The online version of the original article can be found at http:// dx

Yield limitation and widespread sulphur (S) deficiency in pearl-millet-nurturing dryland soils has emerged as a serious threat to crop productivity and quality. Among diverse pathways to tackle moisture and nutrient stress in rainfed ecologies, conservation agriculture (CA) and foliar nutrition have the greatest potential due to their economic and environmentally friendly nature. Therefore, to understand ammonium thiosulphate (ATS)-mediated foliar S nutrition effects on yield, protein content, mineral biofortification, and sulphur economy of rainfed pearl millet under diverse crop establishment systems, a field study was undertaken. The results highlighted that pearl millet grain and protein yield was significantly higher under no-tillage +3 t/ha crop residue mulching (NTCRM) as compared to no-tillage without mulch (NoTill) and conventional tillage (ConvTill), whereas the stover yield under NTCRM and ConvTill remained at par. Likewise, grain and stover yield in foliar S application using ATS 10 mL/L_twice was 19.5% and 13.2% greater over no S application. The sulphur management strategy of foliar-applied ATS 10 mL/L_twice resulted in significant improvement in grain protein content, protein yield, micronutrient fortification, and net returns (₹ 54.6 × 1000) over the control. Overall, ATS-mediated foliar S nutrition can be an alternate pathway to S management in pearl millet for yield enhancement, micronutrient biofortification and grain protein content increase under ConvTill, as well as under the new NTCRM systems.

Pearl millet is a climate-resilient, nutritious crop with low input requirements that could provide economic returns in marginal agro-ecologies. In this study, we report quantitative trait loci (QTLs) for iron (Fe) and zinc (Zn) content from three distinct production environments. We generated a genetic linkage map using 210 F6 recombinant inbred line (RIL) population derived from the (PPMI 683 × PPMI 627) cross using genome-wide simple sequence repeats (SSRs). The molecular linkage map (seven linkage groups) of 151 loci was 3,273.1 cM length (Kosambi). The content of grain Fe in the RIL population ranged between 36 and 114 mg/Kg, and that of Zn from 20 to 106 mg/Kg across the 3 years (2014–2016) at over the three locations (Delhi, Dharwad, and Jodhpur). QTL analysis revealed a total of 22 QTLs for grain Fe and Zn, of which 14 were for Fe and eight were for Zn on three consecutive years at all locations. The observed phenotypic variance (R2) explained by different QTLs for grain Fe and Zn content ranged from 2.85 (QGFe.E3.2014–2016_Q3) to 19.66% (QGFe.E1.2014–2016_Q3) and from 2.93 (QGZn.E3.2014–2016_Q3) to 25. 95% (QGZn.E1.2014–2016_Q1), respectively. Two constitutive expressing QTLs for both Fe and Zn co-mapped in this population, one on LG 2 and second one on LG 3. Inside the QTLs candidate genes such as Ferritin gene, Al3+ Transporter, K+ Transporters, Zn2+ transporters and Mg2+ transporters were identified using bioinformatics approaches. The identified QTLs and candidate genes could be useful in pearl millet population improvement programs, seed, restorer parents, and marker-assisted selection programs.

An attempt was made to compare between easy and inexpensive qualitative method (ammonia vapour test) and analytical methods (thin layer chromatography and enzyme-linked immunosorbent assay) for identification of aflatoxigenic isolates of Aspergillus flavus in maize. In this comparative study the toxicity level of A. flavus isolates exhibited 100% agreement among ammonia vapour test, ELISA and TLC for highly toxigenic (>2000 ppb) and toxigenic (501–2000 ppb) isolates while 88.5% agreement observed for least toxic (<20 ppb) isolates. In ammonia vapour test 51% of A. flavus isolates showed creamish or no colour change corresponding to least toxic/atoxic (<20ppb) category estimated by ELISA. Similarly 22% highly toxic isolates exhibited plum red colour, 12% moderately toxic indicated pink colour and 10% toxic isolates showed red colour. However, 11.5% isolates were found to be false positive in cream colour category (least toxic) and 28.5% false negatives in pink colour (moderately toxic) category. The isolates from different agroclimatic zones of maize in India showed high variability for aflatoxin B1 (AFB1) production potential ranging from 0.214–8116.61 ppb. Toxigenic potential of Aspergillus flavus isolates in culture was further validated by inoculating maize grain sample with four different isolates with varied toxin producing ability. With good agreement percentage between cultural and analytical methods the study concludes the ammonia vapour test to be easy, inexpensive reliable and time saving method that can be used for segregating or pre-screening of contaminated samples from bulk food/feed stock.

No abstract

No abstract

Once thought to be a minor disease, foliar blast disease of pearl millet, caused by Magnaporthe grisea, has recently emerged as an important biotic constraint for pearl millet production in India. The presence of a wider host range as well as high pathogenic heterogeneity complicates host–pathogen dynamics. Furthermore, environmental factors play a significant role in exacerbating the disease severity. An attempt was made to unravel the genotype-by-environment interactions for identification and validation of stable resistant genotypes against foliar blast disease through multi-environment testing. A diversity panel consisting of 250 accessions collected from over 20 different countries was screened under natural epiphytotic conditions in five environments. A total of 43 resistant genotypes were found to have high and stable resistance. Interestingly, most of the resistant lines were late maturing. Combined ANOVA of these 250 genotypes exhibited significant genotype-by-environment interaction and indicated the involvement of crossover interaction with a consistent genotypic response. This justifies the necessity of multi-year and multi-location testing. The first two principal components (PCs) accounted for 44.85 and 29.22% of the total variance in the environment-centered blast scoring results. Heritability-adjusted genotype plus genotype × environment interaction (HA-GGE) biplot aptly identified “IP 11353” and “IP 22423, IP 7910 and IP 7941” as “ideal” and “desirable” genotypes, respectively, having stable resistance and genetic buffering capacity against this disease. Bootstrapping at a 95% confidence interval validated the recommendations of genotypes. Therefore, these genotypes can be used in future resistance breeding programs in pearl millet. Mega-environment delineation and desirability index suggested Jaipur as the ideal environment for precise testing of material against the disease and will increase proper resource optimization in future breeding programs. Information obtained in current study will be further used for genome-wide association mapping of foliar blast disease in pearl millet.

Biofortification of pearl millet (Pennisetum glaucum (L.) R. Br.) with improved iron (Fe) and zinc (Zn) will have great impact as it is an indispensable component of nutritional security of inhabitants of arid and semi-arid regions. Ten genotypes along with checks were evaluated in RBD in six locations during kharif, 2016 under rainfed conditions. Significant differences were observed in genotype, environment and genotype × environment interaction mean squares for grain Fe and Zn contents, indicating differential nutrient accumulation by the genotypes. The first two principal components obtained in AMMI analysis were significant and cumulatively explained the total variation were 81.47 % for Fe and 73.97 % for Zn. A positive and moderately high correlation (r=0.6) between Fe and Zn contents suggests good prospects of simultaneous improvement for both micronutrients. Among the ten genotypes, PPMI 953 was found to be more stable with high mean Fe (90 ppm) and Zn (59 ppm) contents. On crossing with designated A lines of pearl millet, the line PPMI 953 found to be restorer for A1 system with complete fertility restoration of F1 panicle of the cross, ICMA(1) 863 x PPMI 953 under bagged condition and resulting F1 with 78-84% fertility measured by seed setting % under bag. The F2 individuals showed 9:7 fertility-sterility ratio (χ 2 value=0.002, P value=0.964). The promising line, PPMI 953 may be used as source for further genetic improvement with respect to grain micronutrient content or can be directly used as male parent in development of high iron pearl millet hybrids.