The photochemical and photophysical properties of the cis-[Ru(II)(α-diimine)2(4-APy)2](2+) complexes, where α-diimine = 1,10-phenanthroline (phen) and 4-APy = 4-aminopyridine I, 4,7-diphenyl-1,10-phenanthroline (Ph2phen) II, 2,2'-bipyridine (bpy) III, and 4,4'-dimethyl-2,2'-bipyridine (Me2bpy) IV, are reported. The four complexes were characterized using high-performance liquid chromatography, (1)H NMR, UV-visible, emission, and transient absorption spectroscopy. Upon photolysis in acetonitrile solution these complexes undergo 4-APy dissociation to give the monoacetonitrile complex (for II, III, and IV) or the bis(acetonitrile) complex (for I). A fairly wide range of excitation wavelengths (from 420 to 580 nm) were employed to explore the photophysics of these systems. Quantum yields and transient spectra are provided. Density functional theory (DFT) and time-dependent DFT analysis of singlet and triplet excited states facilitated our understanding of the photochemical behavior. A detailed assessment of the geometric and electronic structures of the lowest energy spin triplet charge transfer state ((3)MLCT) and spin triplet metal centered state ((3)MC) (dπ → σ* transitions) for species I-IV is presented. A second, previously unobserved, and nondissociative, (3)MC state is identified and is likely involved in the primary step of photodissociation. This new (3)MC state may indeed play a major role in many other photodissociation processes.
The electrochemical reduction of carbon dioxide into carbon monoxide, hydrocarbons and formic acid has offered an interesting alternative for a sustainable energy scenario. In this context, Sn-based electrodes have attracted a great deal of attention because they present low price and toxicity, as well as high faradaic efficiency (FE) for formic acid (or formate) production at relatively low overpotentials. In this work, we investigate the role of tin oxide surfaces on Sn-based electrodes for carbon dioxide reduction into formate by means of experimental and theoretical methods. Cyclic voltammetry measurements of Sn-based electrodes, with different initial degree of oxidation, result in similar onset potentials for the CO2 reduction to formate, ca. −0.8 to −0.9 V vs. reversible hydrogen electrode (RHE), with faradaic efficiencies of about 90–92% at −1.25 V (vs. RHE). These results indicate that under in-situ conditions, the electrode surfaces might converge to very similar structures, with partially reduced or metastable Sn oxides, which serve as active sites for the CO2 reduction. The high faradaic efficiencies of the Sn electrodes brought by the etching/air exposition procedure is ascribed to the formation of a Sn oxide layer with optimized thickness, which is persistent under in situ conditions. Such oxide layer enables the CO2 “activation”, also favoring the electron transfer during the CO2 reduction reaction due to its better electric conductivity. In order to elucidate the reaction mechanism, we have performed density functional theory calculations on different slab models starting from the bulk SnO and Sn6O4(OH)4 compounds with focus on the formation of -OH groups at the water-oxide interface. We have found that the insertion of CO2 into the Sn-OH bond is thermodynamically favorable, leading to the stabilization of the tin-carbonate species, which is subsequently reduced to produce formic acid through a proton-coupled electron transfer process. The calculated potential for CO2 reduction (E = −1.09 V vs. RHE) displays good agreement with the experimental findings and, therefore, support the CO2 insertion onto Sn-oxide as a plausible mechanism for the CO2 reduction in the potential domain where metastable oxides are still present on the Sn surface. These results not only rationalize a number of literature divergent reports but also provide a guideline for the design of efficient CO2 reduction electrocatalysts.
One of the most important current topics in the renewable and sustainable energy scenario is the CO2 electro‐reduction reaction (CO2RR), which is an alternative and important route for its conversion into various high value‐added chemicals, therefore making up a CO2 recycling process. Despite its importance and the works already developed in this field, many challenges still need to be overcome for CO2RR to reach high values of efficiency and selectivity. This is even more challenging considering that this reaction occurs with the transfer of several electrons, making the investigation and elucidation of the reaction mechanism a real need. Thus, several characterization techniques have been employed, and specially, the on‐line Electrochemical Mass Spectrometry (EC‐MS) technique emerges as a powerful tool, thus making possible to improve the understanding of reaction pathways, through the identification of products and intermediaries, and allowing the screening of electrocatalyst potentials for CO2RR. Herein, we present the evolution of adaptations of general electrochemical cell designs for the study of the CO2RR.
The monodentate cis-[Ru( phen) 2 (hist) 2 ] 2+ 1R and the bidentate cis-[Ru( phen) 2 (hist)] 2+ 2A complexes were prepared and characterized using spectroscopic Cell uptake of the complexes into HeLa cells was detected by fluorescence confocal microscopy. Overall, the observation of a luminescent complex that penetrates the cell wall and has low cytotoxicity, but is reactive photochemically, releasing histamine when irradiated with visible light, are interesting features for application of these complexes as phototherapeutic agents.
The carbon dioxide electrocatalytic reduction is central for the development of regenerative cycles of electrochemical energy conversion and storage. Herein, the gaseous products of the CO 2 electroreduction were monitored by using an electrochemical cell on line coupled to a differential electrochemical mass spectrometer (DEMS), aiming at searching for electrocatalysts with high selectivity for CO formation. The results showed that, among the studied materials, the Cu 4 Sn/C alloy nanoparticles were stable during potentiostatic polarizations as revealed by in situ X-ray absorption spectroscopy (XAS), and the on line DEMS measurements showed the production of CO, suppression of methane and ethylene formations, and diminishing of the hydrogen evolution reaction, in relation to that on pure Cu 2 O-Cu/C. The faradaic efficiencies for CO formation were 13 and 23% for Cu 4 Sn/C and Au/C (a known electrocatalyst for CO), respectively, determined by experiments of in line gas chromatography (GC). The selectivity of Cu 4 Sn/C for CO formation was ascribed to the role of Sn atoms on stabilizing adsorbed HCOO intermediates, and hindering further hydrogenation, letting CO free for desorption. These results are expected to be used as a guide for further development of electrocatalysts with a fine-tuning of composition for increasing the faradaic efficiency of CO 2 electroreduction to CO.Keywords: CO 2 electrochemical reduction, on line DEMS, in line GC, CO formation, Cu 4 Sn/C alloy IntroductionConcomitantly with the growth of the world population, the energy demand is increasing. To satisfy this scenario, fossil fuels, such as oil, coal and natural gas, are being exhaustively used. Unfortunately, together to the dependence on these fuels, large amounts of carbon dioxide (CO 2 ) are emitted into the environment and, so, this is not a sustainable cycle. This has initiated research projects to investigate efficient processes for using the available CO 2 in the atmosphere. The electrochemical reduction of carbon dioxide is, in principle, an efficient manner that can be explored. In this context, the electroreduction of CO 2 to fuels with high-energy density or to industrial chemicals, that can be further processed to produce useful fuels, such as CO, using photovoltaic panels, with the consecutive utilization as fuel in fuel cells, would define a sustainable or regenerative cycle. [1][2][3][4][5][6][7] In the case of performing the CO 2 electroreduction to CO in parallel with the water electroreduction (or the hydrogen evolution reaction (HER)), the mixture CO + H 2 (syngas) is produced. 8,9 In the chemical industry, CO/H 2 mixtures are reacted to form methanol or other liquid fuels, such as diesel, by using the Fischer-Tropsch process. 10 The CO 2 electrochemical reduction can be productselective by using different electrocatalysts. However, even for two-electron products, it is decisive to know the kinetically important steps of the studied reaction. Also, synthesizing an optimized electrocatalyst that do not catalyze undesi...
Electrochemical carbon dioxide reduction reaction (CO2RR) process can allow the production of chemicals under ambient conditions on nanostructured copper materials. However, reaction selectivity is still main drawback due to the...
Cálculos de orbitais moleculares para o complexo cis-[Ru(bpy) 2 L x ](PF 6 ) 2 , onde bpy é 2,2'-bipiridina e L é 3-aminopiridina (complexo 1 com x = 2), foram realizados com o programa Gaussian 03 usando o método DFT. A estrutura eletrônica e as propriedades moleculares de 1 foram caracterizadas no vácuo e em solução com acetonitrila e comparadas com os resultados obtidos para o complexo com L = 5,6-bis(3-amidopiridina)-7-oxanorborneno (complexo 2 com x = 1). Os espectros eletrônicos dos complexos 1 e 2 foram investigados por TD-DFT. Os dados experimentais de voltametria cíclica, UV-vis, fotoquímica e fotofísica foram comparados com dados teóricos de maneira a estabelecer a influência de L nas transições eletrônicas e interpretar as diferenças entre os comportamentos fotoquímicos desses complexos.MO calculations were carried out on a cis-[Ru(bpy) 2 L x ](PF 6 ) 2 complex, where bpy is 2,2'-bipyridine and L is 3-aminopyridine (complex 1 with x = 2), with the Gaussian 03 package using the DFT method. The electronic structure and molecular properties of 1 were characterized in vacuum and in acetonitrile solution, and the results were compared to those obtained from the complex with L = 5,6-bis(3-amidopyridine)-7-oxanorbornene (complex 2 with x = 1). The electronic spectra of 1 and 2 were investigated by TD-DFT. Experimental data from cyclic voltammetry, UV-visible spectroscopy, photochemical and photophysical experiments were compared to the theoretical data to discover the influence of L on the electronic transitions and to interpret the differences between the photochemical behaviors of these complexes.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
334 Leonard St
Brooklyn, NY 11211
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.