No abstract

The application of a self-assembling peptide on noncavitated caries lesions is supposed to be a feasible approach to facilitate remineralization and mask their unfavorable appearance. However, demineralizing conditions are common in the oral environment, so the aim of this pH-cycling study was to compare recommended and novel treatment methods regarding their ability to hamper demineralization and as a consequence mask artificial enamel caries lesions. Artificial caries lesions were prepared in bovine enamel and randomly allocated to 11 groups (n = 22). Treatments before pH-cycling were as follows: the application of a self-assembling peptide (Curodont™ Repair [C]), a low-viscosity resin (Icon® [I]), 2 fluoride solutions (10,000 ppm F^-: Elmex fluid [E] and 43,350 ppm F^-: Tiefenfluorid® [T]), and no intervention (N). During pH-cycling (28 days, 6 × 60 min demineralization/day) half of the specimens in each group were brushed (10 s; 2 ×/day) with either fluoride-free (named e.g., C₀) or NaF (1,100 ppm F^-; e.g., C₁) dentifrice slurry. In another subgroup specimens were pH-cycled but not brushed (N_NB). Differences in integrated mineral loss (ΔΔZ), lesion depth (ΔLD), and colorimetric values (ΔΔE) were calculated between values after pre-demineralization, surface treatment, and pH-cycling. Specimens of C₀, C₁, N_NB, N₀, N₁, T₀, and E₀ showed significantly increased ΔZ and LD values after pH-cycling (p ≤ 0.003; paired t test). C₀, C₁, N_NB, and N₀ showed significantly higher changes in ΔΔZ than E₁, I₀, I₁, and T₁ (p < 0.001; ANOVA). Significantly reduced colorimetric values could only be observed for I₁, I₀, E₁, and E₀ after treatment and after pH-cycling (p ≤ 0.027; paired t test). In conclusion, under the conditions chosen only the application of a low-viscosity resin could mask caries lesions significantly, whereas self-assembling peptides could neither inhibit lesion progression nor mask the lesions considerably.

No abstract

The aim of this study was to compare the caries-preventive effect of different fluoride varnishes on sound dentin as well as on artificial dentin caries-like lesions. Bovine dentin specimens (n = 220) with one sound surface (ST) and one artificial caries lesion (DT) were prepared and randomly allocated to 11 groups. The interventions before pH cycling were as follows: application of a varnish containing NaF (22,600 ppm F^-; Duraphat [NaF₀/NaF₁]), NaF plus tricalcium phosphate (22,600 ppm F^-; Clinpro White Varnish Mint [TCP₀/TCP₁]), NaF plus casein phosphopeptide-stabilized amorphous calcium phosphate complexes (CPP-ACP; 22,600 ppm F^-; MI Varnish [CPP₀/CPP₁]), or silver diamine fluoride (SDF; 35,400 ppm F^-; Cariestop 30% [SDF₀/SDF₁]) and no intervention (N_NB/N₀/N₁). During pH cycling (14 days, 6 × 120 min demineralization/day) half of the specimens in each group were brushed (10 s; 2 times/day) with either fluoride-free (“0”; e.g., TCP₀) or 1,100 ppm F^- (“1”; e.g., TCP₁) dentifrice slurry. In another subgroup, the specimens were pH cycled but not brushed (N_NB). Differences in integrated mineral loss (ΔΔZ), lesion depth (ΔLD), and colorimetric values (ΔΔE) were calculated between the values after initial demineralization and those after pH cycling, using transversal microradiography and photographic images. After pH cycling, no discoloration could be observed. Furthermore, N_NB, N₀, and N₁ showed significantly increased ΔZ_DT/LD_DT and ΔZ_ST/LD_ST values, indicating further demineralization. In contrast, CPP₀, CPP₁, SDF₀, and SDF₁ showed significantly decreased ΔZ_DT/LD_DT values, indicating remineralization (p ≤ 0.004; paired t test). CPP₀, CPP₁, SDF₀, and SDF₁ showed significantly higher changes in ΔΔZ_DT/ΔLD_DT and ΔΔZ_ST/ΔLD_ST than N_NB, N₀, and N₁ (p < 0.001; Bonferroni post hoc test). In conclusion, under the conditions chosen, all fluoride varnishes prevented further demineralization. However, only NaF plus CPP-ACP and SDF could remineralize artificial dentin caries-like lesions under net-demineralizing conditions, thereby indicating that NaF plus CPP-ACP and SDF may be helpful to high-caries-risk patients.

The resin infiltration technique might be used for occlusal caries lesions in order to arrest their progression. This in vitro study evaluated the influence of various modifications of the infiltration technique on the penetration abilities of the infiltrant into occlusal lesions. Extracted human molars and premolars (n = 140) with non-cavitated white spot lesions were randomly allocated to 7 groups. As control, specimens were etched with 15% hydrochloric acid (HCl) gel for 120 s and resin infiltrated for 180 s (Icon; DMG). As modification HCl gel reduced in surface tension and viscosity with and without abrasives was applied using 3 different types of brushes either to oscillate or rub the HCl gel onto the enamel surface. The median maximum lesion depth was 1,232 µm (interquartile range 882-1,513). Compared with the control procedure [23% (16/50)] a higher percentage penetration was observed if the HCl gel was mixed with a small amount of abrasives were rubbed into the fissures using a modified brush with stiff bristles that were adjusted to the fissure relief for either 120 s [100% (64/100)] or 30 s [98% (61/100); p < 0.05; Mann-Whitney test]. All other experimental treatments resulted in penetration results in-between. It can be concluded that the use of an abrasive HCl gel in conjunction with a modified brush mostly enhances resin infiltration into fissure caries lesions. © 2014 S. Karger AG, Basel

Objectives: The aim of this double-blinded, randomized, cross-over in situ study was to evaluate the re- and demineralization characteristics of sound enamel as well as lowly and highly demineralized caries-like enamel lesions after the application of different fluoride compounds. Methods: In each of three experimental legs of 4 weeks, 21 participants wore intraoral mandibular appliances containing 4 bovine enamel specimens (2 lowly and 2 highly demineralized). Each specimen included one sound enamel and either one lowly demineralized (7 days, pH 4.95) or one highly demineralized (21 days, pH 4.95) lesion, and was positioned 1 mm below the acrylic under a plastic mesh. The three randomly allocated treatments (application only) included the following dentifrices: (1) 1,100 ppm F as NaF, (2) 1,100 ppm F as SnF₂ and (3) 0 ppm F (fluoride-free) as negative control. Differences in integrated mineral loss (ΔΔZ) and lesion depth (ΔLD) were calculated between values before and after the in situ period using transversal microradiography. Results: Of the 21 participants, 6 did not complete the study and 2 were excluded due to protocol violation. Irrespectively of the treatment, higher baseline mineral loss and lesion depth led to a less pronounced change in mineral loss and lesion depth. Except for ΔΔZ of the dentifrice with 0 ppm F, sound surfaces showed significantly higher ΔΔZ and ΔLD values compared with lowly and highly demineralized lesions (p < 0.05, t test). Conclusion: Re- and demineralization characteristics of enamel depended directly on baseline mineral loss and lesion depth. Treatment groups should therefore be well balanced with respect to baseline mineral loss and lesion depth.

No abstract

The incorporation of antibacterial agents into dental restorative materials is a promising strategy for secondary caries prevention. Previously, Carolacton affected Streptococcus mutans biofilm formation on composite materials in vitro. The present study evaluated secondary caries formation adjacent to Carolacton-containing composites and conventional restorative materials using an artificial biofilm model. Standardized cavities were prepared in bovine dentin-enamel samples (n = 175) and restored with various dental materials (Tetric EvoCeram [T], GrandioSo composite without [G] and with Carolacton [GC], Grandio Flow without [F] and with Carolacton [FC], GrandioSo containing sodium fluoride [GNaF], and Ketac Fil [K]). After artificial aging, S. mutans was grown on the samples for 7 days. The investigation of gap sizes and secondary caries formation was performed using confocal laser scanning microscopy and transversal microradiography. Median gap size in enamel was 9.4 µm (interquartile range 7.9–12.7). Compared to all other groups significant differences in gap sizes could be observed for Ketac Fil (p < 0.001; Mann-Whitney test). Only GrandioSo composite containing 30% sodium fluoride and Ketac Fil showed significantly smaller lesion areas in enamel (p < 0.001; Mann-Whitney test) than all other groups which was confirmed by the mineral loss data (p < 0.001; Mann-Whitney test). Based on the present in vitro results, it seems that Carolacton-containing composite in the current formulation within the shown simplified monoculture biofilm model is not able to prevent caries formation compared to fluoride-releasing restorative materials.