The present paper describes the principle and characteristics of a biosensor for lactose based on a third-generation design involving cellobiose dehydrogenase. As resulted from a previous comparative study (submitted manuscript), the novelty of this lactose biosensor is based on highly efficient direct electron transfer between two newly discovered cellobiose dehydrogenases (CDH), from the white rot fungi Trametes villosa and Phanerochaete sordida, and a solid spectrographic graphite electrode. CDH was immobilized on the electrode surface (0.073 cm2) by simple physical adsorption, and the CDH-modified electrode was next inserted into a wall-jet amperometric cell connected on-line to a flow injection setup (0.5 mL x min(-1)). The P. sordida CDH-based lactose biosensor, proved to be the better one, has a detection limit for lactose of 1 microM, a sensitivity of 1100 microA x mM(-1) x cm(-2), a response time of 4 s (the time required to obtain the maximum peak current), and a linear range from 1 to 100 microM lactose (correlation coefficient 0.998). The simplicity of construction and analytical characteristics make this CDH-based lactose biosensor an excellent alternative to previous lactose biosensors reported in the literature or commercially available. The CDH-lactose sensor was used to quantify the content of lactose in pasteurized milk, buttermilk, and low-lactose milk, using the standard addition method. No effects of the samples matrixes were observed. The operational stability of the sensor was tested for 11 h by continuous injection of 100 microM lactose (290 injections). The final signal of the sensor was maintained at 98% of its initial signal, with a low standard deviation of 1.72 (RSD 2.41%).

The electrochemistry of the ligninolytic redox enzymes, which include lignin peroxidase, manganese peroxidase and laccase and possibly also cellobiose dehydrogenase, is reviewed and discussed in conjunction with their basic biochemical characteristics. It is shown that long-range electron transfer between these enzymes and electrodes can be established and their ability to degrade lignin through a direct electron transfer mechanism is discussed.

No abstract

A cellobiose dehydrogenase (CDH)-modified graphite electrode was designed for amperometric detection of catecholamines in the flow injection mode, by their recycling between the graphite electrode (+300 mV vs Ag|AgCl) and the reduced FAD cofactor of adsorbed CDH, resulting in an amplified response signal. The high efficiency of the enzyme-catecholamine reaction leads to a detection limit below 1 nM and a sensitivity of 15.8 A.M(-1) x cm(-2) (approximately 1150 nA/microM) for noradrenaline, with a coverage of less than 2.5 microg of CDH adsorbed on the electrode surface (0.073 cm(2)). Working parameters such as pH, cellobiose concentration, carrier buffer, and applied potential were optimized, using hydroquinone as a model analyte. The sensitivity, linear range, and amplification factor can be modulated by the steady-state concentration of cellobiose in the flow buffer. The response of the sensor decreases only 2% when run continuously for 4 h in the flow injection mode. The response peak maximum is obtained within 6 s at a flow rate of 0.5 mL/min, representing the time of the entire sample segment to pass the electrode. CDH enzymes from Phanerochaete chrysosporium and Sclerotium rolfsii were investigated, providing different characteristics of the sensor, with sensors made with CDH from P. chrysosporium being the better ones.

A membrane‐free biofuel cell (BFC) is reported based on enzymes wired to graphite electrodes by means of Os‐complex modified redox polymers. For the anode cellobiose dehydrogenase (CDH) is used as a biocatalyst whereas for the cathode a laccase was applied. This laccase is a high‐potential laccase and hence able to reduce O2 to H2O at a formal potential higher than +500 mV versus Ag/AgCl. In order to establish efficient electrochemical contact between the enzymes and graphite electrodes electrodeposition polymers containing Os‐complex with specifically designed monomer compositions and formal potentials of the coordinatively bound Os‐complex were synthesised and used to wire the enzymes to the electrodes. The newly designed CDH/Os‐redox polymer anode was characterised at different pH values and optimised with respect to the nature of the polymer and the enzyme‐to‐polymer ratio. The resulting BFC was evaluated running on β‐lactose as a fuel and air/O2 as an oxidising agent. The power output, the maximum current density and the electromotor force (Eemf) were found to be affected by the pH value, resulting in a maximum power output of 1.9 μW cm–2 reached at pH 4.3, a maximum current density of about 13 μA cm–2 at pH 3.5, and the highest Eemf approaching 600 mV at pH 4.0.

This paper presents some functional differences as well as similarities observed when comparing the newly discovered cellobiose dehydrogenase (CDH) from Trametes villosa (T.v.) with the well-characterized one from Phanerochaete chrysosporium (P.c.). The enzymes were physically adsorbed on spectrographic graphite electrodes placed in an amperometric flow through cell connected to a flow system. In the case of T.v.-CDH-modified graphite electrodes, a high direct electron transfer (DET) current was registered at the polarized electrode in the presence of the enzyme substrate reflecting a very efficient internal electron transfer (IET) process between the reduced FAD-cofactor and the oxidized heme-cofactor. In the case of P.c.-CDH-modified graphite electrodes, the DET process is not as efficient, and the current will greatly increase in the presence of a mediator (mediated electron transfer, MET). As a consequence, when comparing the two types of enzyme-modified electrodes an inverted DET/MET ratio for T.v.-CDH is shown, in comparison with P.c.-CDH. The rates of the catalytic reaction were estimated to be comparable for both enzymes, by measuring the combined DET + MET currents. The inverted DET/MET ratio for T.v.-CDH-modified electrodes might suggest that probably there is a better docking between the two domains of this enzyme and that the linker region of P.c.-CDH might have an active role in modulating the rate of the IET (by changing the interdomain distance), with respect to pH. Based on the new properties of T.v.-CDH emphasized in the present study, an analytical application of a third-generation biosensor for lactose was recently published.

No abstract

No abstract