We investigate a large geodetic data set of interferometric synthetic aperture radar (InSAR) and GPS measurements to determine the source parameters for the three main shocks of the 2016 Central Italy earthquake sequence on 24 August and 26 and 30 October (Mw 6.1, 5.9, and 6.5, respectively). Our preferred model is consistent with the activation of four main coseismic asperities belonging to the SW dipping normal fault system associated with the Mount Gorzano‐Mount Vettore‐Mount Bove alignment. Additional slip, equivalent to a Mw ~ 6.1–6.2 earthquake, on a secondary (1) NE dipping antithetic fault and/or (2) on a WNW dipping low‐angle fault in the hanging wall of the main system is required to better reproduce the complex deformation pattern associated with the greatest seismic event (the Mw 6.5 earthquake). The recognition of ancillary faults involved in the sequence suggests a complex interaction in the activated crustal volume between the main normal faults and the secondary structures and a partitioning of strain release.

We investigate the ground deformation and source geometry of the 2016 Amatrice earthquake (Central Italy) by exploiting ALOS2 and Sentinel‐1 coseismic differential interferometric synthetic aperture radar (DInSAR) measurements. They reveal two NNW‐SSE striking surface deformation lobes, which could be the effect of two distinct faults or the rupture propagation of a single fault. We examine both cases through a single and a double dislocation planar source. Subsequently, we extend our analysis by applying a 3‐D finite elements approach jointly exploiting DInSAR measurements and an independent, structurally constrained, 3‐D fault model. This model is based on a double fault system including the two northern Gorzano and Redentore‐Vettoretto faults (NGF and RVF) which merge into a single WSW dipping fault surface at the hypocentral depth (8 km). The retrieved best fit coseismic surface deformation pattern well supports the exploited structural model. The maximum displacements occur at 5–7 km depth, reaching 90 cm on the RVF footwall and 80 cm on the NGF hanging wall. The von Mises stress field confirms the retrieved seismogenic scenario.

We found the first evidence, in the last 30 years, of a renewed magmatic activity at Campi Flegrei caldera from January 2012 to June 2013. The ground deformation, observed through satellite interferometry and GPS measurements, have been interpreted as the effect of the intrusion at shallow depth (3090 ± 138 m) of 0.0042 ± 0.0002 km3 of magma within a sill. This interrupts about 28 years of dominant hydrothermal activity and occurs in the context of an unrest phase which began in 2005 and within a more general ground uplift that goes on since 1950. This discovery has implications on the evaluation of the volcanic risk and in the volcanic surveillance of this densely populated area.

We provide new insights into the two main seismic events that occurred in 2012 in the Emilia region, Italy. We extend the results from previous studies based on analytical inversion modeling of GPS and RADARSAT‐1 InSAR measurements by exploiting RADARSAT‐2 data. Moreover, we benefit from the available large amount of geological and geophysical information through finite element method (FEM) modeling implemented in a structural‐mechanical context to investigate the impact of known buried structures on the modulation of the ground deformation field. We find that the displacement pattern associated with the 20 May event is consistent with the activation of a single fault segment of the inner Ferrara thrust, in good agreement with the analytical solution. In contrast, the interpretation of the 29 May episode requires the activation of three different fault segments and a block roto‐translation of the Mirandola anticline. The proposed FEM‐based methodology is applicable to other seismic areas where the complexity of buried structures is known and plays a fundamental role in the modulation of the associated surface deformation pattern.

We investigate the 24–27 December 2018 eruption of Mount Etna occurred from fissures located on the volcano eastern flank and accompanied by a seismic swarm, which was triggered by the magma intrusion and continued for weeks after the end of the eruption. Moreover, this swarm involved some of the shallow volcano‐tectonic structures located on the Mount Etna flanks and culminated on 26 December with the strongest event (ML 4.8), occurred along the Fiandaca Fault. In this work, we analyze seismological data and Sentinel‐1 Differential Interferometric Synthetic Aperture Radar (DInSAR) measurements, the latter inverted through analytical modeling. Our results suggest that a dike source intruded, promoting the opening of the eruptive fissures fed by a shallower dike. Moreover, our findings indicate that the activation of faults in different sectors of the volcano may be considered as a response to accommodate the deformations induced by the magma volumes injection.

No abstract

The causative source of the first damaging earthquake instrumentally recorded in the Island of Ischia, occurred on 21 August 2017, has been studied through a multiparametric geophysical approach. In order to investigate the source geometry and kinematics we exploit seismological, Global Positioning System, and Sentinel‐1 and COSMO‐SkyMed differential interferometric synthetic aperture radar coseismic measurements. Our results indicate that the retrieved solutions from the geodetic data modeling and the seismological data are plausible; in particular, the best fit solution consists of an E‐W striking, south dipping normal fault, with its center located at a depth of 800 m. Moreover, the retrieved causative fault is consistent with the rheological stratification of the crust in this zone. This study allows us to improve the knowledge of the volcano‐tectonic processes occurring on the Island, which is crucial for a better assessment of the seismic risk in the area.

We studied the Yellowstone caldera geological unrest between 1977 and 2010 by investigating temporal changes in differential Interferometric Synthetic Aperture Radar (InSAR), precise spirit leveling and gravity measurements. The analysis of the 1992-2010 displacement time series, retrieved by applying the SBAS InSAR technique, allowed the identification of three areas of deformation: (i) the Mallard Lake (ML) and Sour Creek (SC) resurgent domes, (ii) a region close to the Northern Caldera Rim (NCR), and (iii) the eastern Snake River Plain (SRP). While the eastern SRP shows a signal related to tectonic deformation, the other two regions are influenced by the caldera unrest. We removed the tectonic signal from the InSAR displacements, and we modeled the InSAR, leveling, and gravity measurements to retrieve the best fitting source parameters. Our findings confirmed the existence of different distinct sources, beneath the brittle-ductile transition zone, which have been intermittently active during the last three decades. Moreover, we interpreted our results in the light of existing seismic tomography studies. Concerning the SC dome, we highlighted the role of hydrothermal fluids as the driving force behind the 1977-1983 uplift; since 1983-1993 the deformation source transformed into a deeper one with a higher magmatic component. Furthermore, our results support the magmatic nature of the deformation source beneath ML dome for the overall investigated period. Finally, the uplift at NCR is interpreted as magma accumulation, while its subsidence could either be the result of fluids migration outside the caldera or the gravitational adjustment of the source from a spherical to a sill-like geometry.