A commercially available 4.6 mm id x 50 mm polymethacrylate-based monolithic strong anion exchange column (ProSwift SAX-1S) designed for the separation of proteins has been successfully used to separate small inorganic anions in the presence of a seawater sample matrix. Using a hydroxide eluent with suppressed conductivity detection the ion exchange capacity of this column declined over time; however, using KCl as the eluent, the column performance was stable with a capacity of 530 microequiv. for nitrate. The optimum conditions for the separation of iodate, bromate, nitrite, bromide and nitrate were assessed by constructing van Deemter plots using 1.00 and 0.100 M KCl. Efficiencies of up to 26 700 plates/m were recorded using 1.00 M KCl, at a flow rate of 0.20 mL/min but iodate was not baseline resolved from the void peak. By reducing the concentration of the eluent to 0.100 M, efficiencies of up to 39 900 plates/m could be obtained at 0.35 mL/min. By employing a linear gradient ranging from 0.05 to 1.00 M KCl the ions dissolved in distilled water or a salt water matrix could be baseline separated in less than 3 min at a flow rate of 2.50 mL/min.
Many different techniques have been developed to prepare monolithic materials specifically for chromatographic techniques. The two most popular polymerization techniques being thermal or via ultra violet (UV) light. Whereas thermal polymerization is easily employed for a whole variety of monomer and porogen systems, UV polymerization has been limited to methacrylate-based systems, and styrenic systems have been avoided due to their strong absorbance at low wavelengths. By careful consideration of wavelength, initiator and other system components, it was proven that reversed-phase columns for the separation of proteins and peptides can be prepared using divinylbenzene through UV initiation of 2-methyl-4'-(methylthio)-2-morpholinopropiophenone at a wavelength of 350 nm.
Polymerisation of bicontinuous microemulsions yields porous monolithic structures with well defined pore sizes that are potentially suitable for use as stationary phases for capillary electrochromatography (CEC). Avariety of pore sizes can be achieved by altering the composition of the microemulsion, which typically consists of butyl methacrylate (BMA) and ethylene glycol dimethacrylate (EGDMA) as the polymerisable oil phase. The aqueous phase consists of water, a surfactant (sodium dodecyl sulphate, SDS) and a co-surfactant (1-propanol). 2-acrylamido-2-methyl-l-propane sulfonic acid (AMPS) is also added to provide charges along the polymer backbone to allow electroosmotic flow (EOF) to occur. SEM analysis shows that in-situ polymerisation yields a monolithic structure with a porous topography. Investigations have shown that these monoliths are easy to prepare, robust and suitable for the separation of phthalates. They generate higher linear velocities than are achieved using the silica based HPLC packings normally used for CEC.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.