The layer-by-layer film deposition is a suitable strategy for the design and functionalization of drug carriers with superior performance, which still lacks information describing the influence of assembly conditions on the mechanisms governing the drug release process. Herein, traditional poly(acrylic acid)/poly(allylamine) polyelectrolyte multilayers (PEM) were explored as a platform to study the influence of the assembly conditions such as pH, drug loading method, and capping layer deposition on the mechanisms that control the release of calcein, the chosen model drug, from PEM. Films with 20−40 bilayers were assembled at pH 4.5 or 8.8, and the drug loading process was carried out during-or post-film assembly. Release data were fitted to three release models, namely, Higuchi, Ritger−Peppas, and Berens−Hopfenberg, to investigate the mechanism governing the drug transport, such as the apparent diffusion and the relaxation time. The postassembly drug loading method leads to a higher drug loading capacity than the during-assembly method, attributed to the washing out of calcein during film assembly steps in the latter method. Higuchi's and Ritger−Peppas' model analyses indicate that the release kinetic constant increased with the number of bilayers for the postassembly method. The opposite trend is observed for the during-assembly method. The Berens−Hopfenberg release model enabled the decoupling of each drug transport mechanism's contribution, indicating the increase of the diffusion contribution with the number of bilayers for the postassembly method at pH 4.5 and the increase of the polymer relaxation contribution for the during-assembly method at pH 8.8. Deborah's number, which represents the ratio of the polymer relaxation time to the diffusion time, follows the trends observed for the relaxation contribution for the conditions investigated. The deposition of the capping phospholipid layer over the payload also favored the polymer relaxation contribution in the drug release, featuring new strategies to investigate the drug release in PEM.
Biocompatible chemically cross-linked organic-inorganic (O-I) hybrid nanocomposites were developed using a new atoxic, simple and fast, solvent-free pathway. Poly(ε-caprolactone) (PCL) and poly(ethylene glycol) (PEG), which are both biocompatible, were used as the organic moieties (at different PCL/PEG ratios), while in situ synthesized polysilsesquioxanes made up the inorganic moiety. The O-I hybrid nanocomposites' molecular structures were characterized using solid-state Si NMR, TGA and ATR-IR. Results showed an unusually high condensation yield of approximately 90% and two distinct silsesquioxane structures. No traces of the remaining isocyanate groups were found. Advanced morphological characterization of the ternary O-I hybrids was performed using a combination of electron microscopy and X-ray scattering techniques such as SEM, TEM, ESI-TEM, WAXS and temperature-dependent SAXS. Results showed the occurrence of spherical nanoparticles, associated with polysilsesquioxane, and ordered network grains, associated with PCL and/or PEG chains cross-linked by silsesquioxane cages. As a consequence, a four-phased nanostructured morphology was proposed. In this model, PCL and PEG are undistinguishable, while polysilsesquioxane nanoparticles are uniformly distributed throughout a homogeneous cross-linked matrix, which shows gel-like behavior. Moreover, a mobile phase made up of unbound polymer chains occurs at the grain interface.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.