Agricultural use and management systems in tropical soils of the Brazilian Cerrado may directly influence its chemical properties, in the conventional cultivation systems with pastures or grains, as well as in areas with a crop-livestock-forest integration system. Thus, the objective was to evaluate the chemical attributes of the soil under different use and management systems. The research was carried out at Boa Vereda Farm, in the state of Goiás, Brazil. The experimental design was completely randomized with a 5 x 3 factorial arrangement divided into five production systems: (1) among the rows of Eucalyptus (CLFI), (2) within the rows of Eucalyptus (CLFI), (3) in conventional agricultural monoculture, (4) pasture, and (5) -natural Cerrado (control treatment). Samples were collected in three soil depths (0-0.5; 0.5-0.1 and 0.1-0.2 m), with four replicates each. Among the chemical properties of the soil studied, the organic matter, calcium, magnesium and potassium contents, base saturation, and cation exchange capacity, are higher in the soil with natural Cerrado. The area of agricultural monoculture showed the highest levels of phosphorus and copper, but has the lower levels of organic matter in the soil. The chemical properties of the soil were similar in the CLFI system, regardless of the evaluation point (within or among rows). The chemical properties of the soil evaluated were similar between the pasture cultivated in CLFI and the conventional system. Therefore, the land use and management system do not directly influence the chemical properties of the soils evaluated.
Resumo: Este estudo foi realizado em um sistema de produção integrado lavoura-pecuária-floresta no município de Cachoeira Dourada, Goiás, Brasil. A pesquisa colabora para um melhor entendimento da interação planta-ambiente, esta foi realizada com o objetivo de analisar a entrada de luz em dois períodos diferentes (estação seca e chuvosa). Para a coleta da Densidade de Fluxo de Fótons (DFF) (µmol.m-2 .s-1 ) foi utilizado dois sensores de quanta LI-250 A, Li-cor Inc., USA, na faixa fotossinteticamente ativa. A coleta foi realizada de hora em hora, com início às 9h45min e término às 17h45min. Coletou-se o DFF controle -a pleno sol, e as demais coletas foram realizadas em quatro pontos: (1-no centro do renque de árvores, 2 -a 5m do renque, 3 -a 10m do renque e 4 -a 15m do renque), sendo que em cada ponto se obteve mais 4 repetições. De acordo com os resultados obtidos se verificou que houve diferenças entre os pontos escolhidos, sendo o ponto 10 e 15 metros com maior recebimento de faixa de Radiação Fotossinteticamente Ativa (RFA). Portanto, o sistema Integrado Lavoura-Pecuária-Floresta (ILPF) não reduziu a Densidade de Fluxo de Fótons (DFF). A maior DFF foi verificada no período de seca, porém, a maior variação da DFF foi encontrada no período chuvoso. Quanto maior à distância em relação aos renques, com eucaliptos, maior à incidência de radiação solar. Palavras -chave:Luminosidade; Produtividade; Fotossíntese; Agrossilvipastoril. Photon flux density in a crop livestock forest systemAbstract: This study was conducted in a crop livestock forest system in Cachoeira Dourada, Goiás state, Brazil. Aiming to contribute to a better understanding about plant-environment interaction, this study had as objective to analyze light input in two different periods (dry and wet season). For photon flux density (PFD) measurement, two quanta sensors (LI-250 A, Licor Inc., USA) were used, in photosynthetically active band. Data collection was done in each hour, starting at 9:45 and ending at 17:45, and also collected the control to full sun, and other collections in: (1 in the center of the row of trees, 2 -at 5 m of hedgerow 3 -at 10m of hedgerow 4-at 15m of hedgerow), in each point 4 replications were obtained. According to the observed results, it was possible to verify that there were differences among the chosen points, being the points 10 and 15 meters the ones that receive the most range of PAR.most receiving range (PAR). Therefore, CLFS system did not reduce photons flux density. Highest PFD was verified during the dry season however the highest variation was verified in the wet period. The greater the distance from the rows with trees, the greater the incidence of solar radiation.
The physicochemical characteristics of honey depend on many factors such as bee species, climatic aspects, physiological state of the hive and the vegetable species that serve the necessary nectar and pollen. The description of the physicochemical aspects of honey in Brazil becomes relevant to define the quality of Brazilian products, as well as regional aspects and species of bees influence the physical and chemical composition of honey. The objective of this paper is to describe the physicochemical quality of Brazilian honey, relating to the species of bees and the regional production and to highlight the importance of these elements to determine the quality of honey. In order to provide the standard research on the physicochemical characterization of honey, the following keywords have been set: honey and physicochemical quality. The physic-chemical characteristics are defined by the normative instruction MAPA No. 11/2000 and by the values, there were determined averages, standard deviation and analysis of the main components of honey from different Brazilian states and honey from different species of bees. Stingless bees produce honey with distinguished physical-chemical quality, depending on the species. The Apis mellifera honey has good physicochemical
La pérdida de variabilidad genética de interés ha tomado importancia no sólo la producción, sino también porque puede tener un efecto negativo en la epidemiología de las enfermedades animales. La actividad ganadera puede presentar considerables pérdidas económicas periódicas debido a la eliminación de animales, la reducción de la productividad, la falta de expresión del potencial genético de los animales, los costes de tratamiento, la asistencia laboral y profesional, el cierre del comercio debido a los obstáculos sanitarios y la competencia con los mercados extranjeros. Por lo tanto, la resistencia a las enfermedades es un atributo deseado en la producción ganadera y la salud animal puede estar limitando en los sistemas de producción de ganado. Existe cierta confusión en la terminología: la resistencia se define como la capacidad del huésped para ejercer cierto grado de control sobre el ciclo de vida del patógeno, mientras que la tolerancia define el impacto de la infección en el rendimiento animal. Un concepto muy cercano a la tolerancia es la resiliencia, que se puede definir como mantener la capacidad productiva del animal frente a la infección. Existen numerosos informes que indican las razas locales como un importante reservorio de resistencia genética natural a las enfermedades como un proceso de adaptabilidad al medio ambiente. Refiriéndose a las principales enfermedades de los animales domésticos (tuberculosis, brucelosis, fiebre aftosa, etc.), numerosos genes han sido identificados y estudiados como biomarcadores de resistencia y tolerancia como los genes BOLA, CD, NOD y SLC11A1 entre los más importantes. Aunque el factor limitante para que los programas de reproducción incluyan resistencia a enfermedades genéticas es la necesidad de cuantificar los fenotipos de resistencia. Esto puede ser costoso y logísticamente difícil, y es una barrera significativa para la selección de la resistencia a las enfermedades. Por esta razón, las características de resistencia a la enfermedad son un objetivo atractivo para los estudios genómicos y generalmente son objeto de estos estudios.
RESUMO Estimamos a biomassa para diferentes compartimentos acima do solo de uma floresta estacional decidual em Niquelândia, Goiás, Brasil, e determinamos fatores de expansão para necromassa, serapilheira, camada herbácea, arvoretas e vegetação rasteira. A amostra arbórea compreendeu 20 parcelas (10 x 10 m) de árvores com diâmetro à altura do peito (DAP) ≥ 5 cm, distribuídas em quatro transectos (cinco parcelas por transecto). As parcelas foram alocadas a cada 50 m ao longo dos transectos. Para cada parcela, foram amostrados os seguintes compartimentos em cinco subparcelas (1 m²): arvoretas (DAP < 5 cm e altura (h) ≥ 1,5 m), vegetação rasteira (árvores, arbustos e herbáceas com h <1,5 m), necromassa e serapilheira. A amostra da camada herbácea consistiu de uma subparcela (0,4 x 0,6 m) por parcela. A biomassa das árvores foi estimada com a equação: ln (AGB) =-10,4398 + 2,1183 * ln (DAP) + 0,8339 * ln (h), onde AGB = biomassa seca acima do solo (Mg), DAP = diâmetro a 1,30 m de altura (cm), e h= altura (m). O peso fresco dos demais compartimentos foi determinado em campo e, para cada subparcela, uma amostra 500 g foi levada ao laboratório para determinação do peso seco. A biomassa aérea acima do solo foi de 100,67 Mg ha-1 (±30,97 Mg ha-1), a necromassa foi de 1,0472 Mg ha-1 (±0,3403 Mg ha-1), a biomassa de serapilheira foi de 2,798 Mg ha-1 (±0,2932 ha-1), a biomassa da camada herbácea foi de 0,2398 Mg ha-1 (± 0,1789 Mg ha-1), a biomassa das arvoretas foi de 0,8184 Mg ha-1 (± 0,3257 Mg ha-1) e a biomassa vegetação rasteira foi de 0,2583 Mg ha-1 (± 0,0941 Mg ha-1). Os fatores de expansão, em relação à biomassa árborea acima do solo, para necromassa, serapilheira, camada herbácea, arvoretas e vegetação rasteira foram de 0
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.