No abstract

The aim of this study was to compare the effects of different silica grades on the structure and morphology of isotactic polypropylene (iPP)/silica composites to better understand their structure-property relationships. Isotactic polypropylene composites with 2, 4, 6, 8 vol % of added silica fillers differing in particle size (micro-vs. nanosilica) and surface modification (untreated vs. treated surface) were prepared by nonisothermal compression molding and characterized by different methods. The addition of all silica fillers grades to the iPP matrix significantly influenced the spherulitic morphology, while phase characteristics of the iPP matrix seemed to be unaffected. Surface modification of silica fillers exhibited stronger effects on spherulite size than size of silica particles. Nonpolar silica particles, more miscible or compatible with iPP chains than polar silica particles, enabled better spherulitic growth. The spherulite sizes tended to reach equal values at 8 vol % of added silicas showing that spherulite size became independent of filler concentration and surface modification above optimum filler concentration.

No abstract

No abstract

Various silica grades differing in particle size (micro- versus nanosilica) and surface modification (untreated versus modified surface) have affected interfacial and mechanical properties of compression-molded polypropylene composites with 2, 4, 6, 8 vol% of added silica. Mechanical properties have been influenced primarily by combination of stiff fillers and tough polypropylene matrix and additionally by restructured matrix. Namely, silica particles with different surface properties have influenced nucleation and spherulite growth differently affecting thus tensile properties of the composites. All composites exhibited best tensile strength in silica content range 2–6 vol%.

The effects of two metallocene ethylene-propylene-based elastomers (m-EPR1 and m-EPR2) differing in molecular mass and viscosity on mechanical, rheological and interfacial properties were compared. The m-EPR elastomers were added to iPP in 2.5, 5, 10, 15, and 20 vol.%. Torque values, elongation at break and impact strength measured of the iPP/m-EPR1 blends were higher than the iPP/m-EPR2 blends due to higher molten viscosity of m-EPR1 than m-EPR2 copolymer. Slight differences in Young moduli as well as in tensile strength at yield and at break might indicate that tensile properties of iPP/m-EPR blends were not significantly affected by difference in viscosity or molecular mass, miscibility and spherulite size. Optimization diagrams indicated the metallocene m-EPR copolymers are efficient impact modifiers for polypropylene and showed good balancing of mechanical properties in iPP/m-EPR blends.

The ecodesign of products is becoming an important part of environmental and innovation policies in many sectors. The aim of this study was to understand how product ecodesign activities can be effectively introduced to stimulate step changes in small and medium enterprises (SMEs) in the construction and building sector, together with SMEs from related industrial sectors. Based on an interview study among Slovenian SMEs, the general level of managers’ awareness of how their products impact the environment and how they understand the concept of product ecodesign to provide potential measures for ecodesign implementation was investigated. The results showed the quantified aggregate of degrees of implementation related to individual ecodesign strategies based on life cycle phases and individual environmental aspects. The study revealed that the most frequently implemented criteria were maximizing product lifetime and ease of reuse, disassembly and recycling. The highest ecodesign implementation level was observed in the “design for use” phase.

No abstract