equations proposed over the last decades by researchers. This estimation will occur in the municipality of Curitiba, using data from INMET's automatic station, located in the same city. The estimation was calculated hourly, throughout the day for one year. The validation of the estimated results was performed by measuring the cell temperature of a photovoltaic system installed in Curitiba, where it was observed that the equation proposed by Duffie and Beckman (2013) was the one that most approached to the measured value.
With the development of renewable energies in the world, there is also an increase in solar photovoltaic systems globally. In Brazil, and in the state of Paraná, there is an exponential growth of this form of energy generation, which causes the necessity to study the performance of the installed systems. Therefore, this article analyzed eight photovoltaic systems installed in the state of Paraná, under the aspect of figures of merit parameters, through calculations of final yield, performance ratio and capacity factor. In addition, the calculated values were compared to the values estimated by the Solar Energy Atlas of the State of Paraná. As a result, the largest average differences in final yield, between the calculations and the Atlas, were found in the cities of Cascavel, while the smallest were observed in Goioerê.
O aumento da responsabilidade ambiental tem conduzido a ações sustentáveis mundialmente, inclusive no Brasil. Neste sentido, há uma tendência no aumento de fontes renováveis na geração de eletricidade, com o intuito de descarbonizar a matriz elétrica. Um dos desafios está na crescente participação de fontes intermitentes na matriz elétrica, representadas pela geração eólica e solar. Estas fontes apresentam previsibilidade limitada na geração de energia ao longo do tempo, dependendo de condições meteorológicas locais. A energia renovável gerada pode ter que ser reduzida para manter o equilíbrio entre carga e geração. Deste modo, uma prática comum adotada globalmente é o corte na geração de energia renovável. Esta ação é chamada de curtailment. Este artigo abordará este tema, analisando seus motivos e expondo algumas soluções propostas na literatura. No Brasil, o corte na geração de eletricidade é mais frequente em hidrelétricas. Entre os desafios para a redução deste corte, estão o investimento na expansão da rede de transmissão, o gerenciamento eficiente do despacho de energia e sistemas de armazenamento. Portanto, com o aumento da capacidade instalada em usinas eólica e solar, estudar e analisar estratégias a fim de reduzir o curtailment mostram-se extremamente relevantes, de forma que haja um maior aproveitamento da energia gerada através de fontes renováveis, contribuindo com a segurança da rede.
This paper presents a novel methodology for planning and operating biogas energy systems based on the transactive energy concept to determine multilevel operating regimes for distributed generation. The developed model is used to manage the production, storage, and dispatch of biogas energy systems to meet the load demands of the biogas producer and support the operation of the distribution network operator. An Integer Linear Programming (ILP) is fitted to optimize the biogas production of the biogas producer, including the operation of the biogas storage systems and their interaction with the network operator. The model’s objective is to maximize benefits for the participating agents in a transactive energy context. The model’s effectiveness is validated using seven case studies involving biogas systems having different operating ranges and modes to achieve enhanced flexibility and reliability for the system operation with a large proportion of intermittent energy resources. The simulation results showed that the approach could effectively manage the operation of biogas systems and their interaction with the network operator. The developed model is suitable for systems fostering net metering charging and real-time pricing.
O fator de dimensionamento do inversor (FDI) consiste na relação entre a potência do inversor e a potência dos módulos em condições padrão de ensaio. Com a finalidade de verificar a influência do FDI na produção de energia, foram analisadas, a potência de saída nos momentos de limitação dos inversores bem como a irradiância e produtividade de energia no período de janeiro a agosto de 2020 em sistemas fotovoltaicos conectados à rede elétrica compostos por filmes finos (CdTe e CIGS) localizadas em Curitiba, Ponta Grossa, Campo Mourão e Medianeira, no Paraná. Para o inversor no qual estão conectados os módulos de CdTe, o FDI foi igual a 0,98, enquanto para o inversor no qual estão conectados os módulos de CIGS o FDI foi de 0,89, onde foi observado limitação de geração em momentos de elevada irradiância, entretanto, foram os que mais geraram energia no período analisado.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.