Ashes were prepared by annealing selected types of solid fuels (biomass: corn cobs, sunflower husks, olive pomace, hay pellets and rice husks; coal: lignite and bituminous; and alternative fuel: paper sludge) at different temperatures (550°C, 815°C and 975°C). Based on X-ray fluorescence spectra, the slagging/fouling indexes were used to study the effects of the type of ash and the ashing temperature on the ash fouling and slagging properties. Slagging indexes were compared with the ash fusion temperatures. Ash fusion temperatures were measured by a LECO AF-700. The lowest deformation temperature (below 1000°C) was seen for the ashes prepared from hay pellets and corn cobs. On the other hand, the deformation temperature exceeded 1500°C for ashes prepared from paper sludge, sunflower husks and rice husks. By calculating the different slagging/fouling indexes, all the ashes exhibited slagging/fouling problems of varying degrees.
In line with the requirements of the circular economy, the European Union’s waste management legislative changes also concern the treatment of sewage sludge. Although sewage sludge production cannot be prevented, its quantities may be reduced by the synergetic effect of energy recovery via choosing a proper technology. Sewage sludge is difficult to apply as fuel alone, because of its high moisture and ash content. However, its energy use will be increased by adding suitable waste materials (different types of plastics, waste tires and paper rejects). Most recently, the thermal utilization of sewage sludge via incineration or pyrolysis has grown in importance. This article describes the fuel parameters of particular waste materials and of their blends with sewage sludge in connection with laboratory-scale thermal decomposition in an inert atmosphere, for their potential use in a semi-pilot plant pyrolysis unit. For pyrolytic application, the results of thermogravimetric analysis are needed in order to know the maximal temperature of thermal decomposition in an inert atmosphere, maximal mass losses, and weight loss rates. The samples of different thermoplastics mixed with sewage sludge, and low-density polyethylene blends with sewage sludge, had the lowest residual masses (70–74%) and the highest weight loss rates (11–19%/min). On the other hand, the blend of polyester rejects from tire processing, paper rejects and sewage sludge had the second highest residual mass (60%) and the lowest weight loss rate (3%/min).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.