No abstract

No abstract

High-speed machine tools have parts with both stationary and rotating dynamics. While spindle housing, column, and table have stationary dynamics, rotating parts may have both symmetric (i.e., spindle shaft and tool holder) and asymmetric dynamics (i.e., two-fluted end mill) due to uneven geometry in two principal directions. This paper presents a stability model of dynamic milling operations with combined stationary and rotating dynamics. The stationary modes are superposed to two orthogonal directions in rotating frame by considering the time- and speed-dependent, periodic dynamic milling system. The stability of the system is solved in both frequency and semidiscrete time domain. It is shown that the stability pockets differ significantly when the rotating dynamics of the asymmetric tools are considered. The proposed stability model has been experimentally validated in high-speed milling of an aluminum alloy with a two-fluted, asymmetric helical end mill.

No abstract

Chatter is one of the major problems in machining and can be avoided by stability diagrams which are generated using frequency response functions (FRF) at the tool tip. During cutting operations, discrepancies between the stability diagrams obtained by using FRFs measured at the idle state and the actual stability of the process are frequently observed. These deviations can be attributed to the changes of machine dynamics under cutting conditions. In this paper, the effects of the cutting process on the spindle dynamics are investigated both experimentally and analytically. The variations in the spindle dynamics are attributed to the changes in the bearing parameters. FRFs under cutting conditions are obtained through the input-output relations of the cutting forces and the vibration response which are measured simultaneously. Experimentally and analytically obtained FRFs are then used in the identification of the bearing parameters under cutting conditions. Thus, bearing properties obtained at idle and cutting conditions are compared and variations in their values are obtained.

No abstract

No abstract

No abstract