With the ability to engineer ferroelectricity in HfO2 thin films, manufacturable and highly scaled MFM capacitors and MFIS-FETs can be implemented into a CMOS-environment. NVM properties of the resulting devices are discussed and contrasted to existing perovskite based FRAM

No abstract

No abstract

No abstract

The discovery of ferroelectricity in thin doped hafnium oxide films revived the interest in ferroelectric (FE) memory concepts. Zirconium‐doped hafnium oxide (HZO) crystallizes at low temperatures (e.g., 400 °C), which makes this material interesting for the implementation of FE functionalities into the back end of line (BEoL). So far, the FE phase of prior amorphous HZO films is achieved by using a dedicated rapit thermal annealing (RTA) treatment. However, herein, it is shown that this dedicated anneal is not needed. A sole furnace treatment given by the thermal budget present during the interconnect formation is sufficient to functionalize even ultrathin 5 nm HZO films. This result helps to optimize the integration sequence of HZO films (e.g., involving a minimum number of BEoL process steps), which saves process time and fabrication costs. Herein, metal–FE–metal capacitors with Hf0.5Zr0.5O2 films of different thicknesses (5–20 nm) are fabricated annealed at 400 °C for various durations within different types of ovens (RTA and furnace). Structural and electrical characterization confirms that all furnace‐annealed samples have similar X‐ray diffraction patterns, remanent polarization, endurances, and thickness dependencies as RTA‐annealed ones. With respect to remanent polarization, leakage current, and endurance, the HZO film of 10 nm thickness shows the most promising results for the integration into the BEoL.

Research data are not shared.

The local crystal phase and orientation of ferroelectric grains inside TiN/Hf0.5Zr0.5O2/TiN have been studied by the analysis of the local electron beam scattering Kikuchi patterns, recorded in transmission. Evidence was found that the ferroelectric phase of the layers is derived from an orthorhombic phase, most likely of space group Pca21. The orientation analysis reveals a strong out-of-plane texture of the polycrystalline film which is in accordance with a high remanent polarization Pr observed for P-V measurements. The results of this analysis help us to further optimize the ratio of ferroelectric grains and their orientation for many applications, e.g., in the field of emerging memory or infrared sensors.

The recent discovery of ferroelectricity in thin film HfO2 materials renewed the interest in ferroelectric FET (FeFET) as an emerging nonvolatile memory providing a potential high speed and low power Flash alternative. Here, we report more insight into FeFET performance by integrating two types of ferroelectric (FE) materials and varying their properties. By varying the material type [HfO2 (HSO) versus hafnium zirconium oxide (HZO)], optimum content (Si doping/mixture ratio), and film thickness, a material relation to FeFET device physics is concluded. As for the material type, an improved FeFET performance is observed for HZO integration with memory window (MW) comparable to theoretical values. For different Si contents, the HSO based FeFET exhibited a MW trend with different stabilized phases. Similarly, the HZO FeFET shows MW dependence on the Hf:Zr mixture ratio. A maximized MW is obtained with cycle ratios of 16:1 (HfO2:Si) and 1:1 (Hf:Zr) as measured on HSO and HZO based FeFETs, respectively. The thickness variation shows a trend of increasing MW with the increased FE layer thickness confirming early theoretical predictions. The FeFET material aspects and stack physics are discussed with insight into the interplay factors, while optimum FE material parameters are outlined in relation to performance.