Gallium nitride (GaN) is a compound semiconductor that has tremendous potential to facilitate economic growth in a semiconductor industry that is silicon-based and currently faced with diminishing returns of performance versus cost of investment. At a material level, its high electric field strength and electron mobility have already shown tremendous potential for high frequency communications and photonic applications. Advances in growth on commercially viable large area substrates are now at the point where power conversion applications of GaN are at the cusp of commercialisation. The future for building on the work described here in ways driven by specific challenges emerging from entirely new markets and applications is very exciting. This collection of GaN technology developments is therefore not itself a road map but a valuable collection of global state-of-the-art GaN research that will inform the next phase of the technology as market driven requirements evolve. First generation production devices are igniting large new markets and applications that can only be achieved using the advantages of higher speed, low specific resistivity and low saturation switching transistors. Major investments are being made by industrial companies in a wide variety of markets exploring the use of the technology in new circuit topologies, packaging solutions and system architectures that are required to achieve and optimise the system advantages offered by GaN transistors. It is this momentum that will drive priorities for the next stages of device research gathered here.

ower GaN transistors have recently demonstrated to be excellent devices for application in power electronics. The high breakdown field and the superior mobility of the 2-dimensional electron gas allow to fabricate transistors with low resistive and switching losses, that permit to increase the efficiency of switching mode power converters beyond 99 %. GaN-based transistors are currently supposed to be adopted in KW-range power converters; 650 V transistors are already available on the market, and 1200 V devices are currently under development. During operation, GaN power transistors can reach critical conditions, especially in the off-state (with a high VDS, in excess of 650 V), during hard-switching (where high current and voltage can be simultaneously present), and for high positive gate voltages (in the case of normally-off devices). This paper reports our most recent results on the gradual and catastrophic degradation of GaN-based power HEMTs. We present the results of three different case studies, on: (i) the time-dependent breakdown of power HEMTs submitted to high off-state stress; (ii) the degradation of HEMTs with p-GaN gate submitted to high gate stress; (iii) the hot electron effects in GaN-MISHEMTs submitted to high-Temperature source current stres

We present a first study of threshold voltage instabilities of semi-vertical GaN-on-Si trench-MOSFETs, based on double pulsed, threshold voltage transient, and UV-assisted C-V analysis. Under positive gate stress, small negative V th shifts (low stress) and a positive V th shifts (high stress) are observed, ascribed to trapping within the insulator and at the metal/insulator interface. Trapping effects are eliminated through exposure to UV light; wavelength-dependent analysis extracts the threshold de-trapping energy ≈2.95 eV. UV-assisted CV measurements describe the distribution of states at the GaN/Al 2 O 3 interface. The described methodology provides an understanding and assessment of trapping mechanisms in vertical GaN transistors.

This paper presents an extensive investigation of the impact of the resistivity of the silicon substrate on the vertical leakage and charge trapping in 200 V GaN-on-Si enhancement-mode high-electron mobility transistors. Three wafers having different substrate resistivities were submitted to combined DC characterization, step-stress experiments, and electroluminescence (EL) analysis. The results described within this paper demonstrate that: 1) the use of a highly resistive silicon substrate can increase the vertical breakdown voltage of the transistors, due to the fact that the voltage drop on the GaN buffer is mitigated by the partial depletion of the substrate (this latter causes a plateau region in the drain to substrate I-V characteristic) and 2) highly resistive substrate results in stronger trapping effects, due to the capacitance of the depleted substrate and the resulting backgating effects. The results described within this paper indicate that the choice of the resistivity of the substrate is the result of a tradeoff between high breakdown voltage (that could be in principle achieved through a highly resistive substrate) and the minimization of trapping processes (which can be hardly obtained with a resistive substrate).Index Terms-Buffer traps, GaN, high-electron mobility transistor (HEMT), vertical leakage. I. INTRODUCTIONG AN-ON-SILICON power high-electron mobility transistors (HEMTs) are promising devices for switching application in the range of voltages up to 1200 V. Thanks

No abstract

We propose to use a bilayer insulator (2.5 nm Al2O3 + 35 nm SiO2) as an alternative to a conventional uni-layer Al2O3 (35 nm), for improving the performance and the reliability of GaN-on-Si semi vertical trench MOSFETs. This analysis has been performed on a test vehicle structure for module development, which has a limited OFF-state performance. We demonstrate that devices with the bilayer dielectric present superior reliability characteristics than those with the uni-layer, including: (i) gate leakage two-orders of magnitude lower; (ii) 11 V higher off-state drain breakdown voltage; and (iii) 18 V higher gate-source breakdown voltage. From Weibull slope extractions, the uni-layer shows an extrinsic failure, while the bilayer presents a wear-out mechanism. Extended reliability tests investigate the degradation process, and hot-spots are identified through electroluminescence microscopy. TCAD simulations, in good agreement with measurements, reflect electric field distribution near breakdown for gate and drain stresses, demonstrating a higher electric field during positive gate stress. Furthermore, DC capability of the bilayer and unilayer insulators are found to be comparable for same bias points. Finally, comparison of trapping processes through double pulsed and Vth transient methods confirms that the Vth shifts are similar, despite the additional interface present in the bilayer devices.

The vertical Gallium Nitride-on-Silicon (GaN-on-Si) trench metal-oxide-semiconductor field effect transistor (MOSFET) is a promising architecture for the development of efficient GaN-based power transistors on foreign substrates for power conversion applications. This work presents an overview of recent case studies, to discuss the most relevant challenges related to the development of reliable vertical GaN-on-Si trench MOSFETs. The focus lies on strategies to identify and tackle the most relevant reliability issues. First, we describe leakage and doping considerations, which must be considered to design vertical GaN-on-Si stacks with high breakdown voltage. Next, we describe gate design techniques to improve breakdown performance, through variation of dielectric composition coupled with optimization of the trench structure. Finally, we describe how to identify and compare trapping effects with the help of pulsed techniques, combined with light-assisted de-trapping analyses, in order to assess the dynamic performance of the devices.

This work investigates p+n−n GaN-on-Si vertical structures, through dedicated measurements and TCAD simulations, with the ultimate goal of identifying possible strategies for leakage and breakdown optimization. First, the dominant leakage processes were identified through temperature-dependent current–voltage characterization. Second, the breakdown voltage of the diodes was modelled through TCAD simulations based on the incomplete ionization of Mg in the p+ GaN layer. Finally, the developed simulation model was utilized to estimate the impact of varying the p-doping concentration on the design of breakdown voltage; while high p-doped structures are limited by the critical electric field at the interface, low p-doping designs need to contend with possible depletion of the entire p-GaN region and the consequent punch-through. A trade-off on the value of p-doping therefore exists to optimize the breakdown.