No abstract

Explosive field emission cathodes comprise an important class of cathodes for high power microwave tubes, having the advantages of light weight as well as requiring no heater for electron emission. Generally, however, this class of cathodes suffers from large amounts of outgassing, nonuniform emission, and very high emittance. This article describes a new class of carbon velvet cathodes that have been coated with a cesium iodide (CsI) salt. We discuss two manifestations of the cathode. We review the lifetime and operation of the cathodes with two different pulse durations, as well as the outgassing from the cathodes during operation. Lifetimes in excess of 980 000 pulses have been obtained, with an outgassing rate of 3.5 atoms per electron. Finally, we discuss the uniformity and emittance of tufted carbon cathodes that have been coated with CsI salt. For comparison, we relate these results to those previously obtained from other cathodes in this class. The cathodes have an emittance of 2.5π mm rad, as compared to the theoretical value, based on computation, of 2.3π mm rad. These new cathodes differ greatly from cathodes such as polymer velvet and tufted carbon fiber cathodes in that no volatiles reside on the cathode and in that a unique coating technique allows the cathodes to function. This new class of cathodes offers a potential replacement for existing thermal cathodes, in that no heater is required for superior operation with low outgassing and long lifetime.

Field emission cathodes have been a subject of research for many years. These cathodes hold the promise of effective electron emission in the absence of a heater. Such devices find application in the high power microwave (HPM) arena, as well as the conventional microwave industry and other areas such as flat panel displays. Over the past several years the Air Force Research Laboratory began to focus on cesium iodide cathodes as a field emission cathode of some interest. Previously reported results demonstrated a cesium iodide coated carbon velvet cathode capable of over one million pulses of operation with no degradation of emission. However, the exact emission mechanism remains somewhat unclear. This paper presents results showing that plasma formation on the cathode surface remains minimal at 1 μs pulse lengths. While ionized cesium and iodine lines exist in the light spectrum from the diode, these lines remain quite small, with the fluorescent emission from solid cesium iodide dominating the optical spectra in the diode. Hence, we propose that the cesium iodide coated carbon velvet operates in a space charge limited regime with pure field emission alone.

No abstract

This paper describes the first experiments that use only two carbon fiber field emitters with different separations to quantify and isolate the effect of electric field screening. Experiments show that when the separation between the two carbon fiber cathodes decreases, both the effective field enhancement factor, βeff, and the current emission decreases. For a two-emitter geometry, our experiment suggests a height of approximately 1.5 times the separation between the two cathodes as the optimum ratio to optimize the emitted current. The paper shows the analysis of the turn on voltage of the field emitters for different separations. The authors compare experimental data with Fowler–Nordheim field emission theory and particle-in-cell simulation, showing good agreement between experiment, theory, and modeling.

No abstract

Explosive field emission cathodes have been used extensively in high power microwave tubes. These cathodes emit electrons without the use of cathode heaters. Recently, some theoretical and simulation work has been performed to gain further understanding of the physics of these cathodes. The purpose of this letter is to provide the experimental background and justification for the theoretical work. The general idea of how explosive field emission cathodes operate is that plasma is rapidly formed, which provides the sea of electrons for space charge limited flow. However, recent theoretical and experimental work suggests edge effects, rather than plasma formation across the entire emission area, can also provide the same effect. In this letter we review three types of cathodes which have been tested. We provide optical data on the cathode emission uniformity as well as the electrical data for the same devices. In particular, we find that a large percentage of the cathode can fail to take part in the emission process and yet the voltage and current can appear identical from the case in which the entire cathode contributes electrons to the emission process.

Explosive field emission cathodes have been a subject of research for a number of years. These cathodes offer high current densities and total current without requiring a heater for the production of electrons. Generally these cathodes consist of some structure with a series of tips or metal–dielectric regions in which a large electric field enhancement can occur. A cathode plasma is then formed from these discharge points that then supplies the electrons necessary for space charge limited emission. This article reports on a series of optical measurements in which the cathode and anode plasmas of explosive field emission cathodes are observed. Three types of cathodes are investigated. These types are a polymer velvet cathode, a metal–dielectric cathode, and a tufted carbon fiber cathode in which the fibers have been coated with a cesium iodide salt. Cesium iodide coated carbon fiber cathodes have shown a great deal of promise for various field emitter applications. From these high speed photos, the evolution of the plasmas on both cathode and anode can be qualitatively ascertained. Experimentally we find that not only does cathode plasma behavior depend on the type of cathode, but the anode plasma behavior does also. Further, we find that the best performing cathode shows the most rapid plasma formation on both anode and cathode, yet without a rapid plasma expansion across the anode–cathode gap.