No abstract

No abstract

In this study a simple and rapid sample preparation technique, homogeneous liquid-liquid extraction based on phase separation in the presence of a salt performed in a narrow-bore tube, followed by GC-flame ionization detection has been developed. In this work, sodium chloride and ACN were used as the salting-out agent and water-soluble extraction solvent, respectively. The homogeneous solution of water and ACN was broken by addition of the salt. Small volume of ACN was collected on top of the tube and the extracted analytes in the collected phase were determined. It has been successfully used for the analysis of five phthalate esters as model compounds in aqueous sample. Experimental parameters affecting the extraction efficiency such as kind and volume of the water-soluble organic solvent, length and diameter of the tube, and pH of the sample solution were investigated. Under the optimal conditions, the LODs were between 0.02 and 0.7 μg/L and enrichment factors were in the range of 172-309. In addition, good linearity (between 1 and 5000 μg/L) and high precision on the base of RSD (<8%, C = 600 μg/L, n = 6) were achieved.

No abstract

No abstract

A simultaneous derivatization/air-assisted liquid-liquid microextraction technique has been developed for the sample pretreatment of some parabens in aqueous samples. The analytes were derivatized and extracted simultaneously by a fast reaction/extraction with butylchloroformate (derivatization agent/extraction solvent) from the aqueous samples and then analyzed by GC with flame ionization detection. The effect of catalyst type and volume, derivatization agent/extraction solvent volume, ionic strength of aqueous solution, pH, numbers of extraction, aqueous sample volume, etc. on the method efficiency was investigated. Calibration graphs were linear in the range of 2-5000 μg/L with squared correlation coefficients >0.990. Enhancement factors and enrichment factors ranged from 1535 to 1941 and 268 to 343, respectively. Detection limits were obtained in the range of 0.41-0.62 μg/L. The RSDs for the extraction and determination of 250 μg/L of each paraben were <4.9% (n = 6). In this method, the derivatization agent and extraction solvent were the same and there is no need for a dispersive solvent, which is common in a traditional dispersive liquid-liquid microextraction technique. Furthermore, the sample preparation time is very short.

No abstract

No abstract