No abstract

Zinc oxide (ZnO) nanorods were grown on a paper support prepared from soft wood pulp. The photocatalytic activity of a sheet of paper with ZnO nanorods embedded in its porous matrix has been studied. ZnO nanorods were firmly attached to cellulose fibers and the photocatalytic paper samples were reused several times with nominal decrease in efficiency. Photodegradation of up to 93% was observed for methylene blue in the presence of paper filled with ZnO nanorods upon irradiation with visible light at 963 Wm -2 for 120 min. Under similar conditions, photodegradation of approximately 35% was observed for methyl orange. Antibacterial tests revealed that the photocatalytic paper inhibits the growth of Escherichia coli under room lighting conditions.

The most important component for living beings on the earth is access to clean and safe drinking water. Globally, water scarcity is pervasive even in water-rich areas as immense pressure has been created by the burgeoning human population, industrialization, civilization, environmental changes and agricultural activities. The problem of access to safe water is inevitable and requires tremendous research to devise new, cheaper technologies for purification of water, while taking into account energy requirements and environmental impact. This review highlights nanotechnology-based water treatment technologies being developed and used to improve desalination of sea and brackish water, safe reuse of wastewater, disinfection and decontamination of water, i.e., biosorption and nanoadsorption for contaminant removal, nanophotocatalysis for chemical degradation of contaminants, nanosensors for contaminant detection, different membrane technologies including reverse osmosis, nanofiltration, ultrafiltration, electro-dialysis etc. This review also deals with the fate and transport of engineered nanomaterials in water and wastewater treatment systems along with the risks associated with nanomaterials.

Plant-derived cellulosic materials play a critical role when organic wastes are composted to produce a beneficial amendment for topsoil. This review article considers publications dealing with the science of composting, emphasizing ways in which the cellulosic and lignin components of the composted material influence both the process and the product. Cellulose has been described as a main source of energy to drive the biological transformations and the consequent temperature rise and chemical changes that are associated with composting. Lignin can be viewed as a main starting material for the formation of humus, the recalcitrant organic matter that provides the water-holding, ion exchange, and bulking capabilities that can contribute greatly to soil health and productivity. Lignocellulosic materials also contribute to air permeability, bulking, and water retention during the composting process. Critical variables for successful composting include the ratio of carbon to nitrogen, the nature of the cellulosic component, particle size, bed size and format, moisture, pH, aeration, temperature, and time. Composting can help to address solid waste problems and provides a sustainable way to enhance soil fertility.

No abstract

No abstract

No abstract

Synthetic filters are neither biodegradable nor produced from renewable sources. Thus, their disposal has serious environmental impacts. There is a growing desire to produce filters from cellulosic fibers that are renewable, biodegradable, cheap and most importantly recyclable if the contamination is removed. Foam-laid process in papermaking is a promising process for the production of specialty papers. Filters produced using this process are capable of providing products with high specific surface area and tortuous structure favorable for entrapping particulate matters, while providing excellent permeability for incoming gas or liquid. Although the end product fulfills completely the requirement of a filter in a dry environment, it fails completely if it is exposed to a moist environment. This work reports on converting the hydrophilic cellulosic filter into a hydrophobic product without disturbing its original structure.