We investigated the impact of photon irradiation on the stability of gallium-indium-zinc oxide (GIZO) thin film transistors. The application of light on the negative bias temperature stress (NBTS) accelerated the negative displacement of the threshold voltage (Vth). This phenomenon can be attributed to the trapping of the photon-induced carriers into the gate dielectric/channel interface or the gate dielectric bulk. Interestingly, the negative Vth shift under photon-enhanced NBTS condition worsened in relatively humid environments. It is suggested that moisture is a significant parameter that induces the degradation of bias-stressed GIZO transistors.

Ultra-definition, large-area displays with three-dimensional visual effects represent megatrend in the current/future display industry. On the hardware level, such a “dream” display requires faster pixel switching and higher driving current, which in turn necessitate thin-film transistors (TFTs) with high mobility. Amorphous oxide semiconductors (AOS) such as In-Ga-Zn-O are poised to enable such TFTs, but the trade-off between device performance and stability under illumination critically limits their usability, which is related to the hampered electron-hole recombination caused by the oxygen vacancies. Here we have improved the illumination stability by substituting oxygen with nitrogen in ZnO, which may deactivate oxygen vacancies by raising valence bands above the defect levels. Indeed, the stability under illumination and electrical bias is superior to that of previous AOS-based TFTs. By achieving both mobility and stability, it is highly expected that the present ZnON TFTs will be extensively deployed in next-generation flat-panel displays.

No abstract

The world's largest (15‐inch) XGA active matrix liquid crystal display (AMLCD) panel made with IGZO TFTs (W/L=29.5/4 μm) was fabricated and evaluated with the field effective mobility of 4.2±0.4 cm2/V‐s, Vth of −1.3±1.4V and sub‐threshold swing (SS) of 0.96±0.10 V/dec. for a manufacturing‐oriented process, the main factors affecting threshold voltage (Vth) of the IGZO thin film transistors (TFT) are investigated. On the glass surface, thicker regions of IGZO film have a negative threshold voltage shift. A dry etching process of molybdenum source and drain (S/D) causes negative shift of the average threshold voltage compared to wet etching in the bottom gate back channel etched TFTs. However, optimization of SiOx passivation and subsequent annealing shift average Vth positively and reduce Vth variation.

Interest in oxide semiconductors stems from benefits, primarily their ease of process, relatively high mobility (0.3–10 cm2/vs), and wide-bandgap. However, for practical future electronic devices, the channel mobility should be further increased over 50 cm2/vs and wide-bandgap is not suitable for photo/image sensor applications. The incorporation of nitrogen into ZnO semiconductor can be tailored to increase channel mobility, enhance the optical absorption for whole visible light and form uniform micro-structure, satisfying the desirable attributes essential for high performance transistor and visible light photo-sensors on large area platform. Here, we present electronic, optical and microstructural properties of ZnON, a composite of Zn3N2 and ZnO. Well-optimized ZnON material presents high mobility exceeding 100 cm2V−1s−1, the band-gap of 1.3 eV and nanocrystalline structure with multiphase. We found that mobility, microstructure, electronic structure, band-gap and trap properties of ZnON are varied with nitrogen concentration in ZnO. Accordingly, the performance of ZnON-based device can be adjustable to meet the requisite of both switch device and image-sensor potentials. These results demonstrate how device and material attributes of ZnON can be optimized for new device strategies in display technology and we expect the ZnON will be applicable to a wide range of imaging/display devices.

This study examined the effect of gate dielectric materials on the light-induced bias instability of Hf-In-Zn-O ͑HIZO͒ transistor. The HfO x and SiN x gated devices suffered from a huge negative threshold voltage ͑V th ͒ shift ͑Ͼ11 V͒ during the application of negative-bias-thermal illumination stress for 3 h. In contrast, the HIZO transistor exhibited much better stability ͑Ͻ2.0 V͒ in terms of V th movement under identical stress conditions. Based on the experimental results, we propose a plausible degradation model for the trapping of the photocreated hole carrier either at the channel/ gate dielectric or dielectric bulk layer.

A novel method to design metal oxide thin-film transistor (TFT) devices with high performance and high photostability for next-generation flat-panel displays is reported. Here, we developed bilayer metal oxide TFTs, where the front channel consists of indium-zinc-oxide (IZO) and the back channel material on top of it is hafnium-indium-zinc-oxide (HIZO). Density-of-states (DOS)-based modeling and device simulation were performed in order to determine the optimum thickness ratio within the IZO/HIZO stack that results in the best balance between device performance and stability. As a result, respective values of 5 and 40 nm for the IZO and HIZO layers were determined. The TFT devices that were fabricated accordingly exhibited mobility values up to 48 cm(2)/(V s), which is much elevated compared to pure HIZO TFTs (∼13 cm(2)/(V s)) but comparable to pure IZO TFTs (∼59 cm(2)/(V s)). Also, the stability of the bilayer device (-1.18 V) was significantly enhanced compared to the pure IZO device (-9.08 V). Our methodology based on the subgap DOS model and simulation provides an effective way to enhance the device stability while retaining a relatively high mobility, which makes the corresponding devices suitable for ultradefinition, large-area, and high-frame-rate display applications.

No abstract