The base is fixed on the test-section of a water channel facility. The flexor blades possess a low-damping and the flexor blades base an the air bearing base are free to oscillate only in the cross-flow direction. The Reynolds number of the experiments ranges from 2000 to 10000, and reduced velocities, based on natural frequency in still water, vary up to 13. The drag coefficient is increased by 20% for the h = 0.1D cylinder, and 60% for the h = 0.2D cylinder, comparing both with the plain cylinder. The smaller height strokes (h = 0.1D) do not prevent vortex formation in the region very close to the body, resulting in a decrease of about 50% of the amplitude response compared with the plain cylinder. Lowest amplitude response was found to the p = 10D and h = 0.2D case. The analysis of the vorticity contours shows that the shear layer does not roll close to the body (same result for the other cases with h = 0.2D).

In the last years, the most of offshore oil and gas reserves discoveries in Brazil are placed in ultra-deep water depths. Petroleum production from these offshore fields needs developments with novel solutions in terms of necessary technologies and economical viability. The use of vertical rigid risers such as top tensioned risers (TTR) and others like combined systems as self standing hybrid risers and steel catenary risers for ultra-deep waters have shown viable from both, technical and economical aspects. However, there are needs for detailed studies on their dynamic behavior in order to improve, particularly, the understanding of influence of the environment as wave and current, and floating platform oscillations at the riser top. The present work presents studies on vertical top tensioned riser dynamic behavior through time domain simulations of its displacements and respective, bending moments and stresses. Influences of the vortex induced vibrations (VIV) and waves on the riser service life reduction are analyzed. Maximum and minimum envelops for displacements and stresses along riser length are shown.

No abstract