Operative treatment of sacral insufficiency fractures is frequently being complicated by osteopenic bone properties. Cement augmentation of implanted sacroiliac screws may lead to superior construct stability and prevent mechanical complications. A novel hemi-pelvis test model with dissected symphysis was developed. Five fresh-frozen cadaveric pelvises were vertically osteotomized at the sacrum on both sides and fixed with sacroiliac screws in both corridors of the first sacral vertebral body. One side was randomly augmented with bone cement. Cyclic testing consisting of torsional loading (±2.5 Nm) combined with progressively increasing axial loading (+50 N compression, -10 N traction, ±0,01 N/cycle) was performed until failure; simulated physiological loads derived from inverse dynamic calculations. The fixation was analyzed fluoroscopically quantifying screw migrations and assessing failure mechanisms. Failure modes were cut-out, pull-out, screw-out, and washer penetration. Motion at fracture site was analyzed via optical motion tracking. Unscrewing was provoked four times with non-augmented and twice with augmented screws. When focusing on the sacral region only, cement augmentation significantly improved screw fixation in terms of increased number of cycles to failure (p = 0.043). However, when considering overall construct stability, there was no significant difference between augmented and non-augmented state due to washer penetration at the iliac bone. The generated hemi-pelvis model was found to be valid due to the reproduction of the clinically observed failure mode (unscrewing). Unscrewing was not fully prevented by cement augmentation. Augmentation effects stability at the screw tip, but particularly in porotic bone, failure may shift to the next weak point. © 2016 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 35:1485-1493, 2017.

No abstract

Augmentation of a patellar tendon repair with either a cable wire or a PDS cord provides higher primary stability than suture anchor repair in patellar tendon ruptures. The study supports the use of additional augmentation of a tendon repair in the clinical setting in order to prevent loss of reduction and allow for early post-operative mobilisation.

Periprosthetic hip fractures are an increasing problem in modern orthopedic and trauma surgery. Many options for the operative treatment are available to the surgeon ranging from modern variable angular systems to standard plates, screws, and cerclages. However, there is no gold standard and therefore, the aim of this study, was to investigate the biomechanical characteristics of double plating versus a lateral standard plate in a Vancouver B1 fracture model. Ten 4th generation composite femora were used to implant cementless total hip prosthesis and create Vancouver B1 periprosthetic fractures. Afterwards, the osteotomies were fixed using the locking compression plate in combination with the locking attachment plate (LCP, LAP, DePuy Synthes, Solothurn, Switzerland)-group I. Group II additionally achieved a 5-hole 4.5/5.0 mm LCP anteriorly. Each construct was cyclically loaded to failure in axial compression. Axial construct stiffness was 50.87 N/mm (SD 1.61) for group I compared to 738.68 N/mm (SD 94.8) for group II, this difference was statistically significant (p = 0.016). The number of cycles to failure was also significant higher for group II (2,375 vs. 13,000 cycles; p = 0.016). Double plating can significantly increase construct stiffness and stability, and thus, is an option in the treatment of complex periprosthetic fractures, in revision surgery and for patients with the inability to partial weight bear. © 2016 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 35:234-239, 2017.