Patterned monolayers of N-heterocyclic carbenes (NHCs) on gold surfaces were obtained by microcontact printing of NHC-CO adducts and NHC(H)[HCO ] salts. The NHC-modified areas showed an increased conductivity compared to unmodified gold surface areas. Furthermore, the remaining surface areas could be modified with a second, azide-functionalized carbene, facilitating further applications and post-printing modifications. Thorough elucidation by a variety of analytical methods offers comprehensive evidence for the viability of the methodology reported here. The protocol enables facile access to versatile, microstructured NHC-modified gold surfaces with highly stable patterns, enhanced conductivity, and the option for further modification.

Triazolinedione (TAD) click reactions were combined with microcontact chemistry to print, erase, and reprint polymer brushes on surfaces. By patterning substrates with a TAD-tagged atom-transfer radical polymerization initiator (ATRP-TAD) and subsequent surface initiated ATRP, it was possible to graft micropatterned polymer brushes from both alkene- and indole-functionalized substrates. As a result of the dynamic nature of the Alder-ene adduct of TAD and indole at elevated temperatures, the polymer pattern could be erased while the regenerated indole substrate could be reused to print new patterns. To demonstrate the robustness of the methodology, the write-erase cycle was repeated four times.

Abstract. The analytical sensitivity in matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) is largely affected by the specific analyte-matrix interaction, in particular by the possible incorporation of the analytes into crystalline MALDI matrices. Here we used time-of-flight secondary ion mass spectrometry (ToF-SIMS) to visualize the incorporation of three peptides with different hydrophobicities, bradykinin, Substance P, and vasopressin, into two classic MALDI matrices, 2,5-dihydroxybenzoic acid (DHB) and α-cyano-4-hydroxycinnamic acid (HCCA). For depth profiling, an Ar cluster ion beam was used to gradually sputter through the matrix crystals without causing significant degradation of matrix or biomolecules. A pulsed Bi 3 ion cluster beam was used to image the lateral analyte distribution in the center of the sputter crater. Using this dual beam technique, the 3D distribution of the analytes and spatial segregation effects within the matrix crystals were imaged with sub-μm resolution. The technique could in the future enable matrix-enhanced (ME)-ToF-SIMS imaging of peptides in tissue slices at ultra-high resolution.

Cholesterol is an essential component of most biological membranes and serves important functions in controlling membrane integrity, organization, and signaling. However, probes to follow the dynamic distribution of cholesterol in live cells are scarce and so far show only limited applicability. Herein, we addressed this problem by synthesizing and characterizing a class of versatile and clickable cholesterol-based imidazolium salts. We show that these cholesterol analogs faithfully mimic the biophysical properties of natural cholesterol in phospholipid mono- and bilayers, and that they integrate into the plasma membrane of cultured and primary human cells. The membrane-incorporated cholesterol analogs can be specifically labeled by click chemistry and visualized in live-cell imaging experiments that show a distribution and behavior comparable with that of endogenous membrane cholesterol. These results indicate that the cholesterol analogs can be used to reveal the dynamic distribution of cholesterol in live cells.

Electrochemiluminescence (ECL) generated by a monolayer of a spirobifluorene derivative covalently bound onto an indium tin oxide (ITO) substrate is reported for the first time. Our approach allows the efficient preparation homogeneous and patterned substrates through micromolding in capillaries (MIMIC), and opens novel scenarios for multicolour ECL applications.

Time-of-flight secondary ion mass spectrometry (ToF-SIMS) was used to characterize the freeze-fracturing process of human epithelial PANC-1 and UROtsa cells. For this purpose, phosphatidylcholine, sphingomyelin, phosphatidylethanolamine, and phosphatidylserine standard samples were investigated to find specific signals with both high specificity and signal intensity. The results were used to investigate single cells of subconfluent cell layers prepared with a special silicon wafer sandwich preparation technique. This freeze-fracturing technique strips cell membranes off the cells, isolating them on opposing silicon wafer substrates. Criteria were found for defining regions with stripped off cell membranes and, on the opposing wafer, complementary regions with the remaining cells. Measured ethanolamine/choline and serine/choline ratios in these regions clearly showed that in the freeze-fracturing process, the lipid bilayer of the plasma membrane is split along its central zone. Accordingly, only the outer lipid monolayer is stripped off the cell, while the inner lipid monolayer remains attached to the cell on the opposing wafer, thus allowing detailed analysis of a single lipid monolayer. Furthermore, it could be shown that using different washing procedures did not influence the transmembrane lipid distribution. Under optimized preparation conditions, it became feasible to detect lipids with a lateral resolution of approximately 100 nm. The data indicate that ToF-SIMS would be a very useful technique to study with very high lateral resolution changes in lipid composition caused, for example, by lipid storage diseases or pharmaceuticals that interfere with the lipid metabolism.

Time of flight secondary ion mass spectrometry (ToF-SIMS) is a powerful technique for the nanoanalysis of biological samples, but improvements in sensitivity are needed in order to detect large biomolecules, such as peptides, on the individual cell level at physiological concentrations. Two promising options to improve the sensitivity of SIMS to large peptides are the use of cluster primary ions to increase desorption of intact molecules or the use of matrix-assisted laser desorption/ionization (MALDI) matrices to increase the ionization probability. In this paper, the authors have combined these two approaches in order to improve understanding of the interaction between ionization and fragmentation processes. The peptides bradykinin and melittin were prepared as neat monolayers on silicon, in a Dextran-40 matrix and in two common MALDI matrices, 2,5-dihydroxybenzoic acid (DHB) and α-cyano-4-hydroxy cinnamic acid (HCCA). ToF-SIMS spectra of these samples were collected using a range of small Bi cluster primary ions and large Ar cluster primary ions. The trends observed in the molecular ion yield and the [M+H](+)/C4H8N(+) ratio with primary ion cluster size were sample system dependent. The molecular ion yield of the bradykinin was maximized by using 30 keV Bi3 (+) primary ions in a DHB matrix but in the HCCA matrix, the maximum molecular ion yield was obtained by using 30 keV Bi7 (+) primary ions. In contrast, the molecular ion yield for melittin in both matrices was greatest using 20 keV Ar2000 (+) primary ions. Improvements in the molecular ion yield were only loosely correlated with a decrease in small fragment ions. The data indicate a complex interplay between desorption processes and ion formation processes which mean that the optimal analytical conditions depend on both the target analyte and the matrix.

Strukturierte Monoschichten aus N-heterocyclischen Carbenen auf Goldoberflächen wurden durchM ikrokontaktdruck von NHC-CO 2 -Addukten und NHC(H)[HCO 3 ]-Salzen hergestellt. Die NHC-modifizierten Bereiche zeigten eine erhçhte Leitfähigkeit im Vergleichz ud er nichtm odifizierten Goldoberfläche. Darüber hinaus konnte die nicht bedeckte Oberflächemit einem zweiten, Azid-funktionalisierten Carben bestücktwerden, was weitere Anwendungen und nachträgliche ¾nderungen nachdem Drucken ermçglichte.Eine gründliche Aufklärung durch eine Vielzahl von Analysemethoden bietet einen umfassenden Nachweis fürd ie Durchführbarkeit der hier vorgestellten Methode.D as Protokoll ermçglicht den einfachen Zugang zu vielseitigen, mikrostrukturierten NHCmodifizierten Goldoberflächen mit hochstabilen Mustern, erhçhter Leitfähigkeit und der Mçglichkeit zur weiteren Modifikation.