A large anomalous Hall effect is observed in the triangular antiferromagnet Mn3Ge arising from an intrinsic electronic Berry phase.

The specific heat C of e-beam evaporated amorphous silicon (a-Si) thin films prepared at various growth temperatures T(S) and thicknesses t was measured from 2 to 300 K, along with sound velocity v, shear modulus G, density n(Si), and Raman spectra. Increasing T(S) results in a more ordered amorphous network with increases in n(Si), v, G, and a decrease in bond angle disorder. Below 20 K, an excess C is seen in films with less than full density where it is typical of an amorphous solid, with both a linear term characteristic of two-level systems (TLS) and an additional (non-Debye) T3 contribution. The excess C is found to be independent of the elastic properties but to depend strongly on density. The density dependence suggests that low energy glassy excitations can form in a-Si but only in microvoids or low density regions and are not intrinsic to the amorphous silicon network. A correlation is found between the density of TLS n0 and the excess T3 specific heat c(ex) suggesting that they have a common origin.

The ubiquitous low-energy excitations, known as two-level tunneling systems (TLSs), are one of the universal phenomena of amorphous solids. Low temperature elastic measurements show that e-beam amorphous silicon (a-Si) contains a variable density of TLSs which diminishes as the growth temperature reaches 400 °C. Structural analyses show that these a-Si films become denser and more structurally ordered. We conclude that the enhanced surface energetics at a high growth temperature improved the amorphous structural network of e-beam a-Si and removed TLSs. This work obviates the role hydrogen was previously thought to play in removing TLSs in the hydrogenated form of a-Si and suggests it is possible to prepare "perfect" amorphous solids with "crystal-like" properties for applications.

In e-beam evaporated amorphous silicon (a-Si), the densities of two-level systems (TLS), n 0 and P, determined from specific heat C and internal friction Q −1 measurements, respectively, have been shown to vary by over three orders of magnitude. Here we show that n 0 and P are proportional to each other with a constant of proportionality that is consistent with the measurement time dependence proposed by Black and Halperin and does not require the introduction of additional anomalous TLS. However, n 0 and P depend strongly on the atomic density of the film (n Si ) which depends on both film thickness and growth temperature suggesting that the a-Si structure is heterogeneous with nanovoids or other lower density regions forming in a dense amorphous network. A review of literature data shows that this atomic density dependence is not unique to a-Si. These findings suggest that TLS are not intrinsic to an amorphous network but require a heterogeneous structure to form.

Recently non-collinear magnetic structures have attracted renewed attention due to the novel Hall effects that they display. In earlier work evidence for a non-collinear magnetic structure has been reported for the ferromagnetic Heusler compound Mn 2 RhSn. Using sputtering techniques we have prepared high quality epitaxial thin films of Mn 2 RhSn by high temperature growth on MgO (001) substrates. The films are tetragonally distorted with an easy magnetization axis along the c-axis. Moreover, we find evidence for an anomalous Hall effect whose magnitude increases strongly below the Curie temperature that is near room temperature. Consistent with theoretical calculations of the anomalous Hall conductivity that we have carried out by deriving the Berry curvature from the electronic structure of perfectly ordered Mn 2 RhSn, the sign of the anomalous Hall conductivity is negative, although the measured value is considerably smaller than the calculated value. We attribute this difference to small deviations in stoichiometry and chemical ordering. We also find evidence for a topological Hall resistivity of about 50 nΩ cm, which is ∼5% of the anomalous Hall effect, for temperatures below 100 K. The topological Hall effect signifies the presence of a chiral magnetic structure that evolves from the non-collinear magnetic structure that Mn 2 RhSn is known to exhibit.

Inducing long‐range magnetic order in 3D topological insulators can gap the Dirac‐like metallic surface states, leading to exotic new phases such as the quantum anomalous Hall effect or the axion insulator state. These magnetic topological phases can host robust, dissipationless charge and spin currents or unique magnetoelectric behavior, which can be exploited in low‐energy electronics and spintronics applications. Although several different strategies have been successfully implemented to realize these states, to date these phenomena have been confined to temperatures below a few Kelvin. This review focuses on one strategy: inducing magnetic order in topological insulators by proximity of magnetic materials, which has the capability for room temperature operation, unlocking the potential of magnetic topological phases for applications. The unique advantages of this strategy, the important physical mechanisms facilitating magnetic proximity effect, and the recent progress to achieve, understand, and harness proximity‐coupled magnetic order in topological insulators are discussed. Some emerging new phenomena and applications enabled by proximity coupling of magnetism and topological materials, such as skyrmions and the topological Hall effect, are also highlighted, and the authors conclude with an outlook on remaining challenges and opportunities in the field.

No abstract

Off-stoichiometry, epitaxial Fe x Si 1-x thin films (0.5