The aim of this study was to evaluate concentration-dependent antioxidant and anticancer activities of CA and RA in ethanol extracts of three different Oregano species (Origanum onites L., Origanum vulgare L., and Origanum vulgare ssp. hirtum). The study revealed the highest RA antioxidant activity in O. vulgare ssp. hirtum (9550 ± 95 mmol/g) and the lowest in O. vulgare L. (2605 ± 52 mmol/g) (p < 0.05). The highest CA amount was present in O. onites L., which was 1.8 and 4.7 times higher (p < 0.05) than in O. vulgare ssp. hirtum and O. vulgare L., respectively. The anticancer activity was evaluated on human glioblastoma (U87) and triple-negative breast cancer (MDA-MB231) cell lines in vitro. RA anticancer activity was negligible. CA and the extracts were about 1.5–2 times more active against MDA-MB231 cell line (p < 0.05) compared to U87 cell line. The anticancer activities of three tested extracts were similar against U87 cell line (p > 0.05) but they had different activities against MDA-MB231 cell line.

The aim of our study was to increase the extraction efficiency of carvacrol, rosmarinic, oleanolic and ursolic acid from the different species of oregano herbs (Origanum onites L., Origanum vulgare spp. hirtum and Origanum vulgare L.). Various extraction methods (ultrasound-assisted, heat-reflux, continuous stirring, maceration, percolation) and extraction conditions (different solvent, material:solvent ratio, extraction temperature, extraction time) were used, and the active substances were determined by HPLC. The lowest content of carvacrol, rosmarinic, oleanolic and ursolic acid was obtained by percolation. During heat-reflux extraction, the content of active substances depended on the solvent used: ethanol/non-aqueous solvent (glycerol or propylene glycol) mixture was more effective compared with ethanol alone. The results showed that for each species of oregano the most optimal extraction method should be selected to maximize the content of biologically active substances in the extracts.

Aluminum accumulation, glutathione (GSH) and malondialdehyde (MDA) concentrations as well as catalase (CAT) and superoxide dismutase (SOD) activities were determined in erythrocytes and brain and liver homogenates of BALB/c mice treated with Al 3+ (7.5 mg/kg/day (0.15 LD 50 ) as AlCl 3 (37.08 mg/kg/day), whereas HCl (30.41 mg/kg/day) was used as Cl − control, the treatments were performed for 21 days, i.p., in the presence and absence of rosmarinic acid (0.2805 mg/kg/day (0.05 LD 50 ), 21 days, i.g.) or carvacrol (0.0405 mg/kg/day (0.05 LD 50 ), 21 days, i.g.). The treatment with AlCl 3 increased GSH concentration in erythrocytes only slightly and had no effect on brain and liver homogenates. Rosmarinic acid and carvacrol strongly increased GSH concentration in erythrocytes but decreased it in brain and liver homogenates. However, AlCl 3 treatment led to Al accumulation in mice blood, brain, and liver and induced oxidative stress, assessed based on MDA concentration in the brain and liver. Both rosmarinic acid and carvacrol were able to counteract the negative Al effect by decreasing its accumulation and protecting tissues from lipid peroxidation. AlCl 3 treatment increased CAT activity in mice brain and liver homogenates, whereas the administration of either rosmarinic acid or carvacrol alone or in combination with AlCl 3 had no significant effect on CAT activity. SOD activity remained unchanged after all the treatments in our study. We propose that natural herbal phenolic compounds rosmarinic acid and carvacrol could be used to protect brain and liver against aluminum induced oxidative stress leading to lipid peroxidation.

The aim of this study was optimization of spray-drying process conditions for microencapsulation of Turkish oregano extract. Different concentrations of maltodextrin and gum arabic as encapsulating agents (wall material) as well as influence of selected processing variables were evaluated. The optimal conditions were maintained on the basis of the load of main bioactive compounds - ursolic, rosmarinic acids and carvacrol - in prepared microparticles after comparison of all significant response variables using desirability function. Physicomechanical properties of powders such as flowability, wettability, solubility, moisture content as well as product yield, encapsulation efficiency (EE), density, morphology and size distribution of prepared microparticles have been determined. The results demonstrated that the optimal conditions for spray-drying mixture consisted of two parts of wall material solution and one part of ethanolic oregano extract when the feed flow rate was 40 mL/min and air inlet temperature -170 °C. Optimal concentration of wall materials in solution was 20% while the ratio of maltodextrin and gum arabic was 8.74:1.26.

The potential antimicrobial benefit of high levels of rosmarinic acid (RA) and carvacrol (CA) in oregano (O. onites L.) extract has been limited until now by poor bioavailability arising from the low aqueous-phase solubility and slow dissolution behaviour of the lyophilized extract (E). To address this issue, various ratios of phospholipon 90H (P90H) and 1,2-dimyristoyl-sn-glycero-3-phospho-(1'-rac-glycerol), sodium salt (DMPG) were sonicated, yielding four empty liposomes (L1, L2, L3, and L90). After an initial selection process, Turkish oregano extract was internalized into the more promising candidates. Each empty liposome, extract-loaded liposome (LE1, LE2, and LE3), and freeze-dried control (E) was assessed in terms of structure, composition, RA and CA dissolution profile, storage stability, and, when relevant, zeta potential. Empty liposome L1, which was prepared using P90H and DMPG in a 1:1 ratio, displayed the most convenient encapsulation traits among the four unloaded types. Loaded liposome LE1, obtained by combining oregano extract and L1 in a 1:1 ratio, proved superior as a vehicle to deliver RA & CA when compared against control freeze-dried E and test liposomes LE2 and LE3. Dissolution profiles of the active compounds RA and CA in loaded liposomes were determined using a semi-automated dissolution tester. The basket method was applied using artificial gastric juice without pepsin (AGJ, 50rpm, 500mL). The pH value was maintained at 1.5 (37 ± 0.5°C). Aliquots (5ml) were manually extracted from parallel dissolution vessels at 1, 3, 5, 7, 10, 15, 20, 25, 30, 45, and 60-minute time points. Dissolution tests, run to completion on LE1, showed that approximately 99% of loaded CA and 88% of RA had been released. Shorter dissolution times were also noted in using LE1. In particular, the release profile of CA and RA had levelled off after only 25 minutes, respectively, depicting an impressive 3.0–3.3 and 2.3-2.6 rate increase compared to the freeze-dried control extract. The improved dispersibility of RA and CA in the form of LE1 was supported by particle size and zeta potential measurements of the liposome, yielding 234.3nm and −30.9mV, respectively. The polydispersity index value was 0.35, indicating a reasonable particle size distribution. To study storage stability, liposomes were stored (4°C, 6 months) in amber coloured glass containers (4 oz.). Each container held 30 capsules, which were stored according to the ICH guidelines prescribed for long-term storage (25°C ± 2°C; 60% ± 5% RH). Triplicate samples were withdrawn after 0, 3, 6, 9, and 12 months for analysis. Lastly, LE1 displayed good storage stability. The results imply that RA and CA can be conveniently and routinely delivered via oral and mucosal routes by first internalizing oregano extracts into appropriately engineered liposomes.

Microencapsulation protects core materials from deteriorating due to environmental conditions, such as moisture or oxidation, and improves the bioavailability of active compounds, allowing one to make solid formulations from oils and increase their solubility. Wall and core material properties determine the microencapsulation efficiency and the best results are achieved when a wall material mixture is used to prepare the microcapsules. In this work, we optimized the wall material composition (gelatin supplemented with gum Arabic, Tween 20, and β-cyclodextrin) of Turkish oregano microcapsules prepared by spray-drying technology to increase the product yield, the encapsulation efficiency, and to achieve narrower particle size distribution. When the wall material solution contained 10 g of gelatin, 7.5 g of gum Arabic, 1.99 g of Tween 20, 1.98 g of β-cyclodextrin, and 20 g of ethanolic oregano extract, the encapsulation efficiency of oregano’s active compounds, rosmarinic acid and carvacrol, were 96.7% and 99.8%, respectively, and the product yield was 85.63%. The physicochemical properties, microscopic morphology, and in vitro release of the prepared microcapsules were characterized in the study. The use of gelatin as the main coating material, in supplementation with gum Arabic, Tween 20, and β-cyclodextrin, not only improved the encapsulation efficiency, but also increased the in vitro release of both main active compounds of Turkish oregano extract—rosmarinic acid and carvacrol.

Introduction Nowadays, the interest in industrial Cannabis sativa L. herb has been increasing in the world. As a result, it is becoming one of the most studied plants due to its multifunctional benefits. Objectives To the best of our knowledge, no study has been conducted so far to determine the impact of extraction methods and conditions on the extraction yields of CBD and CBG from the Cannabis sativa L. ssp. Santhica. Therefore, we aimed to investigate a simple and sensitive GC‐FID method to determine CBD and CBG in hemp extract. Methods As regards sample preparation, three extraction techniques were compared, including maceration (ME), ultrasound‐assisted extraction (UAE) and reflux‐heat extraction (RHE), in order to obtain a high recovery of the CBD of interest from the plant material. The GC‐FID method developed in this study represents a powerful tool for the extraction and analysis of non‐psychoactive cannabinoids from hemp varieties to be used for the preparations of extracts with a high content of bioactive compounds for both pharmaceutical and nutraceutical applications. Results A simple extraction procedure for CBD and CBG from hemp was also optimized in this work, by using ultrasound assisted extraction method with 96% ethanol, material/solvent ratio 1:10 and extraction time 10 min at room temperature. Conclusion The overall analytical method was fully validated in agreement with international guidelines. Therefore, proving a powerful and reliable tool for both the selection of hemp varieties with a high content of bioactive compounds and the quality control of its derivatives.

To the best of our knowledge, so far, no study has been conducted about the comparison of the total fatty acid concentration in the four bee products (honey, bee pollen, bee bread, and propolis) collected from Lithuania. Therefore, we aimed to optimize the derivatization parameters and to investigate a simple and sensitive gas chromatography-flame ionization detection (GC-FID) method to determine fatty acids. The optimal derivatization parameters were used to analyze fatty acids in the bee products. Regarding sample preparation, three derivatization parameters were compared (temperature and extraction time with BF3/MeOH reagent) in order to obtain a high amount of the total fatty acids of interest from the fatty acid methyl ester (FAME) standard. The results showed that the highest total yield of fatty acids was conducted by using the conventional heating process at 70 °C for 90 min. Under optimal conditions, there was obtained excellent linearity for fatty acids with determination coefficients of r2 > 0.9998. The LODs and LOQs ranged from 0.21 to 0.54 µg/mL and 0.63 to 1.63 µg/mL, respectively. This method has been successfully applied to the qualitative analysis of fatty acids in bee products. The above findings might provide a scientific basis for evaluating the nutritional values of bee products.