Dental resin composites have been widely used in a variety of direct and indirect dental restorations due to their aesthetic properties compared to amalgams and similar metals. Despite the fact that dental resin composites can contribute similar mechanical properties, they are more likely to have microbial accumulations leading to secondary caries. Therefore, the effective and long-lasting antimicrobial properties of dental resin composites are of great significance to their clinical applications. The approaches of ascribing antimicrobial properties to the resin composites may be divided into two types: The filler-type and the resin-type. In this review, the resin-type approaches were highlighted. Focusing on the antimicrobial polymers used in dental resin composites, their chemical structures, mechanical properties, antimicrobial effectiveness, releasing profile, and biocompatibility were included, and challenges, as well as future perspectives, were also discussed.
In this paper, the effect of a low constant current stress (CCS) treatment on the performance of a Cu/ZrO 2 /Pt resistive switching device is investigated. The conductance of the device increases about two orders of magnitude after CCS treatment, indicating that some defects are introduced into the ZrO 2 matrix and the CCS treatment can be regarded as an electrical doping process. Benefiting from these introduced defects, better resistive switching performance is obtained after CCS treatment, including low forming voltage, low reset current, uniform resistive switching and good endurance characteristics.
The practical application of spinel-type lithium titanate Li 4 Ti 5 O 12 (LTO) lithium-ion batteries is hindered by its poor conductivity and relatively low capacity. To address these issues, an LTO/reduced graphene oxide (rGO)/ SnO 2 is synthesized via an in situ electrostatic self-assembly and hydrothermal reduction process. Density function theory (DFT) simulations are conducted to understand the geometrical structures of these composites and the energy storage mechanisms. The DFT results confirm that the introduction of rGO and SnO 2 to LTO increases the overall conductivity, improves the structure stability, and increases Li-ion diffusion speed.
Sn3O4/g-C3N4 heterostructure nanomaterials were prepared by calcining melamine and the hydrothermal method. The microstructure and morphology of the synthesized specimen were characterized by X-ray diffraction (XRD), electron microscope (SEM and TEM) and nitrogen adsorption and desorption (BET). The photocatalytic activity was evaluated by the photodegradation of methylene blue (MB) under visible light irradiation and the electrochemical performance was tested under a typical three-electrode configuration. The results show that the Sn3O4/g-C3N4 heterojunctions exhibit more superior photocatalytic performance for degrading MB compared with single Sn3O4 and g-C3N4. The degradation rate of MB reaches up to a maximal 90.30% within 75[Formula: see text]min, which is far higher than that of Sn3O4 (61.30%). It is attributed to the effective interfacial contact between Sn3O4 and g-C3N4, which increases charge transfer and prolongs electron-hole separation time. The specific capacitance of Sn3O4/g-C3N4 is 28.6% higher than that of Sn3O4 due to the formation of a heterostructure.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.