The extraction of essential oils is generally carried out by two main techniques: azeotropic distillation (hydrodistillation, hydrodiffusion, and steam distillation) and extraction with solvents. However, these traditional methods are a bit expensive, especially since they are extremely energy and solvent consuming. This work consists in studying two methods of extraction of the essential oils of Rosmarinus officinalis L.: microwave assisted hydrodistillation (MAH) and Clevenger hydrodistillation (CH). Several parameters have been studied: the extraction time, the yield, and the chemical composition of the essential oils as well as the efficiency and cost of each procedure. The results obtained revealed that microwave-assisted hydrodistillation makes it possible to minimize the extraction time of the essential oils in comparison with conventional hydrodistillation. Thus, the same yield of essential oils is obtained for 20 minutes only with MAH while it takes 180 minutes with CH. In addition, the quality of the essential oil is improved thanks to a 1.14% increase in oxygenates. In conclusion, the MAH method offers significant advantages over conventional hydrodistillation and can therefore replace it on a pilot and industrial scale.
International audienceAn environmentally friendly electrochemical treatment, electro-Fenton process, was applied to the depollution of a synthetic dismissal composed of three dyes, yellow drimaren, congo red and methylene blue, frequently used in textile and dyehouses. Here, we show that those dyes and their mixture are quickly degraded under current controlled electrolysis conditions, leading to an almost complete mineralization. The results show the efficiency of electro-Fenton process to quickly degrade aqueous effluents polluted by synthetic organic dyes
Various membrane separation processes are being used for seawater desalination and treatment of wastewaters in order to deal with the worldwide water shortage problem. Different types of membranes of distinct morphologies, structures and physico-chemical characteristics are employed. Among the considered membrane technologies, membrane distillation (MD), osmotic distillation (OD) and osmotic membrane distillation (OMD) use porous and hydrophobic membranes for production of distilled water and/or concentration of wastewaters for recovery and recycling of valuable compounds. However, the efficiency of these technologies is hampered by fouling phenomena. This refers to the accumulation of organic/inorganic deposits including biological matter on the membrane surface and/or in the membrane pores. Fouling in MD, OD and OMD differs from that observed in electric and pressure-driven membrane processes such electrodialysis (ED), membrane capacitive deionization (MCD), reverse osmosis (RO), nanofiltration (NF), ultrafiltration (UF), microfiltration (MF), etc. Other than pore blockage, fouling in MD, OD and OMD increases the risk of membrane pores wetting and reduces therefore the quantity and quality of the produced water or the concentration efficiency of the process. This review deals with the observed fouling phenomena in MD, OD and OMD. It highlights different detected fouling types (organic fouling, inorganic fouling and biofouling), fouling characterization techniques as well as various methods of fouling reduction including pretreatment, membrane modification, membrane cleaning and antiscalants application.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.